Search Results (9)

The beneficial role of melatonin (MT) as a potent broad-spectrum antioxidant and hormone-like regulator in plant protection against adverse environmental conditions is indisputable. However, the molecular networks underlying its unique scavenging capabilities are still far from understood. Herein, we show the ability of MT to maintain physiological functions under high light stress (HL) is mediated by photoreceptors. Melatonin treatment (50 μM) of the photoreceptor mutants phyA/B and cry1/2 augmented the deleterious effects of excess light (600 μmol m⁻² s⁻¹, 24 h), as evidenced by increased TBARs levels and electrolyte leakage, as well as decreased photosynthetic efficiency, in contrast to their parental form, Landsberg erecta, in which these parameters were significantly improved. The reduced stress resistance of the mutants was also confirmed by analysis of the transcript accumulation of ROS markers and enzymatic scavengers. Moreover, the increase in melatonin content in the mutants exposed to HL + MT contributed to increased ROS accumulation; therefore, the deleterious effect of MT could not be explained by an imbalance in ROS production below the cytostatic level. We hypothesize that the light-sensitive phenotypes of photoreceptor mutants under MT treatment may be due to the misregulation of stress-related genes that are targets for melatonin action. Full article

Leaf photosynthesis largely determines the daughter corm yields in vegetative growth for saffron (Crocus sativus L.). Most of the previous researches focus on the spectral response in various species, but research on saffron leaves at different leaf ages is lacking. In this study, the action spectrum based on photosynthetic photon flux density (PPFD) and irradiance were distinguished and interpreted. The optical properties and photosynthetic performances of leaves were, respectively, investigated at two leaf ages, dependent on customized narrow-band LED spotlights from 380 nm to 780 nm with an interval of 20 nm and a band width of 10 nm. The younger leaves were characterized by higher reflectance and transmittance values at 500−600 nm, resulting in lower absorptance compared to the older leaves. The spectral response curves including the action spectrum and quantum yield for younger leaves were higher than the older, but their relative curves displayed coincidence. The spectral response curves exhibited two peaks at 440 and 640 nm, but no obvious troughs between 500 and 600 nm were observed. Nevertheless, the photosynthetic energy efficiencies of spotlights demonstrated very low values in the green/yellow region. Accordingly, more attention should be paid to green and yellow LED lighting during the vegetative stage for saffron, as well as improving their manufacturing technology. Full article

Green microalgae are important sources of natural products and are attractive cell factories for manufacturing high-value products such as recombinant proteins. Increasing scales of production must address the bottleneck of providing sufficient light energy for photosynthesis. Enhancing the photosynthetic action spectrum of green algae to improve the utilisation of yellow light would provide additional light energy for photosynthesis. Here, we evaluated the Katushka fluorescent protein, which converts yellow photons to red photons, to drive photosynthesis and growth when expressed in Chlamydomonas reinhardtii chloroplasts. Transplastomic algae expressing a codon-optimised Katushka gene accumulated the active Katushka protein, which was detected by excitation with yellow light. Removal of chlorophyll from cells, which captures red photons, led to increased Katushka fluorescence. In yellow light, emission of red photons by fluorescent Katushka increased oxygen evolution and photosynthetic growth. Utilisation of yellow photons increased photosynthetic growth of transplastomic cells expressing Katushka in light deficient in red photons. These results showed that Katushka was a simple and effective yellow light-capturing device that enhanced the photosynthetic action spectrum of C. reinhardtii. Full article

Microalgae are photosynthetic organisms known for producing valuable metabolites under different conditions such as extreme temperatures, high salinity, osmotic pressure, and ultraviolet radiation. In recent years, these metabolites have become a trend due to their versatility in applications such as pharmaceuticals, cosmetics, and others. They have even been proposed as an alternative source of bioactive metabolites to avoid the harmful effects on the environment produced by active compounds such as oxybenzone in commercials sunscreens. One of the most studied applications is the use of microalgae for skin care and topical use as cosmeceuticals. With the increasing demand for more environmentally friendly products in cosmetics, microalgae have been further explored in relation to this application. It has been shown that some microalgae are resistant to UV rays due to certain compounds such as mycosporine-like amino acids, sporopollenin, scytonemin, and others. These compounds have different mechanisms of action to mitigate UV damage induced. Still, they all have been proven to confer UV tolerance to microalgae with an absorbance spectrum like the one in conventional sunscreens. This review focuses on the use of these microalgae compounds obtained by UV stimulation and takes advantage of their natural UV-resistant characteristics to potentially apply them as an alternative for UV protection products. Full article

Engineered nanoparticles (NPs) are considered potential agents for agriculture as fertilizers and growth enhancers. However, their action spectrum differs strongly, depending on the type of NP, its concentrations, and plant species per se, ranging from growth stimulation to toxicity. This work aimed to investigate effects of iron oxide (Fe₃O₄) NPs on growth, photosynthesis, respiration, antioxidant activity, and leaf mineral content of wheat plants. Wheat seeds were treated with NP for 3 h and plants were grown in the soil at two light intensities, 120 and 300 μmol (photons) m⁻²·s⁻¹, followed by physiological assessment at several time points. High NP treatment (200 and 500 mg·L⁻¹) enhanced plant growth, photosynthesis and respiration, as well as increasing the content of photosynthetic pigments in leaves. This effect depended on both the light intensity during plant growth and the age of the plants. Regardless of concentration and light intensity, an effect of NPs on the primary photochemical processes was not observed. Seed treatment with NP also led to increased activity of ascorbate peroxidase and reduced malondialdehyde (MDA) content in roots and leaves. Treatment with Fe₃O₄ also led to noticeable increases in the leaf Fe, P, and K content. It is concluded that iron oxide (Fe₃O₄)-based NP could enhance plant growth by improving photosynthetic performance and the availability of Fe and P. Full article

The optimization of plant-specific LED lighting protocols for indoor plant growing systems needs both basic and applied research. Experiments with lettuce, Lactuca sativa L., plants using artificial lighting based on narrow-band LEDs were carried out in a controlled environment. We investigated plant responses to the exclusion of certain spectral ranges of light in the region of photosynthetically active radiation (PAR); in comparison, the responses to quasimonochromatic radiation in the red and blue regions were studied separately. The data on plant phenotyping, photosynthetic activity determination, and PAM fluorometry, indicating plant functional activity and stress responses to anomalous light environments, are presented. The study on carbon isotopic composition of photoassimilates in the diel cycle made it possible to characterize the balance of carboxylation and photorespiration processes in the leaves, using a previously developed oscillatory model of photosynthesis. Thus, the share of plant photorespiration (related to plant biomass enrichment with ¹³C) increased in response to red-light action, while blue light accelerated carboxylation (related to ¹²C enrichment). Blue light also reduced water use efficiency. These data are supported by the observations from the light environments missing distinct PAR spectrum regions. The fact that light of different wavelengths affects the isotopic composition of total carbon allowed us to elucidate the nature of its action on the organization of plant metabolism. Full article

For the first time in dye-sensitized solar cell (DSSC) technology, a di-carbazole-based dye was synthesized and evaluated for its usage as a potential sensitizer for the development of wavelength selective semi-transparent DSSCs for greenhouses-oriented applications. The dye was designed to demonstrate a blue light absorption, allowing a high transmittance in the red region of the visible light, even after its adsorption on the anode semiconductor, which is the most important one for the photosynthetic action of the plants. The application of the new dye to DSSCs was examined using either a high-performance iodide-based electrolyte or a highly transparent iodine-free electrolyte to determine a good balance between electric power generation and device transparency. The spectral engineered DSSCs demonstrated quite promising characteristics, providing a high external quantum efficiency (higher than 70%) in the whole blue–green region of the visible light, while allowing high transparency (up to 55%) in the red region, where the second peak in the absorbance spectrum of chlorophyll is located. Finally, the derived results were discussed under the consideration of important metrics for this niche application, including the transparency of the solar cells in the region of photosynthetic active radiation and the attained crop growth factor. The present work constitutes one of the few comprehensive studies carried out up to now in the direction of the development of 3rd generation “agrivoltaics” for their possible integration as cladding materials in energy-autonomous greenhouses. Full article

Ornamental plants are often used in indoor environments as part of biophilic design to improve the health and wellbeing of occupants, and to support sustainable, green architecture. Unfortunately, many plants do not thrive and need to be continuously replaced, which is economically unsustainable. The wavelengths and spectrum ratio of commonly used light sources such as light emitting diode (LED), and the lack of an appropriate light dark cycle (photoperiod), appear to be crucial influencing factors. Therefore, this study focuses on determining the optimal action spectrum of LEDs for visually and biologically effective illumination for plants, and humans as end users. This practice-based research study applies critical analysis of literature, photographic evaluation of the appearance of plants under various LED lighting in the form of a visual assessment questionnaire-based survey, and provides various measurements that record the properties of light including correlated color temperature (CCT), color rendering index (CRI), spectral power distribution (SPD), peak light wavelength (λP), photosynthetic photon flux density (PPFD) and daily light integrals (DLI). Research confirms the LED lighting used for horticultural food production cannot be applied to ornamental indoor plants due to fundamental differences in purpose. Such illumination provides fast growth for market consumption and usually makes plants appear unnatural, whereas ornamental plants in an indoor environment should grow at an appropriate speed which reduces maintenance costs and they should have a natural appearance. These new findings, supported by evidence and data, can help investors, clients, architects, landscape and lighting designers, as well as luminaire manufacturers, make improved, biophilic-sustainable lighting design choices. Full article

Plant factories have attracted increasing attention because they can produce fresh fruits and vegetables free from pesticides in all weather. However, the emission spectra from current light sources significantly mismatch the spectra absorbed by plants. We demonstrate a concept of using multiple broad-band as well as narrow-band solid-state lighting technologies to design plant-growth light sources. Take an organic light-emitting diode (OLED), for example; the resulting light source shows an 84% resemblance with the photosynthetic action spectrum as a twin-peak blue dye and a diffused mono-peak red dye are employed. This OLED can also show a greater than 90% resemblance as an additional deeper red emitter is added. For a typical LED, the resemblance can be improved to 91% if two additional blue and red LEDs are incorporated. The approach may facilitate either an ideal use of the energy applied for plant growth and/or the design of better light sources for growing different plants. Full article