Skip to Content
You are currently on the new version of our website. Access the old version .
MaterialsMaterials
  • Article
  • Open Access

22 February 2022

15 Pages

Stress Calculations of Heat Storage Tanks

and
Laboratory of the Heat Processes Control Systems, Centre of Heat and Power Engineering, Turbine Department, The Szewalski Institute of Fluid-Flow, Machinery Polish Academy of Sciences, Fiszera 14 St., 80-231 Gdansk, Poland
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue Materials in Energy Technology

Abstract

Stress calculations are necessary to determine the feasibility and profitability of a heat storage tank’s construction. The article presented normative methods of stress calculations for a heat storage tank. Results were verified by finite element analysis. These stress calculations enabled us to determine wall and weld thickness. The calculations were made on the example of a tank with a nominal pressure of 10 bar. The work undertook an extensive analysis of the stresses occurring in a pressure tank, described the finite element method and showed examples of ways in which it could be used. During stress analysis, three types of materials were compared: carbon steel St0 (S185), stainless steel (304) and boiler steel (P 265 GH). A brief overview of types of thermal energy storages was also provided.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.