Vibration and Noise (3rd Edition)

A special issue of Acoustics (ISSN 2624-599X).

Deadline for manuscript submissions: 16 September 2026 | Viewed by 1738

Special Issue Editor


E-Mail Website
Guest Editor
Department of Mechanical Engineering, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong 999077, China
Interests: sound-induced vibration; noise control; building acoustics; environmental noise measurement and control; sound source identification
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

Following the successful publication of our first and second editions, we are pleased to announce the third edition of our Special Issue “Vibration and Noise”. This Special Issue aims to showcase the latest advances in this field, including, but not limited to, the following topics: interactions of vibration and noise; vibrations caused by noise; radiation of noise from vibrating structures; control of low-frequency vibration and noise; insulation, absorption, generation, and propagation of vibration and noise; theoretical, numerical, and experimental studies of vibration and noise; the control of vibration and noise in aircraft, automobiles, machinery, and vehicles; and materials for the control of vibration and noise. Beyond this, detection, measurement, and analysis methods are also discussed in this Special Issue. Due to the multidisciplinary nature of the field, we also welcome research investigating the interplay between structural vibration, noise, and fluids.

Dr. Yat Sze Choy
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Acoustics is an international peer-reviewed open access quarterly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 1600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • noise control
  • noise generation
  • vibration control
  • vibration and noise measurement and analysis
  • aircraft noise
  • automobile or vehicle noise
  • machinery noise
  • vibroacoustic coupling

Benefits of Publishing in a Special Issue

  • Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
  • Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
  • Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
  • External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
  • Reprint: MDPI Books provides the opportunity to republish successful Special Issues in book format, both online and in print.

Further information on MDPI's Special Issue policies can be found here.

Related Special Issues

Published Papers (2 papers)

Order results
Result details
Select all
Export citation of selected articles as:

Research

13 pages, 13564 KB  
Article
Evaluation of the Effect of Vibration and Acoustic Signals in a Class II Biological Safety Cabinet on Wound Healing in Keratinocytes
by Mete Öğüç and Zeynep Güneş Özünal
Acoustics 2026, 8(2), 29; https://doi.org/10.3390/acoustics8020029 - 29 Apr 2026
Viewed by 340
Abstract
Class II biological safety cabinets (BSCs) are designed to protect the user, the product, and the laboratory environment by maintaining HEPA-filtered airflow; however, their fans, alarms, and structural resonances introduce acoustic and vibrational stimuli that may confound mechanosensitive cell-culture assays. In this study, [...] Read more.
Class II biological safety cabinets (BSCs) are designed to protect the user, the product, and the laboratory environment by maintaining HEPA-filtered airflow; however, their fans, alarms, and structural resonances introduce acoustic and vibrational stimuli that may confound mechanosensitive cell-culture assays. In this study, we characterized the vibroacoustic environment of a cell-culture laboratory and a Class II BSC, selected representative tray locations based on measured and modeled stimuli, and evaluated in vitro wound closure in HaCaT keratinocytes using a scratch assay under alarm-induced acoustic exposure. Wound closure after 24 h was quantified using a relative area-closure metric defined as one minus the ratio of wound area at 24 h to wound area at 0 h. For each biological replicate (one flask and one scratch), two non-overlapping image regions were treated as technical subsamples and averaged to obtain a single flask-level value. Three independent experimental runs were performed, each including one flask per tray point, yielding n equals 3 independent flasks per tray point. Mean wound closure values were 73.7 percent plus or minus 15.6 percent, 75.6 percent plus or minus 7.2 percent, and 79.4 percent plus or minus 14.8 percent for tray points P1, P5, and P6, respectively (mean plus or minus standard deviation). No statistically significant differences were detected among points (one-way ANOVA on flask-level values, F equals 0.15, p equals 0.86). These findings highlight that BSC-associated acoustic and vibration stimuli should be documented when interpreting scratch-assay outcomes and motivate larger, sham-controlled studies to resolve small effect sizes relevant for assay reproducibility. Full article
(This article belongs to the Special Issue Vibration and Noise (3rd Edition))
Show Figures

Figure 1

14 pages, 2357 KB  
Article
Diffraction of Sound Waves by a Periodic Array of Impedance Screens
by Nikolay Kanev
Acoustics 2026, 8(1), 4; https://doi.org/10.3390/acoustics8010004 - 23 Jan 2026
Viewed by 838
Abstract
Air-penetrating and noise-canceling constructions are required for numerous noise control issues. High ventilation performance conflicts with effective sound insulation, and vice versa. For this reason, ventilated noise barriers are currently being intensively researched and developed. One of the most popular solutions is the [...] Read more.
Air-penetrating and noise-canceling constructions are required for numerous noise control issues. High ventilation performance conflicts with effective sound insulation, and vice versa. For this reason, ventilated noise barriers are currently being intensively researched and developed. One of the most popular solutions is the louvered-type barrier, whose acoustic efficiency depends on its geometric parameters as well as the acoustic properties of the louvers. One of the main challenges is optimizing the acoustic impedance of louver surfaces in order to achieve maximum reflection, absorption, or minimum transmission of sound waves. This paper proposes an analytical solution to the diffraction problem of a plane sound wave incident on a periodic array of similar thin screens with arbitrary impedance surfaces. An infinite system of linear equations is derived, and its numerical solution allows us to find the reflection and transmission coefficients. It has been shown that screens with reactive impedance are necessary to achieve maximum sound reflection. On the other hand, dissipative screens are required for minimal sound transmission. Additionally, the absorption properties of the array have been studied. It has been found that there is an optimal impedance value that provides the maximum absorption coefficient. Full article
(This article belongs to the Special Issue Vibration and Noise (3rd Edition))
Show Figures

Figure 1

Back to TopTop