Search Results (3)

Nanofluids and nanotechnology are very important in enhancing heat transfer due to the thermal conductivity of their nanoparticles, which play a vital role in heat transfer applications. Researchers have used cavities filled with nanofluids for two decades to increase the heat-transfer rate. This review also highlights a variety of theoretical and experimentally measured cavities by exploring the following parameters: the significance of cavities in nanofluids, the effects of nanoparticle concentration and nanoparticle material, the influence of the inclination angle of cavities, heater and cooler effects, and magnetic field effects in cavities. The different shapes of the cavities have several advantages in multiple applications, e.g., L-shaped cavities used in the cooling systems of nuclear and chemical reactors and electronic components. Open cavities such as ellipsoidal, triangular, trapezoidal, and hexagonal are applied in electronic equipment cooling, building heating and cooling, and automotive applications. Appropriate cavity design conserves energy and produces attractive heat-transfer rates. Circular microchannel heat exchangers perform best. Despite the high performance of circular cavities in micro heat exchangers, square cavities have more applications. The use of nanofluids has been found to improve thermal performance in all the cavities studied. According to the experimental data, nanofluid use has been proven to be a dependable solution for enhancing thermal efficiency. To improve performance, it is suggested that research focus on different shapes of nanoparticles less than 10 nm with the same design of the cavities in microchannel heat exchangers and solar collectors. Full article

The paper compares conceptual designs of a microstructured reactor/heat-exchanger for the small-scale production of C₈₊ range hydrocarbons from methanol over H-ZSM-5 catalytic coatings. In these designs, air was used as a cooling fluid in the adjacent cooling channels. The heat transfer characteristics of a single-zone reactor (with channels 500 $\mathsf{\mu }$m in diameter) and a two-zone reactor (with an additional coolant inlet) have been compared. A single reaction zone was not able to reduce the temperature gradient below 15 K, while a two-zone configuration, with a counter-current fluid flow in the upstream section and co-current flow in the downstream section, demonstrated a near-isothermal behaviour, with a mean temperature of 653 K. Full article

This paper addresses the issues related to the rapid production of hydrogen from methane steam reforming by means of process intensification. Methane steam reforming coupled with catalytic combustion in thermally integrated microchannel reactors for the production of hydrogen was investigated numerically. The effect of the catalyst, flow arrangement, and reactor dimension was assessed to optimize the design of the system. The thermal interaction between reforming and combustion was investigated for the purpose of the rapid production of hydrogen. The importance of thermal management was discussed in detail, and a theoretical analysis was made on the transport phenomena during each of the reforming and combustion processes. The results indicated that the design of a thermally integrated system operated at millisecond contact times is feasible. The design benefits from the miniaturization of the reactors, but the improvement in catalyst performance is also required to ensure the rapid production of hydrogen, especially for the reforming process. The efficiency of heat exchange can be greatly improved by decreasing the gap distance. The flow rates should be well designed on both sides of the reactor to meet the requirements of both materials and combustion stability. The flow arrangement plays a vital role in the operation of the thermally integrated reactor, and the design in a parallel-flow heat exchanger is preferred to optimize the distribution of energy in the system. The catalyst loading is an important design parameter to optimize reactor performance and must be carefully designed. Finally, engineering maps were constructed to design thermally integrated devices with desired power, and operating windows were also determined. Full article