Next Article in Journal
Karman Vortex Creation Using Cylinder for Flutter Energy Harvester Device
Previous Article in Journal
Squeeze Film Air Damping in Tapping Mode Atomic Force Microscopy
Previous Article in Special Issue
Ink-Jet Printing of Micro-Electro-Mechanical Systems (MEMS)
Open AccessEditorial

3D Printing and Bioprinting in MEMS Technology

Singapore Centre for 3D Printing, School of Mechanical and Aerospace Engineering, Nanyang Technological University, 50 Nanyang Avenue, Singapore 639798, Singapore
*
Author to whom correspondence should be addressed.
Micromachines 2017, 8(7), 229; https://doi.org/10.3390/mi8070229
Received: 19 July 2017 / Revised: 20 July 2017 / Accepted: 20 July 2017 / Published: 21 July 2017
(This article belongs to the Special Issue Bioprinting and 3D Printing in MEMS Technology)
3D printing and bioprinting have advanced significantly in printing resolution in recent years, which presents a great potential for fabricating small and complex features suitable for microelectromechanical systems (MEMS) with new functionalities. This special issue aims to give a glimpse into the future of this research field. View Full-Text
Keywords: MEMS; 3D printing; bioprinting; additive manufacturing; rapid prototyping MEMS; 3D printing; bioprinting; additive manufacturing; rapid prototyping
MDPI and ACS Style

Chua, C.K.; Yeong, W.Y.; An, J. 3D Printing and Bioprinting in MEMS Technology. Micromachines 2017, 8, 229.

Show more citation formats Show less citations formats
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Article Access Map by Country/Region

1
Back to TopTop