Search Results (9)

Background/Objectives. With a rapid palatal expander (RPE) is reported to be effective in increasing the volume of nasal cavities, with a restoration of physiological nasal airflow. The purpose of this retrospective clinical study was to evaluate, using Cone Beam Computed Tomography (CBCT), the volumetric changes and airflow velocity changes in the nasal cavities, retro-palatal and retro-glossal airways, resulting from the use of RPE with dental anchorage (group A), also comparing these data with patients non treated with RPE (group B). Methods. Sixteen subjects (aged 9.34 years) with transverse maxillary deficiency and unilateral posterior crossbite were treated with RPE with dental anchorage. Additionally, 8 patients (aged 11.11 years) with juvenile idiopathic arthritis, who did not undergo any orthodontic treatment, were selected as a control group. Expansion was performed until overcorrection was achieved, and the device was left in place for 6 months as fixed retention, followed by another 6 months of night-time removable retention. From the retrospective evaluation, all patients presented two CBCT scans at baseline (T0) and 1-year follow-up (T1). The 3D-Slicer software was used for each CBCT to measure the nasal (VN), retropalatal (VRP), and retroglossal (VRG) volumes, while an iterative Excel spreadsheet allowed for a pilot approximated modeling and calculation of airway flow-related data. Results. Regarding mean age, a statistically significant difference (p = 0.01 *) was found between groups, suggesting that group B is closer to the pubertal growth peak. Analysis between T0 and T1 revealed: (i) a statistically significant increase for volumes VN, VRP and VRG in group A; (ii) a statistically significant increase for VN in group B; (iii) a statistically significant decrease for all variables related to airflow velocity in both groups. Furthermore, comparison between group A and B, regarding variations between T0 and T1, found a statistically significant difference only for VN. Conclusions. Within the limitations of this pilot evaluation, the treatment with RPE revealed promising outcomes for retro-palatal, retro-glossal and nasal volumes, together with clinical changes in airflow velocities. Full article

The most common inflammatory reactions in the oral mucosa are found at the gingival level. The treatment of these inflammations requires, first of all, the removal of the causative factor; often, this maneuver is sufficient. The aim of this retrospective study was to evaluate clinical and histopathological changes that occur in terms of gingival and palatal mucosa enlargement during palatal expansion treatment and their evolution during treatment. Twenty-five (n = 25) research participants, aged between thirteen and twenty-six years old, were examined in this retrospective study. At the end of the treatment, fragments of tissue from the affected level were obtained via incisional biopsy and sent to the histopathology laboratory for a specialized examination. The changes identified were specific to mechanical traumatic injuries, thus excluding hyperplasia from other etiologies (infectious, tumoral, or non-mechanical traumatic). The examined fragments showed hyperplasia. The histopathological examination revealed the mechanical character of the lesion, strengthening the causal relationship between the insertion of the expander and the occurrence of hyperplasia of the palatal mucosa. The type of palatal expander influenced the degree of inflammation, with the severity of hyperplasia being more pronounced in the case of mini-implant-anchored rapid palatal expander (MARPE) usage than in the case of tooth-borne rapid palatal expander (RPE) usage. The analysis of the distance between the expander and the palatal mucosa did not provide conclusive results; the incidence and severity of the reaction were variable in patients with the same distance between the expander and the palatal or gingival mucosa. Full article

We present a novel method for the online measurement of multi-point opening distances of midpalatal sutures during a rapid palatal expansion (RPE) using fiber optic Fabry–Perot (F–P) sensors. The sensor consists of an optical fiber with a cut flat end face and an optical reflector, which are implanted into the palatal base structure of an expander and is capable of measuring the precise distance between two optical reflective surfaces. As a demonstration, a 3D-printed skull model containing the maxilla and zygomaticomaxillary complex (ZMC) was produced and a miniscrew-assisted rapid palatal expander (MARPE) with two guide rods was used to generate the midpalatal suture expansion. The reflected spectrums of the sensors were used to dynamically extract cavity length information for full process monitoring of expansion. The dynamic opening of the midpalatal suture during the gradual activation of the expander was measured, and a displacement resolution of 2.5 μm was demonstrated. The angle of expansion was derived and the results suggested that the midpalatal suture was opened with a slight V-type expansion of 0.03 rad at the first loading and subsequently expanded in parallel. This finding might be useful for understanding the mechanical mechanisms that lead to different types of expansion. The use of a fiber optic sensor for mounting the rapid palatal expander facilitates biomechanical studies and experimental and clinical evaluation of the effects of RPE. Full article

Aim: The aim of the present systematic review is to evaluate the pain perceived by patients during rapid maxillary expansion (RME) in relation to factors such as demographic characteristics, appliance type, activation protocol, and the eventual use of medication or pain management strategies. Materials and methods: An electronic search of available articles on the subject was conducted on three electronic databases, using predefined keywords. Sequential screenings based on pre-established eligibility criteria were performed. Results: Ten studies were ultimately included in this systematic review. The main data of the reviewed studies were extracted according to the PICOS approach. Conclusions: Pain is a common effect of RME treatment that tends to decrease over time. Gender and age differences in pain perception are not clear. Perceived pain is influenced by the expander design and expansion protocol used. Some pain management strategies can be useful for reducing RME-associated pain. Full article

Treatment of third-class malocclusions often presents a challenge for orthodontists. Skeletal disharmony is often associated with dental malposition. There are several therapeutic choices, including the use in combination of transverse expansion of the maxilla with rapid palatal expander (RPE) and posterior-anterior traction with a Delaire face mask (FM). The purpose of the study is to verify whether there are significant differences in the treatment outcome in the case of use of a face mask followed by a palatal expander or with the sequence of these auxiliaries reversed. Subject and Methods: The two groups were both made up of 13 patients, subdivided into group A, i.e., those whose sequence involved the use of extraoral traction first and then the disjunctor, and those with an inverted sequence in group B. Some cephalometric parameters and dento-skeletal characteristics were evaluated pre-treatment (t0) and at the end of therapy (t1). Results: Considering the T1–T0 of group A (Delaire + rapid palatal expander), the evaluation of the results obtained in this work allows us to observe how within group A there is a significant improvement in the Witts and Nanda indices and facial convexity. Group B (treated with the palate disjunctor sequence followed by traction with Delaire’s mask) showed a significant improvement in ANB, in AoBo, and AppBpp values and in convexity. The two groups were comparable, and no statistically significant difference was highlighted. Discussion: The early therapy of the third skeletal classes by means of a rapid palate expander and face mask is effective. There is no statistically significant difference in the two groups who performed the therapy in reverse mode. This suggests that the clinician should choose the treatment sequence based on the skeletal and occlusal conditions of their patients at the start of treatment. Conclusion: Early therapy of third skeletal classes with sagittal expansion using a rapid palate expander can be performed earlier or later than posterior-anterior traction with a Delaire mask. Full article

This case report describes the orthodontic treatment of a 9-year-old girl who presented with multiple agenesis, maxillary contraction, and skeletal Class III malocclusion after the surgical removal of a melanocytic neuroectodermal tumour of infancy (MNTI) or the so-called melanocytic progonoma at 40 days of age. The lack of dental anchorage in the posterior segment of the second quadrant and the search for maximum control during suture expansion to reduce dental effects led to the use of a hybrid rapid palatal expander (RPE) with dental anchorage in the first quadrant and skeletal anchorage on the two miniscrews placed in the second quadrant, to allow a more even distribution of expansion forces. The expansion procedures performed with the hybrid anchorage device and extraoral traction demonstrate the possibility of solving the contraction in the posterior segments and anterior crossbite in a few months with maximum control of the applied forces, despite the objective difficulties related to the specificity of the case. Full article

The aim of this retrospective study was to compare the efficiency of two biologically oriented devices in achieving maxillary expansion: Rapid Palatal Expander (RPE) and Nitanium Palatal Expander-2 (NPE-2). Thirty-six subjects, divided in two equal groups, were included in this study. Maxillary dental arches were scanned using Trios 3 shape^®, in order to perform a digital analysis of 3D models. The models were analyzed using Autodesk Fusion 360^® and Meshmixer^®. All data obtained from analysis of pre-treatment and post-treatment models were processed using Prism^® software. The anterior arch width, the posterior arch width, the palate height, and palatal surface were measured to evaluate differences between the devices. A D’Agostino–Pearson normality test was done to check the data. A non-parametric t-test was used to compare the anterior and posterior arch width between the two groups, while a parametric t-test was used to compare the palatal height measurements between the two groups. The p-value was calculated. The limit value fixed was 0.05. Palatal width and surface showed a significant increase in both groups, but no significant changes in palatal height were found. The data processed showed that there were no significant differences between the devices (ΔREP−ΔNPE) in variation of anterior arch width, there were no significant differences in variation of posterior arch width and there were no significant differences in variation of palatal height. The comparison between the two groups showed that both methods were equally effective in correcting transverse defect. Full article

The aim of this study was to compare the three-dimensional dentoskeletal effects of Haas-type and Hyrax-type expanders using primary teeth as anchorage for rapid palatal expansion (RPE). Thirty-four subjects in mixed dentition were divided according to their expander’s type: Hyrax (n = 16; 6F, 10M; mean age 8 ± 3 years) or Haas (n = 18; 14F, 4M; mean age 8 ± 2 years). Each patient underwent CBCTs before (T0) and after RPE (T1). Dentoskeletal changes were collected. A paired sample t-test and independent t-test were used to compare each variable within the same group and between groups, respectively, with a 5% significance. The Hyrax group showed an increase in all dentoskeletal parameters; skeletal expansion was significantly increased anteriorly (1.76 mm) and posteriorly (1.93 mm). The greatest dental expansion was observed in the anchorage unit (6.47 mm), about twice as much as permanent molars (3.42 mm). The same statistical significance of Haas group measurements was observed; anteriorly skeletal expansion (2.97 mm) was greater than posteriorly (1.93 mm) and dental expansion was greater on anchored teeth (6.80 mm) than non-anchored teeth (4.57 mm). No statistical significance was observed between Hyrax and Hass groups. CBCT analysis showed that, in RPE, the dental expansion was greater than skeletal expansion. No significant or clinical changes were observed between Hyrax and Haas appliances anchored to primary teeth. Full article

Rapid palatal expansion is an orthodontic procedure widely used to correct the maxillary arch. However, its outcome is significantly influenced by factors that show a high degree of variability amongst patients. The traditional treatment methodology is based on an intuitive and heuristic treatment approach because the forces applied in the three dimensions are indeterminate. To enable optimal and individualized treatment, it is essential to measure the three-dimensional (3D) forces and displacements created by the expander. This paper proposes a method for performing these 3D measurements using a single embedded strain sensor, combining experimental measurements of strain in the palatal expander with 3D finite element analysis (FEA). The method is demonstrated using the maxillary jaw from a freshly euthanized pig (Sus scrofa) and a hyrax-design rapid palatal expander (RPE) appliance with integrated strain gage. The strain gage measurements are recorded using a computer interface, following which the expansion forces and extent of expansion are estimated by FEA. A total activation of 2.0 mm results in peak total force of about 100 N—almost entirely along the direction of expansion. The results also indicate that more than 85% of the input activation is immediately transferred to the palate and/or teeth. These studies demonstrate a method for assessing and individualizing expansion magnitudes and forces during orthopedic expansion of the maxilla. This provides the basis for further development of smart orthodontic appliances that provide real-time readouts of forces and movements, which will allow personalized, optimal treatment. Full article