Search Results (10)

Organic dyes in natural waters jeopardize human health. Whether semiconductor materials can effectively degrade dyes has become a challenge for scientific research. Based on this, this study rationally prepared different nanocomposites to remove organic dyes effectively. Pure SnO₂ quantum dots, ZnO nanosheets, and SnO₂/ZnO (ZS) binary nanocomposites are prepared using the hydrothermal method. Subsequently, SnO₂/ZnO@GO (ZSG) ternary composites containing different amounts of GO, i.e., ZSG-5, ZSG-15, and ZSG-25, are synthesized by an ultrasonic water bath method, in which ZS was coupled with GO to form Z-type heterojunctions. The ZSG-15 ternary composites exhibited excellent photocatalytic activity for the degradation of rhodamine B by simulating sunlight. The test results show that the degradation rate of ZSG-15 is about 7.6 times higher than ZnO. The increase in photocatalytic activity is attributed to the synergistic effect of SnO₂ and GO to improve the separation efficiency of photogenerated carriers in ZnO. Notably, the large specific surface area of GO increases the reactive sites. Compared with binary nanocomposites, ZSG-15 broadens the response range to light while further accelerating the electron transport rate and improving the photoelectric stability. Full article

In this work, graphene-oxide-decorated porous ZnO nanosheets were prepared using a hydrothermal method. The graphene oxide/porous ZnO nanosheet (GO/ZnO nanosheet) composites were characterized with SEM, HRTEM, XRD, Raman spectroscopy, XPS and BET. The results indicate that the ZnO nanosheets have a porous, single-crystal structure. Thin GO nanosheets closely cover the surface of porous ZnO nanosheets. The sensing performance of GO/ZnO nanosheet composites is investigated. At the optimized temperature of 300 °C, the GO/ZnO nanosheet composites exhibit a superior sensing performance in n-propanol detection. In a wide range of 5–200 ppm, the composites exhibit a linear response to n-propanol. Moreover, the sensing performance of the GO/ZnO nanosheet composites to n-propanol is largely higher than that to other VOC gases, indicating a high selectivity in n-propanol detection. This can be ascribed to the higher electron-separation efficiency and larger depletion layer brought by the modification of the GO on ZnO nanosheets. It is considered that the GO/ZnO nanosheet composites have a great application potential in n-propanol detection. Full article

Bacteria employ numerous resistance mechanisms against structurally distinct drugs by the process of multidrug resistance. A study was planned to discover the antibacterial potential of a graphene oxide nanosheet (GO), a graphene oxide–zinc oxide nanocomposite (GO/ZnO), a graphene oxide-chitosan nanocomposite (GO–CS), a zinc oxide decorated graphene oxide–chitosan nanocomposite (GO–CS/ZnO), and zinc oxide nanoparticles (ZnO) alone and in a blend with antibiotics against a PS-2 isolate of Pseudomonas aeruginosa. These nanocomposites reduced the MIC of tetracycline (TET) from 16 folds to 64 folds against a multidrug-resistant clinical isolate. Efflux pumps were interfered, as evident by an ethidium bromide synergy study with nanocomposites, as well as inhibiting biofilm synthesis. These nanoparticles/nanocomposites also decreased the mutant prevention concentration (MPC) of TET. To the best of our knowledge, this is the first report on nanomaterials as a synergistic agent via inhibition of efflux and biofilm synthesis. Full article

In this work, the effects of graphene oxide (GO) concentrations (1.5 wt.%, 2.5 wt.%, and 5 wt.%) on the structural, morphological, optical, and luminescence properties of zinc oxide nanorods (ZnO NRs)/GO nanocomposites, synthesized by a facile hydrothermal process, were investigated. X-ray diffraction (XRD) patterns of NRs revealed the hexagonal wurtzite structure for all composites with an average coherence length of about 40–60 nm. A scanning electron microscopy (SEM) study confirmed the presence of transparent and wrinkled, dense GO nanosheets among flower-like ZnO nanorods, depending on the GO amounts used in preparation. Raman spectroscopy, Fourier transform infrared spectroscopy (FTIR), ultraviolet–visible (UV–Vis) absorption spectroscopy, and photoluminescence (PL) measurements revealed the impact of GO concentration on the optical and luminescence properties of ZnO NRs/GO nanocomposites. The energy band gap of the ZnO nanorods was independent of GO concentration. Photoluminescence spectra of nanocomposites showed a significant decrease in the intensities in the visible light range and red shifted suggesting a charge transfer process. The nanocomposites’ chromaticity coordinates for CIE 1931 color space were estimated to be (0.33, 0.34), close to pure white ones. The obtained results highlight the possibility of using these nanocomposites to achieve good performance and suitability for optoelectronic applications. Full article

The coupling reactions of polyethylene glycol (PEG) with two different nano-carbonaceous materials, graphene oxide (GO) and expanded graphene oxide (EGO), were achieved by amide bond formations. These reactions yielded PEGylated graphene oxides, GO-PEG and EGO-PEG. Whilst presence of the newly formed amide links (NH-CO) were confirmed by FTIR stretches observed at 1732 cm⁻¹ and 1712 cm⁻¹, the associated Raman D- and G-bands resonated at 1311/1318 cm⁻¹ and 1584/1595 cm⁻¹ had shown the carbonaceous structures in both PEGylated products remain unchanged. Whilst SEM images revealed the nano-sheet structures in all the GO derivatives (GO/EGO and GO-PEG/EGO-PEG), TEM images clearly showed the nano-structures of both GO-PEG and EGO-PEG had undergone significant morphological changes from their starting materials after the PEGylated processes. The successful PEGylations were also indicated by the change of pH values measured in the starting GO/EGO (pH 2.6–3.3) and the PEGylated GO-PEG/EGO-PEG (pH 6.6–6.9) products. Initial antifungal activities of selective metallic nanomaterials (ZnO and Cu) and the four GO derivatives were screened against Candida albicans using the in vitro cut-well method. Whilst the haemocytometer count indicated GO-PEG and copper nanoparticles (CuNPs) exhibited the best antifungal effects, the corresponding SEM images showed C. albicans had, respectively, undergone extensive shrinkage and porosity deformations. Synergistic antifungal effects all GO derivatives in various ratio of CuNPs combinations were determined by assessing C. albicans viabilities using broth dilution assays. The best synergistic effects were observed when a 30:70 ratio of GO/GO-PEG combined with CuNPs, where MIC₅₀ 185–225 μm/mL were recorded. Moreover, the decreased antifungal activities observed in EGO and EGO-PEG may be explained by their poor colloidal stability with increasing nanoparticle concentrations. Full article

Recently, graphene oxide nanoscroll (GONS) has attracted much attention due to its excellent properties. Encapsulation of nanomaterials in GONS can greatly enhance its performance while ion encapsulation is still unexplored. Herein, various ions including hydronium ion (H₃O⁺), Fe³⁺, Au³⁺, and Zn²⁺ were encapsulated in GONSs by molecular combing acidic graphene oxide (GO) solution. No GONS was obtained when the pH of the GO solution was greater than 9. A few GONSs without encapsulated ion were obtained at the pH of 5–8. When the pH decreased from 5 to 0.15, high-density GONSs with encapsulated ions were formed and the average height of GONS was increased from ~50 to ~190 nm. These results could be attributed to the varied repulsion between carboxylic acid groups located at the edges of GO nanosheets. Encapsulated metal ions were converted to nanoparticles in GONS after high-temperature annealing. The resistance-type device based on reduced GONS (rGONS) mesh with encapsulated H₃O⁺ showed good response for applied pressure from 600 to 8700 Pa, which manifested much better performance compared with that of a device based on rGONS mesh without H₃O⁺. Full article

In order to obtain acetone sensor with excellent sensitivity, selectivity, and rapid response/recovery speed, graphene-like ZnO/graphene oxide (GO) nanosheets were synthesized using the wet-chemical method with an additional calcining treatment. The GO was utilized as both the template to form the two-dimensional (2-D) nanosheets and the sensitizer to enhance the sensing properties. Sensing performances of ZnO/GO nanocomposites were studied with acetone as a target gas. The response value could reach 94 to 100 ppm acetone vapor and the recovery time could reach 4 s. The excellent sensing properties were ascribed to the synergistic effects between ZnO nanosheets and GO, which included a unique 2-D structure, large specific surface area, suitable particle size, and abundant in-plane mesopores, which contributed to the advance of novel acetone vapor sensors and could provide some references to the synthesis of 2-D graphene-like metals oxide nanosheets. Full article

In this study, we use a facile hydrothermal method to synthesize rGO@ZnO_1−x composites. The in-situ synthesized ZnO nanosheets are well attached on the rGO sheets, which prevent the aggregation and restacking of ZnO nanosheets, greatly increasing the specific surface area of the synthesized materials. In addition, on account of the reducing synthesis condition, large numbers of oxygen vacancies are implanted into ZnO. With the incorporation of rGO, the visible light absorption range of the composites is greatly enhanced. The synthesized rGO@ZnO_1−x composites exhibit excellent performance to ppb-level NO₂ under white light illumination at room temperature, which effectively overcomes the disadvantages of typical metal oxide gas sensors. Full article

Herein, a promising carrier, graphene oxide (GO) decorated with ZnO nanoparticles, denoted as GO/ZnO composite, has been designed and constructed. This carrier was characterized by X-ray powder diffraction, scanning electron microscopy, Fourier transform infrared spectroscopy and thermogravimetry. Then, Candida rugosa lipase (CRL) was immobilized onto the GO-based materials via physical adsorption. Our results indicated that the lipase loading amount on the GO/ZnO composites was about 73.52 mg of protein per g. In the activity assay, the novel immobilized lipase GO/ZnO@CRL, exhibited particularly excellent performance in terms of thermostability and reusability. Within 30 min at 50 °C, the free lipase, GO@CRL and ZnO@CRL had respectively lost 64%, 62% and 41% of their initial activity. However, GO/ZnO@CRL still retained its activity of 63% after 180 min at 50 °C. After reuse of the GO/ZnO@CRL 14 times, 90% of the initial activity can be recovered. Meanwhile, the relative activity of GO@CRL and ZnO@CRL was 28% and 23% under uniform conditions. Hence, GO-decorated ZnO nanoparticles may possess great potential as carriers for immobilizing lipase in a wide range of applications. Full article

Bamboo materials with improved antibacterial performance based on ZnO and graphene oxide (GO) were fabricated by vacuum impregnation and hydrothermal strategies. The Zn2+ ions and GO nanosheets were firstly infiltrated into the bamboo structure, followed by dehydration and crystallization upon hydrothermal treatment, leading to the formation of ZnO/GO nanocomposites anchored in the bulk bamboo. The bamboo composites were characterized by several techniques including scanning electron microscopy (SEM), Fourier transform infrared spectra (FTIR), and X-ray diffraction (XRD), which confirmed the existence of GO and ZnO in the composites. Antibacterial performances of bamboo samples were evaluated by the bacteriostatic circle method. The introduction of ZnO/GO nanocomposites into bamboo yielded ZnO/GO/bamboo materials which exhibited significant antibacterial activity against Escherichia coli (E. coli, Gram-negative) and Bacillus subtilis (B. subtilis, Gram-positive) bacteria and high thermal stability. The antimicrobial bamboo would be expected to be a promising material for the application in the furniture, decoration, and construction industry. Full article