Differentiated Data Aggregation Routing Scheme for Energy Conserving and Delay Sensitive Wireless Sensor Networks
School of Information Science and Engineering, Central South University, Changsha 410083, China
School of Informatics, Hunan University of Chinese Medicine, Changsha 410208, China
School of Computer Science and Information Engineering, Zhejiang Gongshang University, Hangzhou 310018, China
The State Key Laboratory of Industrial Control Technology, Zhejiang University, Hangzhou 310027, China
School of Software, Central South University, Changsha 410075, China
Department of Mathematics and Computer Science, Northeastern State University, Tahlequah, OK 74464, USA
State Grid Hunan Electric Power Company Limited Research Institute, Changsha 410007, China
Author to whom correspondence should be addressed.
Received: 9 June 2018 / Revised: 12 July 2018 / Accepted: 17 July 2018 / Published: 19 July 2018
PDF [10049 KB, uploaded 19 July 2018]
Data aggregation is a widely adopted method to effectively reduce the data transmission volume and improve the lifetime of wireless sensor networks (WSNs). In the data aggregation networks, some parameters directly determine the delay of aggregation. In industrial applications, the data generated by different sensors have different requirements for delay or other QoS performance. In the previous study, a common strategy is that all kinds of data is aggregated into one frame when the condition is satisfied with a QoS requirement, which causes excessive energy consumption and severely impairs the lifetime of network. A Differentiated Data Aggregation Routing (DDAR) scheme is proposed to reduce energy consumption and guarantee that the delay could be controlled within the corresponding QoS requirement constraint. The primary contributions of the DDAR scheme are the following: (a) The DDAR scheme makes data with different QoS requirement route to the sink along the different paths. The parameters of the aggregators in each path, such as aggregation deadline (
) and the aggregation threshold (
), are configured according to the QoS requirements. Accordingly, energy consumption can be reduced without degrading the performance of data transmission. (b) Based on DDAR scheme, an improved DDAR scheme is proposed to further improve performance through fully utilize the residual energy in the nodes which are far from the sink. The frequency of aggregation of these nodes increases by reducing the value of
so as to further improve the energy efficiency and reduce delay. Simulation results demonstrate that compared with the previous scheme, this scheme reduces the delay by 25.01%, improves the lifetime by 55.45%, and increases energy efficiency by 83.99%. The improved DDAR scheme improves the energy efficiency by 33.97% and service guarantee rate by 10.11%.
This is an open access article distributed under the Creative Commons Attribution License
which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited (CC BY 4.0).
Share & Cite This Article
MDPI and ACS Style
Li, X.; Liu, W.; Xie, M.; Liu, A.; Zhao, M.; Xiong, N.N.; Zhao, M.; Dai, W. Differentiated Data Aggregation Routing Scheme for Energy Conserving and Delay Sensitive Wireless Sensor Networks. Sensors 2018, 18, 2349.
Li X, Liu W, Xie M, Liu A, Zhao M, Xiong NN, Zhao M, Dai W. Differentiated Data Aggregation Routing Scheme for Energy Conserving and Delay Sensitive Wireless Sensor Networks. Sensors. 2018; 18(7):2349.
Li, Xujing; Liu, Wei; Xie, Mande; Liu, Anfeng; Zhao, Ming; Xiong, Neal N.; Zhao, Miao; Dai, Wan. 2018. "Differentiated Data Aggregation Routing Scheme for Energy Conserving and Delay Sensitive Wireless Sensor Networks." Sensors 18, no. 7: 2349.
Show more citation formats
Show less citations formats
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.
[Return to top]
For more information on the journal statistics, click here
Multiple requests from the same IP address are counted as one view.