Search Results (6)

To address the issues of slow dynamic response and poor disturbance rejection in three-phase interleaved parallel buck converters under disturbance conditions such as voltage or load transients, an improved sliding mode auto-disturbance rejection control (SM-ADRC) strategy is proposed. Firstly, the traditional ADRC algorithm suffers from reduced disturbance observation accuracy in the extended state observer (ESO) due to discontinuous switching of the nonlinear function at segment boundaries. To address this, a novel nonlinear function is designed using an interpolation fitting method. Concurrently, an improved ESO is constructed based on deviation-control principles, utilising the deviation between each state variable and its observed value. Secondly, an enhanced state error feedback law combines an improved exponential approach law with an integral sliding mode surface, thereby enhancing the control system’s robustness. Finally, simulation comparisons of output voltage fluctuations and power response speeds under various operating conditions validate the superiority and feasibility of the proposed SM-ADRC strategy over both the conventional ADRC strategy and PI control strategy. Full article

This paper focuses on the control problems of a multi-modal underwater robot, which is designed mainly for the task of detecting the working environment in deep-sea mining. To tackle model uncertainty and external disturbances, an improved linear active disturbance rejection control scheme based on sliding mode control is proposed (SM-ADRC). Firstly, to reduce overshoot, a piecewise $fhan$ function is introduced into the tracking differentiator (TD). This design retains the system’s fast nonlinear tracking characteristics outside the boundary layer while leveraging linear damping within it to achieve effective overshoot suppression. Secondly, two key enhancements are made to the SMC: an integral sliding surface is designed to improve steady-state accuracy, and a saturation function replaces the sign function to suppress high-frequency chattering. Furthermore, the SMC integrates the total disturbance estimate from the linear extended state observer (LESO) for feedforward compensation. Finally, the simulation experiment verification is completed. The simulation results show that the SM-ADRC scheme significantly improves the dynamic response and disturbance suppression ability of the system and simultaneously suppresses the chattering problem of SMC. Full article

To address the issues of low trajectory tracking accuracy and difficulties in tuning control parameters for crawler robots operating in uneven terrains, this paper proposes a trajectory tracking control method. The method is based on improved particle swarm optimization and sliding mode active disturbance rejection control (SPSO-SMADRC). Firstly, considering the influence of disturbances such as terrain undulations and soil inhomogeneity on trajectory deviation, the kinematic and dynamic models of the crawler robot are established. A vector field guidance approach is employed to transform the trajectory tracking task into a heading control problem. The heading angle is adaptively adjusted based on the position deviation and path curvature. A nonlinear extended state observer is introduced to estimate external disturbances. A velocity-based SMADRC controller is designed to dynamically regulate the robot’s linear and angular velocities. This allows real-time correction of the robot’s motion. To overcome the tendency of the standard particle swarm optimization (PSO) algorithm to fall into local optima during controller parameter tuning, a nonlinear dynamic adjustment strategy was adopted. This strategy adaptively adjusts the inertia weight and learning factors, enhancing the algorithm’s global search capability. Comparative experiments were conducted using two types of curved trajectories: U-shaped and V-shaped paths. The experimental results show that, under the proposed SPSO-SMADRC method, the crawler robot achieved maximum position errors of 8.28 cm and 9.26 cm, average position errors of 1.41 cm and 2.94 cm, and maximum heading angle deviations of 0.56 rad and 0.87 rad. The standard deviations of the position errors were 3.19 and 4.28, respectively. Compared with conventional PSO-based SMADRC and standard SMADRC methods, the proposed approach improved the navigation tracking accuracy. In the U-shaped trajectory, the maximum position error was reduced by 19.22% and 38.21%, the average position error by 40.00% and 65.53%, and the heading angle error by 28.21% and 74.66%. In the V-shaped trajectory, the maximum position error was reduced by 17.39% and 38.95%, the average position error by 51.71% and 52.04%, and the heading angle error by 80.58% and 84.49%. These results demonstrate that the proposed SPSO-SMADRC method significantly enhances trajectory tracking performance and system robustness. It provides effective support for high-precision autonomous navigation of crawler robots in complex and unstructured environments. Full article

This article presents a modified active-disturbance-rejection control (ADRC) combined with a sliding mode control (SMC) regarding the tracking control problems for plants with unmatched uncertainty. The proposed modified active-disturbance-rejection control with sliding mode (ADRC-SM) employs a reduced-order extended state observer (ESO) for estimating various uncertainties of system in time, including unmatched and matched uncertainties. Meanwhile, a novel reaching law of SMC was designed by using the cycloid function as the main controller of ADRC, which ensures the robustness of the uncertain system. Due to the reduced-order ESO tracking and compensating for various uncertainties in the system as a total disturbance, the upper bound of the disturbance in the SMC is relaxed. The gain coefficient of the reaching law only needs to be designed to be larger than the limit of the lumped disturbance; thus, the chattering problem is greatly reduced. The designed new reaching law of the cycloid function shortens the time for the system state’s convergence to the sliding mode’s surface. The cycloid function replaces the switching function in the traditional reaching law, making the actual control input continuous and shortening the approach time. Compared with traditional ADRC-SM, the use of multiple ESOs or intelligent algorithms to approximate plant parameters can be avoided, the design is simplified, its robustness is enhanced, computational costs are reduced, and the convergence time is reduced. The controlled object with unmatched uncertainty is transformed into a system with matched uncertainty using state-space transformation, which reduces the complexity of the controller’s design. In addition, the stability analysis of the closed-loop system is carried out based on the Lyapunov method. Simulations and experiments verify that the modified ADRC-SM has the merits of fast response, small overshoot, small steady-state error, strong anti-interference competence, and high control accuracy. Full article

This paper proposes a novel robust control scheme for tip trajectory tracking of a lightweight flexible single-link arm. The developed control scheme deals with the influence of tip payload changes and disturbances during the working process of the flexible arm, thus realizing the accurate tracking for the tip reference trajectory. The robust control scheme is composed of an inner loop and an outer loop. The inner loop adopts the traditional PD control, and an active disturbance rejection control (ADRC) with a sliding mode (SM) compensation is designed in the outer loop. Moreover, the sliding mode compensation is mainly used to cope with the disturbance estimation error from the extended state observer (ESO), by which the insensitivity to tip payload variations and strong disturbance resistance is achieved. Finally, some numerical simulations are performed to support the theoretical analysis. The results show that the system is more robust to the tip mass variations of the arm and more resistant to the external torque after adding the sliding mode robustness term to the ADRC. Full article

The DC distribution network has more advantages in power transmission, grid connection of distributed energy, and reliability of power supply when compared with AC distribution network, but there are still many problems in the development of DC distribution network. DC bus voltage control is one of the hot issues in the research of DC distribution network. To solve this problem, in this paper, a new type of sliding mode active disturbance rejection control (SMADRC) controller for AC/DC converters is designed and applied to the voltage outer loop. The linear extended state observer (LESO) can observe the state variables and the total disturbance of the system. The SMADRC is composed of a sliding mode controller, LESO, and disturbance compensator, which can compensate the total disturbance observed by LESO properly. Therefore, it improves the dynamic. At the same time, it can also reduce the system jitter that is caused by sliding mode controller. The state variables that are observed by the LESO are used in the design of sliding mode controller, which greatly simplifies the design of sliding mode controller. Finally, the simulation results of Matlab/Simulink show that the controller has good start-up performance and strong robustness. Full article