Next Article in Journal
Analysis of Experimental Results Regarding the Selection of Spring Elements in the Front Suspension of a Four-Axle Truck
Previous Article in Journal
Analytical Methods for Causality Evaluation of Photonic Materials
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Article

Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy

1
General Research Institute for Nonferrous Metals, Beijing 100088, China
2
GRIMAT Engineering Institute Co., Ltd., Beijing 101407, China
3
State Key Laboratory of Advanced Materials for Smart Sensing, GRINM Group Co., Ltd., Beijing 100088, China
4
Laboratory of Advanced Materials, School of Materials Science and Engineering, Tsinghua University, Bejing 100084, China
*
Author to whom correspondence should be addressed.
Materials 2022, 15(4), 1537; https://doi.org/10.3390/ma15041537
Submission received: 31 December 2021 / Revised: 10 February 2022 / Accepted: 16 February 2022 / Published: 18 February 2022
(This article belongs to the Topic Metallurgical and Materials Engineering)

Abstract

The influence of alloying element Mg on Na and Sr modifying Al-7Si hypoeutectic alloys was investigated. The residual content of Na and the morphology of modified eutectic silicon were characterized. It was found that the alloying element Mg had an enhanced effect on the uptake of sodium in the Al-7Si hypoeutectic alloy modified by the Na-contained modifier. Moreover, the morphology of eutectic silicon of the modified Al-7Si alloys was significantly different from that of Al-7Si-0.4Mg alloys in the present research. When the addition of the modifier is enough, both modifiers could entirely modify the eutectic silicon phase of Al-7Si alloys, while incompletely modified eutectic silicon was observed in both Na-modified and Sr-modified Al-7Si-0.4Mg alloy. It was observed that there was an adhering relationship between the partially modified eutectic silicon with Mg-rich phases. According to the results, it can be proposed that the addition of Mg will affect the solidification behavior of alloys, thereby, leading to the incomplete modification of eutectic silicon phases.
Keywords: alloying element magnesium; Al-7Si-0.4Mg alloy; Na modification; Sr modification; modification efficiency alloying element magnesium; Al-7Si-0.4Mg alloy; Na modification; Sr modification; modification efficiency

Share and Cite

MDPI and ACS Style

Huang, C.; Liu, Z.; Li, J. Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy. Materials 2022, 15, 1537. https://doi.org/10.3390/ma15041537

AMA Style

Huang C, Liu Z, Li J. Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy. Materials. 2022; 15(4):1537. https://doi.org/10.3390/ma15041537

Chicago/Turabian Style

Huang, Chunfa, Zhiguo Liu, and Jianguo Li. 2022. "Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy" Materials 15, no. 4: 1537. https://doi.org/10.3390/ma15041537

APA Style

Huang, C., Liu, Z., & Li, J. (2022). Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy. Materials, 15(4), 1537. https://doi.org/10.3390/ma15041537

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop