Search Results (9)

The increasing demand for plant-based foods has led to significant growth in the availability, at a retail level, of plant-based cheese analogue products. This study presents the first comprehensive benchmarking of commercially available plant-based cheese analogue (PBCA) products in the Irish market, comparing them against conventional cheddar and processed dairy cheeses. A total of 16 cheese products were selected from Irish retail outlets, comprising five block-style plant-based analogues, seven slice-style analogues, two cheddar samples, and two processed cheese samples. Results showed that plant-based cheese analogues had significantly lower protein content (0.1–1.7 g/100 g) than cheddar (25 g/100 g) and processed cheese (12.9–18.2 g/100 g) and lacked a continuous protein matrix, being instead stabilized largely by solid fats, starch, and hydrocolloids. While cheddar showed the highest hardness, some plant-based cheeses achieved comparable hardness using texturizing agents but still demonstrated lower tan δ_max values, indicating inferior melting behaviour. Thermograms of differential scanning calorimetry presented a consistent single peak at ~20 °C across most vegan-based variants, unlike the dual-phase melting transitions observed in dairy cheeses. Sensory analysis further highlighted strong negative associations between PBCAs and consumer-relevant attributes such as flavour, texture, and overall acceptability. By integrating structural, functional, and sensory findings, this study identifies key formulation and performance deficits across cheese formats and provides direction for targeted improvements in next-generation PBCA product development. Full article

The global concern about the use of disposable plastics has fed the research on sustainable packaging for food products. Among the virtuous materials, chitosan emerges as a valid alternative to conventional polyethylene films because of its abundance in nature. In this work, a novel film for food wrapping was developed by exploiting shellfish waste according to a vision of circular economy. Compared to previous studies, here, novel ingredients, such as polyvinyl alcohol (PVA), fibroin, and essential oils, were used in a synergistic combination to functionally postpone cheese deterioration. The fermentative procedure applied for the obtainment of chitin contributes to filling the existing gap in the literature, since the majority of studies are based on the chemical pathways that dramatically impact the environment. After pretreatment, the shrimp shell waste (SSW) was fermented through two bacterial strains, namely Lactobacillus plantarum and Bacillus subtilis. A deacetylation step in an alkaline environment transformed chitin into chitosan, yielding 78.88 g/kg SWW. Four different film formulations were prepared, all containing chitosan with other ingredients added in order of decreasing complexity from the A to D groups. The novel films were tested with regard to their physico-mechanical and antioxidant properties, including the tensile strength (12.10–23.25 MPa), the elongation at break (27.91–46.12%), the hardness (52–71 Shore A), the film thickness (308–309 μm), and the radical scavenging activity (16.11–76.56%). The performance as a cling film was tested on two groups of cheese samples: the control (CTR), wrapped in conventional polyethylene (PE) film; treated (TRT), wrapped in the chitofilm formulation deemed best for its mechanical properties. The volatiles entrapped into the headspace were investigated by means of the SPME-GC technique. The results varied across soft, Camembert, and semi-hard cheeses, indicating a growing abundance of volatiles during the conservation of cheese. The bacterial growth trends for mesophilic, enterobacteriaceae, and lactic acid bacteria were expressed as the mean colony forming units (CFU)/mL for each type of cheese at different sampling times (day 2, day 8, and day 22): the highest load was quantified as 8.2 × 10⁶ CFU/mL at day 22 in the CTR Camembert cheese. The TRT samples generally exhibited inhibitory activity comparable to or lower than that observed in the CTR samples. The sensory analysis revealed distinctions in cheese taste between the TRT and CTR groups. Full article

This study is based on the need to improve packaging sustainability in the food industry. Its aim was to assess the performance of a recyclable plastic material for semi-hard sheep’s cheese wedges packaging as an alternative to conventional non-sustainable plastic materials. Four different packaging treatments (air, vacuum, and CO₂/N₂ gas mixtures 50/50 and 80/20% (v/v)) were studied. Changes in gas headspace composition, sensory properties, cheese gross composition, weight loss, pH, colour, and texture profile were investigated at 5 ± 1 °C storage for 56 days. The sensory analysis indicated that vacuum packaging scored the worst in paste appearance and holes, and air atmosphere the worst in flavour; it was concluded that cheeses were unfit from day 14–21 onwards. Air and vacuum packaging were responsible for most of the significant changes identified in the texture profile analysis, and most of these happened in the early stages of storage. The colour parameters a* and b* differentiated the air packaging from the rest of the conditions. As in previous studies using conventional plastic materials, modified atmosphere packaging, either CO₂/N₂ 50/50 or 80/20% (v/v), was the most effective preserving technique to ensure the quality of this type of cheese when comparing air and vacuum packaging treatments. Full article

Biobased and biodegradable polymeric materials are a sustainable alternative to the conventional plastics used in food packaging. This study investigated the possible effect of biobased cling films derived from renewable and circular and sustainable sources on key cheese sensory parameters (appearance and odor) able to influence consumer acceptance or rejection of a food product over time. For this purpose, a semi-hard cheese was selected as food model and stored for 14 days at 5 °C wrapped with five cling films: two bio-plastic materials from renewable circular and sustainable sources (R-BP1 and R-BP2), one bio-plastic film from a non-renewable source (NR-BP), and two conventional cling films (LDPE and PVC). Three analytical approaches (image analysis, electronic nose, and sensory test) were applied to evaluate the variation and the acceptability in terms of appearance and odor of the cheese. In preserving cheese color, the R-BP1 and RBP2 films were comparable to LDPE film, while NR-BP film was comparable to PVC film. In terms of odor preservation, R-BP2 film was comparable to LDPE and PVC. The consumer test showed that appearance and odor scores were higher for cheeses stored in R-BP1 and R-BP2 films than NR-BP film. Moreover, in terms of odor, R-BP1 film performed better than conventional films. This study shows how biodegradable cling films from renewable circular and sustainable resources could have comparable performance to conventional plastics (LDPE and PVC) used in the food sector. Full article

With increasing awareness of the impact of food on the climate, consumers are gradually changing their dietary habits towards a more plant-based diet. While acceptable products have been developed in meat analogues and non-fermented dairy products, alternative fermented dairy products such as yogurt and particularly ripened hard and semi-soft cheese products are not yet satisfactory. Since the cheese category has such a broad range of flavors and applications, it has proven complicated to find plant-based sources able to mimic them in terms of texture, meltability, ripening and flavor. Moreover, plant-based dairy alternatives do not provide the same nutritional supply. New technological approaches are needed to make cheese production more sustainable, which should be integrated in the already existing conventional cheese production to ensure a fast and cost-efficient transition. This can be tackled by incorporating plant-based components into the milk matrix, creating so-called “hybrid cheeses”. This review will discuss the challenges of both animal- and plant-based cheese products and highlight how the combination of both matrices can associate the best properties of these two worlds in a hybrid product, reviewing current knowledge and development on the matter. Emphasis will be drawn to the selection and pre-processing of raw materials. Furthermore, the key challenges of removing the off-flavors and creating a desirable cheese flavor through fermentation will be discussed. Full article

Kefalograviera is a well-known hard Greek cheese. The aim of this study was to determine how milk produced from ewes fed omega-3-enriched diets could influence the microbiota as well as the chemical composition of Kefalograviera cheese. At the start of the trial, 30 dairy ewes (Lesvos and Chios crossbreed) were selected and fed a conventional diet, based on alfalfa hay, straw and concentrate feed that contained soybean meal for a period of thirty days. Then, for a period of sixty days the same ewes were fed an omega-3-enriched concentrate feed with a lower level of soybean meal that contained 10% flaxseed and 10% lupins. Milk yield was collected individually on Days 30, 60 and 90 and used to produce three different batches of Kefalograviera cheeses, at the same cheese factory, by using a traditional recipe and identical preparation conditions (pasteurization of milk, salt, rennet and culture). Sample analysis was done after six months of Kefalograviera cheese ripening. MALDI-TOF-MS (matrix-assisted laser desorption/ionization time of flight mass spectrometry) identification was performed by contrasting the samples’ mass spectra with the corresponding reference database. The correlation between the different Kefalograviera cheeses revealed the predominant species being Lactococcus lactis, Lactobacillus rhamnosus, Lactobacillus plantarum, Lactobacillus brevis, Lactobacillus paracasei, Enterococcus faecium and Enterococcus faecalis, with significant quantitative differences between the experimental groups and the controls. Pediococcus spp. was isolated only from the experimental groups’ cheeses and Staphylococcus spp. only from the controls’ cheese, suggesting—among other differences—a bacterial microbiota distinction between the groups. Moreover, increased levels of alpha-linolenic acid and total polyunsaturated omega-3 fatty acids were noted in the enriched Kefalograviera cheeses. These promising findings suggest that enriched Kefalograviera cheese could be manufactured via enriching the ewes’ diets, with potential benefits for the consumers’ health. Full article

In this study, we investigated the lipid composition of fresh and semi-hard goat cheese produced in three Italian farms as well as the welfare assessment of goats reared in these farms. The fatty acid (FA) profile of cheese samples were found to be strictly related to the livestock system. Cheese collected from farms in which goats were allowed to graze and were fed diets with a higher forage/concentrate (F/C) ratio showed a FA profile represented by higher contents of health-promoting fatty acids. In the same samples, the health lipid indices showed the most favorable values. Conversely, cheese samples collected from a conventional-lowland farm, where goats were fed with higher amounts of concentrates and lower F/C ratio, presented a lower nutritional quality, characterized by the worst results for what concerns the health lipid indices. Then, we built a multivariate model able to discriminate samples coming from farms managed by a low-input system from those coming from farm managed by a high-input system. The comparison of animal welfare measurements and fatty acids data showed that a better intrinsic quality of low-input farms did not always correspond to better extrinsic quality, suggesting that the information on the livestock system is not always enough to provide consumers with complete awareness of the total product quality. Full article

In the following study, three different dairy by-products, previously concentrated by ultrafiltration (UF), were used as ingredients in the production of reduced-fat (RF) washed curd cheeses in order to improve their characteristics. Conventional full-fat (FF) cheeses (45% fat, dry basis (db)) and RF cheeses (20–30% fat, db) were compared to RF cheeses produced with the incorporation of 5% concentrated whey (RF + CW), buttermilk (RF + CB) or sheep second cheese whey (RF + CS). Protein-to-fat ratios were lower than 1 in the FF cheeses, while RF cheeses ranged from 1.8 to 2.8. The tested by-products performed differently when added to the milk used for cheese production. The FF cheese showed a more pronounced yellow colour after 60 and 90 days of ripening, indicating that fat plays an important role regarding this parameter. As far as the texture parameters are concerned, after 60 days of ripening, RF cheeses with buttermilk presented similar results to FF cheeses for hardness (5.0–7.5 N) and chewiness (ca. 400). These were lower than the ones recorded for RF cheeses with added UF concentrated whey (RF + CW) and second cheese whey (RF + CS), which presented lower adhesiveness values. RF cheeses with 5% incorporation of buttermilk concentrated by UF presented the best results concerning both texture and sensory evaluation. Full article

Lactobacillus plantarum are amongst the diversified lactic acid bacteria (LAB) species which are being utilized abundantly in the food industry. Numerous L. plantarum strains have been reported to produce several antimicrobial compounds. Diacetyl, hydrogen peroxide, organic acids, as well as bacteriocins can also be exemplified by a variable spectrum of actions. The current study was intended to conduct the screening and characterization of antimicrobial prospective of L. plantarum from traditional Inner Mongolian fermented hard cheese. Foodborne pathogens, Salmonella typhimurium, Escherichia coli O157:H7, Listeria monocytogenes, and Staphylococcus aureus, were examined by using the Oxford cup technique and the mixed culture inhibition assays. The resulting analyses disclosed that L. plantarum KLDS1.0344 indicated broad antimicrobial spectrum against all selected pathogens as compared to other LAB used in this study. Additionally, the decrement of the pathogen population was observed up to 3.47 logs in mixed culture inhibition assays. L. plantarum KLDS 1.0344 acid production was recorded up to 71.8 ± 3.59 °D in mixed culture while antimicrobial particles released in cell free supernatants demonstrated bacteriocin-like characteristics showing substantial pH stability (2.0–6.0), proteolytic enzyme reduced the antibacterial activity (15.2 ± 0.6 mm–20.4 ± 0.8 mm), heat stability (20 min at 120 °C) against selected pathogens. Moreover, the spectrum range of antimicrobial peptides after the partial purification was decreased as compared to the crude bacteriocin-like compound. The SDS-PAGE analysis showed the molecular weight range of partially purified bacteriocin from 12 to 45 kDa. After analyzing the obtained data from the current experimentation showed that the capability of L. plantarum KLDS 1.0344 to oppose the pathogen growth in vitro relies on the occurrence of organic acids along with bacteriocin-like compounds proving L. plantarum KLDS 1.0344 as a potentially appropriate candidate as an alternative bio-control agent against foodborne pathogens. Full article