Next Article in Journal
Interaction of Factors Influencing the Sustainability of Water, Sanitation, and Hygiene (WASH) Services in Rural Indonesia: Evidence from Small Surveys of WASH-Related Stakeholders in Indonesia
Next Article in Special Issue
Investigate Impact Force of Dam-Break Flow against Structures by Both 2D and 3D Numerical Simulations
Previous Article in Journal
Assessment of Flood Forecast Products for a Coupled Tributary-Coastal Model
Previous Article in Special Issue
Performance Improvement of a Drag Hydrokinetic Turbine
Article

Impeller Optimization in Crossflow Hydraulic Turbines

1
Department of Engineering, University of Palermo, 90128 Palermo, Italy
2
National School of Engineers of Sfax, University of Sfax, Sfax 3038, Tunisia
*
Author to whom correspondence should be addressed.
Academic Editor: Inmaculada Pulido-Calvo
Water 2021, 13(3), 313; https://doi.org/10.3390/w13030313
Received: 24 November 2020 / Revised: 15 January 2021 / Accepted: 25 January 2021 / Published: 27 January 2021
(This article belongs to the Special Issue Hydraulic Dynamic Calculation and Simulation)
Crossflow turbines represent a valuable choice for energy recovery in aqueducts, due to their constructive simplicity and good efficiency under variable head jump conditions. Several experimental and numerical studies concerning the optimal design of crossflow hydraulic turbines have already been proposed, but all of them assume that structural safety is fully compatible with the sought after geometry. We show first, with reference to a specific study case, that the geometry of the most efficient impeller would lead shortly, using blades with a traditional circular profile made with standard material, to their mechanical failure. A methodology for fully coupled fluid dynamic and mechanical optimization of the blade cross-section is then proposed. The methodology assumes a linear variation of the curvature of the blade external surface, along with an iterative use of two-dimensional (2D) computational fluid dynamic (CFD) and 3D structural finite element method (FEM) simulations. The proposed methodology was applied to the design of a power recovery system (PRS) turbine already installed in an operating water transport network and was finally validated with a fully 3D CFD simulation coupled with a 3D FEM structural analysis of the entire impeller. View Full-Text
Keywords: micro-hydropower; energy recovery; energy harvesting; banki turbine; water distribution network; pressure control micro-hydropower; energy recovery; energy harvesting; banki turbine; water distribution network; pressure control
Show Figures

Figure 1

MDPI and ACS Style

Sinagra, M.; Picone, C.; Aricò, C.; Pantano, A.; Tucciarelli, T.; Hannachi, M.; Driss, Z. Impeller Optimization in Crossflow Hydraulic Turbines. Water 2021, 13, 313. https://doi.org/10.3390/w13030313

AMA Style

Sinagra M, Picone C, Aricò C, Pantano A, Tucciarelli T, Hannachi M, Driss Z. Impeller Optimization in Crossflow Hydraulic Turbines. Water. 2021; 13(3):313. https://doi.org/10.3390/w13030313

Chicago/Turabian Style

Sinagra, Marco, Calogero Picone, Costanza Aricò, Antonio Pantano, Tullio Tucciarelli, Marwa Hannachi, and Zied Driss. 2021. "Impeller Optimization in Crossflow Hydraulic Turbines" Water 13, no. 3: 313. https://doi.org/10.3390/w13030313

Find Other Styles
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Article Access Map by Country/Region

1
Back to TopTop