Connecting with the Past: Filament Development and 3D Printing from Historical Wood Waste

Waste prevention is at the top of the EU Waste Framework directive hierarchy. With this in mind, this article considers the application of novel technologies in the Cultural Heritage Restoration and Conservation field through environmental and circular economy principles. While previous research has explored the use of wood waste for composite materials such as building insulation and concrete additives, the suitability of degraded historical wood waste for filament production and 3D printing has not yet been addressed. This article contributes to this topic by studying the PLA/wood composite, material composed of a polylactic acid (PLA) polymer matrix reinforced with wood particles, produced from degraded historical construction materials. The paper describes the process of producing filament from bio- and moisture-damaged pine beam and oak parquet, followed by the 3D printing of historical platband replica. Research methods include photogrammetry, filament machine construction, filament production and 3D printing. The machines settings used in the process: heater temperatures were set to 140 °C, 90 °C and 105 °C; servo speed was 33 s; spool tension was 12.5; winding speed was 24 RPM; and screw speed was 9.2 RPM. For material preparation, a mixture containing 25% pine and oak sawdust and PLA dust was processed to achieve particle sizes of 312 μm, 471 μm, and 432 μm, respectively. Filament production was carried out with diameters of 2.85 mm for the pine/PLA composite and 1.75 mm for the oak/PLA composite. Finally, replica samples were fabricated using 3D printing. The dual objective of this research was to develop the method of 3D printing from degraded historical materials and introduce it to restoration practice as a wood waste minimization technique. Perspectives for further study include the testing of 3D-printed construction materials in outdoor conditions, and pellet production to achieve a higher wood content, compared to the filament thread. The processes described are adaptable to a variety of materials and disciplines.