Affiliation Correction
In the original publication [1], the postcode of Affiliation 6 should be 35121.
Error in Figure
In the original publication [1], there was a mistake in Figure 4 as published.
The modification to Figure 4 only concerns the part that is marked with the letter a. In Section 2.2.1. (Unconfined Compression Tests), we explain that with the stress relaxation procedure, the sample reached a 60% compression strain at the end of the testing approach, but as reported in Section 3 (Results), we decided to limit the strain up to 50%. Therefore, we took the stress–strain curve which considers the strain in the range from 0 to 0.6 and, with software for curve elaboration, stopped the deformation up to 0.5 (50%). Unfortunately, while performing this procedure, we did not update the values along the y-axis, which remain those corresponding to the 0–0.6 range, 70 kPa, instead of the correct 14 kPa. The updated visual representation is provided below. Hence, Figure 4 should be updated to have the correct y-axis range of values 0–14 kPa, in part a.
The corrected Figure 4 appears below. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.
Figure 4.
Unconfined compression tests: (a) Stress–strain equilibrium curves and (b) normalized stress–time results comparing the different regions (mean ± SD). (c) Initial and (d) final elastic modulus computed from stress–strain equilibrium curves, (e) relative stiffness computed at t = 300 s (median with maximum and minimum values). HP = heel pad; L = lateral; M = medial; Met = metatarsal; p = statistically different p-value.
Reference
- Pettenuzzo, S.; Belluzzi, E.; Pozzuoli, A.; Macchi, V.; Porzionato, A.; Boscolo-Berto, R.; Ruggieri, P.; Berardo, A.; Carniel, E.L.; Fontanella, C.G. Mechanical Behaviour of Plantar Adipose Tissue: From Experimental Tests to Constitutive Analysis. Bioengineering 2024, 11, 42. [Google Scholar] [CrossRef]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2025 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).