Next Article in Journal
Dynamic Recrystallization Critical Conditions and a Physically–Based Constitutive Model of Al–4.8Mg Alloy Under Hot Working Conditions
Next Article in Special Issue
Properties and Performance of Novel Mg(OH)2-Based Coatings for Corrosion Mitigation in Concrete Sewer Pipes
Previous Article in Journal
The Influence of Different Microstructure on Tensile Deformation and Acoustic Emission Behaviors of Low-Alloy Steel
Previous Article in Special Issue
Heat-Induced Acceleration of Pozzolanic Reaction Under Restrained Conditions and Consequent Structural Modification
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Article

The Examination of Hydrated Cement Paste Made of CEM III/A 42,5 N-LH/HSR/NA under the Influence of Urea Solution

by
Barbara Słomka-Słupik
Faculty of Civil Engineering, Silesian University of Technology, Akademicka 5 Str., 44-100 Gliwice, Poland
Materials 2020, 13(21), 4984; https://doi.org/10.3390/ma13214984
Submission received: 13 October 2020 / Revised: 30 October 2020 / Accepted: 3 November 2020 / Published: 5 November 2020
(This article belongs to the Special Issue New Findings in Cementitious Materials)

Abstract

The production of urea, used inter alia in agriculture, is increasing. Therefore, urea hydrolysis products are expected in groundwater. Due to lack of new research on the influence of urea on the technical condition of concrete structures, the changes that this compound may cause to hardened cement paste were initially check. After 11 months of immersion of hardened cement paste in 20% CO(NH2)2 solution, tests were conducted at different depths of penetration. A pH of 11.97 was recorded in the first layer with a thickness of 0.5 mm, and the pH of the innermost layer was 12.48. The decalcification process and the formation of predominantly secondary calcite in the edge layers were confirmed using XRD, SEM, and analytical methods. No nitrogen phase was formed, but the deeper was the layer, more wollastonite was present. Moreover, up to a depth of about 20 mm, the sample was mechanically weak-breakable by the force of the hands. The examination of the filtrate’s conductivity, leachable calcium content, and pH along the way of urea diffusion confirmed changes in the examined material. When analyzing the technical condition of concrete treated with urea, pH could be an indicator due to the possibility of buffer reactions.
Keywords: concrete corrosion; urea; decalcification concrete corrosion; urea; decalcification

Share and Cite

MDPI and ACS Style

Słomka-Słupik, B. The Examination of Hydrated Cement Paste Made of CEM III/A 42,5 N-LH/HSR/NA under the Influence of Urea Solution. Materials 2020, 13, 4984. https://doi.org/10.3390/ma13214984

AMA Style

Słomka-Słupik B. The Examination of Hydrated Cement Paste Made of CEM III/A 42,5 N-LH/HSR/NA under the Influence of Urea Solution. Materials. 2020; 13(21):4984. https://doi.org/10.3390/ma13214984

Chicago/Turabian Style

Słomka-Słupik, Barbara. 2020. "The Examination of Hydrated Cement Paste Made of CEM III/A 42,5 N-LH/HSR/NA under the Influence of Urea Solution" Materials 13, no. 21: 4984. https://doi.org/10.3390/ma13214984

APA Style

Słomka-Słupik, B. (2020). The Examination of Hydrated Cement Paste Made of CEM III/A 42,5 N-LH/HSR/NA under the Influence of Urea Solution. Materials, 13(21), 4984. https://doi.org/10.3390/ma13214984

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop