Next Article in Journal
Effect of Compositional and Processing Variations in New 5182-Type AlMgMn Alloys on Mechanical Properties and Deformation Surface Quality
Next Article in Special Issue
n-i-p Nanocrystalline Hydrogenated Silicon Solar Cells with RF-Magnetron Sputtered Absorbers
Previous Article in Journal
CO-Releasing Materials: An Emphasis on Therapeutic Implications, as Release and Subsequent Cytotoxicity Are the Part of Therapy
Previous Article in Special Issue
Enhancing Photovoltaic Performance of Plasmonic Silicon Solar Cells with ITO Nanoparticles Dispersed in SiO2 Anti-Reflective Layer
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Article

Influence of Electrical Traps on the Current Density Degradation of Inverted Perovskite Solar Cells

1
Department of Electrical and Computer Engineering, Inter-University Semiconductor Research Center, Seoul National University, Seoul 08826, Korea
2
Department of Safety Engineering, Seoul National University of Science and Technology, Seoul 01811, Korea
*
Authors to whom correspondence should be addressed.
Materials 2019, 12(10), 1644; https://doi.org/10.3390/ma12101644
Submission received: 26 April 2019 / Revised: 15 May 2019 / Accepted: 15 May 2019 / Published: 20 May 2019
(This article belongs to the Special Issue Materials for Photovoltaic Applications)

Abstract

Premature aging of perovskite solar cells (PSC) is one of the biggest challenges for its commercialization. Particularly, PSCs exhibit rapid degradation of photovoltaic parameters under ambient air exposure. To estimate the degradation mechanism of PSC under air exposure, we systematically analyzed the relationship between electrical traps of the PSC and its degradation. After 240 h of air exposure to the PSC, its power conversion efficiency degraded to 80% compared to its initial value. The loss mainly originated from reduced current density, which is affected by traps and carrier transport in the disordered semiconducting layer. Capacitance–voltage plots of the PSC showed that the ionic doping from the perovskite layer caused an increased number of trap sites at the buffer layer. Moreover, the extrapolation of temperature dependent open circuit voltage graphs indicated that the trap sites lead to poor carrier transport by increasing recombination losses in the aged device. Therefore, trap sites arose from the result of ion migration and caused an early degradation of PSC under air exposure.
Keywords: perovskite solar cells; degradation; impedance; Mott–Schottky plot; temperature analysis perovskite solar cells; degradation; impedance; Mott–Schottky plot; temperature analysis
Graphical Abstract

Share and Cite

MDPI and ACS Style

Lee, H.; Lee, C.; Song, H.-J. Influence of Electrical Traps on the Current Density Degradation of Inverted Perovskite Solar Cells. Materials 2019, 12, 1644. https://doi.org/10.3390/ma12101644

AMA Style

Lee H, Lee C, Song H-J. Influence of Electrical Traps on the Current Density Degradation of Inverted Perovskite Solar Cells. Materials. 2019; 12(10):1644. https://doi.org/10.3390/ma12101644

Chicago/Turabian Style

Lee, Hyunho, Changhee Lee, and Hyung-Jun Song. 2019. "Influence of Electrical Traps on the Current Density Degradation of Inverted Perovskite Solar Cells" Materials 12, no. 10: 1644. https://doi.org/10.3390/ma12101644

APA Style

Lee, H., Lee, C., & Song, H.-J. (2019). Influence of Electrical Traps on the Current Density Degradation of Inverted Perovskite Solar Cells. Materials, 12(10), 1644. https://doi.org/10.3390/ma12101644

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop