The Electronic Waste (E-waste) Management and Treatment

Dear Colleagues,

Rapid technological innovation has greatly shortened the life cycle of electronic products. The massive generation of waste electrical and electronic equipment (WEEE) has displayed exponential growth with a rate of more than 3–5% annually. In 2016, the global amount of electronic waste, so called e-waste, was approximately 44.7 million metric tons (Mt) and has reached 57 Mt in 2021. In the past few decades, informal e-waste burning had resulted in substantially high levels of air pollution identified at the treatment points and, in turn, posed a threat to the environment and public health. Recently, many advanced technologies have been developed to facilitate metal recovery from WPCBs, including pyrometallurgy, hydrometallurgy, physico-mechanical separation, electrolysis, supercritical fluid, and bioleaching. Among them, the pyrometallurgical processes are generally operated at 300–900 ºC and have the disadvantage of high energy consumption and expensive capital investment. Hydrometallurgical processes use cyanide, halide, thiourea, and thiosulfate to recover metals, consuming large amounts of chemical reagents, as well as producing a large volume of effluents. Mechanical beneficiation operations, such as gravity air classifiers, eddy current separation, and magnetic separation have been widely used in e-waste recycling plants worldwide. However, the recovered metals are mixed, and need be refined. Therefore, more in-depth research on e-waste management and treatment need be conducted, including novel techniques development, fate of pollutants and control strategies, the economic appraisal, etc.

In this Special Issue, original research articles and reviews are welcome. Research areas may include (but are not limited to) the following:

• Crushing and separation;
• Bioleaching;
• Metal recovery;
• Thermal treatment and kinetics;
• Fate of pollutants and control strategies;
• Solidification/Stabilization;
• Polymer composites preparation;
• Circular economy;
• Policies.

Dr. Zhitong Yao
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Electronics is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.