Aerogels and Their Composites: Fabrication, Properties and Application

A special issue of Gels (ISSN 2310-2861). This special issue belongs to the section "Gel Applications".

Deadline for manuscript submissions: closed (29 February 2024) | Viewed by 835

Special Issue Editor


E-Mail Website
Guest Editor
Department of Physics, University of Mumbai, Mumbai, India
Interests: aerogels; synthesis; material characterization; materials; nanomaterials; thin films and nanotechnology; polymers; X-ray diffraction; material; characteristics; advanced materials; materials processing

Special Issue Information

Dear Colleagues,

Gels is a multi-disciplinary, rapid-publication journal focused on the fundamental principles of nanoporous materials, as well as the principles of the applied technologies of related fields. The objective of the journal is to advance the field through new discoveries and techniques, encouraging widespread scientific international readership.

This Special Issue, titled “Aerogels and Their Composites: Fabrication, Properties and Application”, emphasizes the fundamental scientific innovation of comprehensive articles, short communications and reviews within the following categories:

  • Nanogels formulation and characterization.
  • Hydrogels formulation and characterization.
  • Organogels formulation and characterization.
  • Silica aerogel synthesis and characterization.
  • Carbon aerogel synthesis and characterization.
  • Organic and inorganic aerogel.
  • Aerogels for water-splitting applications.
  • Aerogels for water treatment applications.
  • Aerogels for supercapacitor applications.
  • Batteries
  • Gas capture/separation/storage.
  • Green/sustainable materials.
  • Carbon dioxide conversion.
  • Catalysis.
  • Fuel cells.
  • Hydrogen generation.
  • Hydrogen storage.
  • Photocatalysts.
  • Sensors.
  • Surfaces and coating.

Dr. Pradip B. Sarawade
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Gels is an international peer-reviewed open access monthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • silica aerogel synthesis and characterization
  • carbon aerogel synthesis and characterization
  • organic and inorganic aerogel
  • aerogels for water-splitting applications
  • aerogels for water treatment applications
  • aerogels for supercapacitor applications

Published Papers

There is no accepted submissions to this special issue at this moment.
Back to TopTop