Next Article in Journal / Special Issue
Computational Predictions for Boger Fluids and Circular Contraction Flow under Various Aspect Ratios
Previous Article in Journal
Three-Dimensional Convective Planforms for Inclined Darcy-Bénard Convection
Previous Article in Special Issue
Antibiotic Activity Screened by the Rheology of S. aureus Cultures
 
 
Article
Peer-Review Record

Verification and Validation of openInjMoldSim, an Open-Source Solver to Model the Filling Stage of Thermoplastic Injection Molding

by João Pedro, Bruno Ramôa, João Miguel Nóbrega * and Célio Fernandes
Reviewer 2: Anonymous
Reviewer 3: Anonymous
Submission received: 3 May 2020 / Revised: 23 May 2020 / Accepted: 25 May 2020 / Published: 29 May 2020
(This article belongs to the Special Issue Advances in Experimental and Computational Rheology, Volume II)

Round 1

Reviewer 1 Report

Dear all,

the content of the paper is very relevant and nicely presented. I only added a few remarks, both on content and language.

congratulations

 

Comments for author File: Comments.pdf

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

Dear authors, 

I appreciate your work on development numerical simualtion apporach for injection moulding using open source software. 

Overall, I think the apporach is sound and it is orgnized very well. 

It would be good to adapt the simulation to more challenging area, such as micro injection moulding. 

 

 

 

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 3 Report

Please refer to the attached pdf file.

Comments for author File: Comments.pdf

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Back to TopTop