Search Results (8)

Deterministic generation of dissipative Kerr solitons (DKSs) is a key requirement for practical microresonator-based frequency comb sources. Here, we present a design methodology for Si₃N₄ dual-coupled microring resonators (DCMs) that relates device geometry to the intrinsic and interaction parameters governing soliton formation. In particular, the auxiliary-ring geometry controls the avoided mode crossing, enabling targeted control of the interaction strength a and its modal position b through geometric design and refractive-index tuning. The resulting DCM configurations exhibit accessible DKS regions in the $(\Delta ,|S{|}^2)$ parameter space under constant pump power and linear detuning sweeps. These results provide a practical framework for the implementation of robust microresonator frequency comb sources with simplified control. Full article

Microwave frequency comb (MFC) optimization for frequency-modulated continuous-wave (FMCW) generation by period-one (P1) dynamics with dual-loop optical feedback are numerically investigated. The linewidth, the side peak suppression (SPS) ratio, and the comb contrast are adopted to quantitatively evaluate the optimization performance, which directly influence the phase stability, spectral purity and repeatability of the MFC. The results show that intensity modulation of the optical injection can generate a sweepable FMCW signal after photodetection via the optical beat effect. When optical feedback loops are introduced, the single-loop configuration can reduce the phase noise of the FMCW signal whereas a dual-loop configuration exploits the Vernier effect to achieve further linewidth reduction and wide tolerance to the feedback strength. Finally, for both the SPS ratio and comb contrast, the dual-loop configuration achieves a higher SPS ratio and maintains high contrast across a wide range of optical feedback loop delays, which outperforms the loop time tolerance of the single-loop configuration. Full article

To address the thermal protection challenges of multiple high-temperature components and the electrical power deficiency in hypersonic vehicles, this study proposes twelve multi-heat-source thermoelectric conversion schemes based on the sCO₂ Brayton cycle. A three-dimensional evaluation system for thermal management is established, incorporating thermal efficiency, coolant mass flow rate, and system mass as key metrics. A comprehensive parameter sensitivity analysis was conducted on the twelve dual-heat-source cycle configurations. For systematic performance comparison, the Non-dominated Sorting Genetic Algorithm II (NSGA-II) was employed for multi-objective optimization, with Pareto fronts analyzed to determine optimal configurations. The results demonstrate that appropriately increasing the minimum cycle temperature can significantly reduce coolant flow requirements. Multi-objective optimization reveals the following: (1) The pre-compressed aero-comb configuration achieves optimal performance in the efficiency-mass flow rate optimization scenario; (2) Both pre-compressed aero-comb and re-compressed comb-aero configurations show superiority in the efficiency-mass optimization scenario; (3) The pre-compressed aero-comb configuration exhibits lower system mass in low coolant flow regions for the mass flow rate-mass optimization scenario. Overall, the performance of the precompression aero-comb configuration is relatively superior. This work provides an important reference for the design of thermal management systems for hypersonic vehicles. Full article

We configured a long-distance ranging apparatus to test the principle of dual-comb time-of-flight measurement using ultrashort lasers. Emphasis was given to the evaluation of open-air performance quantitatively in terms of the measurement resolution and stability. The test results revealed that our dual-comb asynchronous optical pulse sampling permits micrometer-resolved ranging with a repeatability of 2.05 μm over a 648 m distance in dry weather conditions. Further atmospheric effects were evaluated in three different weather conditions with corresponding Allan deviations. Finally, the capability of simultaneous determination of multiple targets was verified with the potential of advanced industrial applications, such as manufacturing, surveying, metrology, and geodesy. Full article

We propose and implement a terahertz time-of-flight ranging system based on adaptive clock asynchronous optical sampling, where the timing jitter is corrected in real time to recover the depth information in the acquired interferograms after compensating for laser instabilities using electronic signal processing. Consequently, the involved measurement uncertainties caused by the timing jitter during the terahertz sampling process and the noise intensity of the terahertz electric field have been reduced by the utilization of the adaptive clock. The achieved uncertainty range is about 2.5 μm at a 5 cm distance after averaging the acquisition time of 1876 ms 5000 times, showing a significant improvement compared with the asynchronous optical sampling using a constant clock. The implemented terahertz ranging system only uses free-running mode-locked lasers without any phase-locked electronics, and this favors simple and robust operations for subsequent applications that extend beyond the laboratory conditions. Full article

We report feedback-induced frequency oscillations using a power-split-ratio through asymmetric dual-loop optical feedback (Loop I: ~2.2 km and Loop II: ~20 m) subject to a self-mode-locked two-section QDash laser emitting at 1550 nm and operating at 21 GHz repetition rate. To assess the suppression of frequency resonances, three chosen combinations of feedback power (Loop I: −27.27 dB and Loop II: −19.74 dB, Loop I: −22 dB and Loop II: −22 dB, and Loop I: −19.74 dB and Loop II: −27.27 dB) through asymmetric dual-loop optical feedback have been studied. Based on the chosen coupling strength, an optimum feedback ratio that yields better side-mode suppression has been identified. Our results demonstrate that side-mode suppression can be achieved by the fine adjustment of coupling power through either cavity of dual-loop feedback configurations. Furthermore, we have further demonstrated that frequency fluctuations from the RF spectra can be filtered by carefully selecting the delay phase of the second cavity. Our experimental findings suggest that semiconductor mode-locked lasers based on dual-loop feedback configurations can be used to develop noise oscillations free from integrated photonic oscillators for potential applications in telecommunications, multiplexing, and frequency-comb generation. Full article

Conventional mechanical Fourier Transform Spectrometers (FTS) can simultaneously measure absorption and dispersion spectra of gas-phase samples. However, they usually need very long measurement times to achieve time-resolved spectra with a good spectral and temporal resolution. Here, we present a mid-infrared dual-comb-based FTS in an asymmetric configuration, providing broadband absorption and dispersion spectra with a spectral resolution of 5 GHz (0.18 nm at a wavelength of 3333 nm), a temporal resolution of 20 μs, a total wavelength coverage over 300 cm⁻¹ and a total measurement time of ~70 s. We used the dual-comb spectrometer to monitor the reaction dynamics of methane and ethane in an electrical plasma discharge. We observed ethane/methane formation as a recombination reaction of hydrocarbon radicals in the discharge in various static and dynamic conditions. The results demonstrate a new analytical approach for measuring fast molecular absorption and dispersion changes and monitoring the fast dynamics of chemical reactions over a broad wavelength range, which can be interesting for chemical kinetic research, particularly for the combustion and plasma analysis community. Full article

Optical frequency combs (OFC) generated by electro-optic modulation of continuous-wave lasers provide broadband coherent sources with high power per line and independent control of line spacing and the number of lines. In addition to their application in spectroscopy, they offer flexible and optimized sources for the interrogation of other sensors based on wavelength change or wavelength filtering, such as fiber Bragg grating (FBG) sensors. In this paper, a dual-OFC FBG interrogation system based on a single laser and two optical-phase modulators is presented. This architecture allows for the configuration of multimode optical source parameters such as the number of modes and their position within the reflected spectrum of the FBG. A direct read-out is obtained by mapping the optical spectrum onto the radio-frequency spectrum output of the dual-comb. This interrogation scheme is proposed for measuring fast phenomena such as vibrations and ultrasounds. Results are presented for dual-comb operation under optimized control. The optical modes are mapped onto detectable tones that are multiples of 0.5 MHz around a center radiofrequency tone (40 MHz). Measurements of ultrasounds (40 kHz and 120 kHz) are demonstrated with this sensing system. Ultrasounds induce dynamic strain onto the fiber, which generates changes in the reflected Bragg wavelength and, hence, modulates the amplitude of the OFC modes within the reflected spectrum. The amplitude modulation of two counterphase tones is detected to obtain a differential measurement proportional to the ultrasound signal. Full article