Error in Figures
In the original publication [1], there was a mistake in Figures 2 and 3 as published: wrong unit (mm) in the x-axis. The corrected Figure 2 and Figure 3 with the correct unit (µm) in the x-axis appear below.
Figure 2.
Filler size distribution (selection; see Supplementary Materials for overall results) based on one SEM picture with max. 5100 single particles.
Figure 3.
Filler sphericity distribution (1.0 indicates the cross section of the filler is a circle) based on one SEM picture with max. 5100 single particles.
Error in Table
In the top line of Table 4 was a mistake: Incorrect abbreviations 3LUA, CBCA, and SBA. The correct abbreviations in Table 4 are 3LU, CBC, and SB. The correct Table 4 appears below:
Table 4.
Properties of local discontinuities identified by µXCT in CAD/CAM RBCs (HT).
Error in Supplementary Materials
In the original publication, there was a mistake in Tables S1–S3. The presented units of ferret diameter were incorrect and were revised from mm to µm.
The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.
Reference
- Koenig, A.; Schmidtke, J.; Schmohl, L.; Schneider-Feyrer, S.; Rosentritt, M.; Hoelzig, H.; Kloess, G.; Vejjasilpa, K.; Schulz-Siegmund, M.; Fuchs, F.; et al. Characterisation of the Filler Fraction in CAD/CAM Resin-Based Composites. Materials 2021, 14, 1986. [Google Scholar] [CrossRef] [PubMed]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2024 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).