Next Article in Journal
Investigation of the Fractional Strongly Singular Thermostat Model via Fixed Point Techniques
Next Article in Special Issue
Finite-Time Passivity Analysis of Neutral-Type Neural Networks with Mixed Time-Varying Delays
Previous Article in Journal
Norms That Regulate the Theorem Construction Process in an Inquiry Classroom of 3D Geometry: Teacher’s Management to Promote Them
Previous Article in Special Issue
Global Stability of Delayed Ecosystem via Impulsive Differential Inequality and Minimax Principle
Article

Improved Rotor Flux and Torque Control Based on the Third-Order Sliding Mode Scheme Applied to the Asynchronous Generator for the Single-Rotor Wind Turbine

by 1 and 2,3,4,*
1
Faculty of Engineering and Architecture, Department of Electrical & Electronics Engineering, Nisantasi University, Istanbul 34481742, Turkey
2
Faculty of Electronics, Communication and Computers, University of Pitesti, 110040 Pitesti, Romania
3
Doctoral School, Polytechnic University of Bucharest, 313 Splaiul Independentei, 060042 Bucharest, Romania
4
ICSI Energy, National Research and Development Institute for Cryogenic and Isotopic Technologies, 240050 Ramnicu Valcea, Romania
*
Author to whom correspondence should be addressed.
Academic Editors: Francesc Pozo and Amir Mosavi
Mathematics 2021, 9(18), 2297; https://doi.org/10.3390/math9182297
Received: 8 August 2021 / Revised: 30 August 2021 / Accepted: 13 September 2021 / Published: 17 September 2021
In this work, a third-order sliding mode controller-based direct flux and torque control (DFTC-TOSMC) for an asynchronous generator (AG) based single-rotor wind turbine (SRWT) is proposed. The traditional direct flux and torque control (DFTC) technology or direct torque control (DTC) with integral proportional (PI) regulator (DFTC-PI) has been widely used in asynchronous generators in recent years due to its higher efficiency compared with the traditional DFTC switching strategy. At the same time, one of its main disadvantages is the significant ripples of magnetic flux and torque that are produced by the classical PI regulator. In order to solve these drawbacks, this work was designed to improve the strategy by removing these regulators. The designed strategy was based on replacing the PI regulators with a TOSMC method that will have the same inputs as these regulators. The numerical simulation was carried out in MATLAB software, and the results obtained can evaluate the effectiveness of the designed strategy relative to the traditional strategy. View Full-Text
Keywords: asynchronous generator; single-rotor wind turbine; direct flux and torque control (DFTC); third-order sliding mode controller (TOSMC); integral proportional (PI) regulator; DFTC-PI control; DFTC-TOSMC strategy asynchronous generator; single-rotor wind turbine; direct flux and torque control (DFTC); third-order sliding mode controller (TOSMC); integral proportional (PI) regulator; DFTC-PI control; DFTC-TOSMC strategy
Show Figures

Figure 1

MDPI and ACS Style

Benbouhenni, H.; Bizon, N. Improved Rotor Flux and Torque Control Based on the Third-Order Sliding Mode Scheme Applied to the Asynchronous Generator for the Single-Rotor Wind Turbine. Mathematics 2021, 9, 2297. https://doi.org/10.3390/math9182297

AMA Style

Benbouhenni H, Bizon N. Improved Rotor Flux and Torque Control Based on the Third-Order Sliding Mode Scheme Applied to the Asynchronous Generator for the Single-Rotor Wind Turbine. Mathematics. 2021; 9(18):2297. https://doi.org/10.3390/math9182297

Chicago/Turabian Style

Benbouhenni, Habib, and Nicu Bizon. 2021. "Improved Rotor Flux and Torque Control Based on the Third-Order Sliding Mode Scheme Applied to the Asynchronous Generator for the Single-Rotor Wind Turbine" Mathematics 9, no. 18: 2297. https://doi.org/10.3390/math9182297

Find Other Styles
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Article Access Map by Country/Region

1
Back to TopTop