Search Results (7)

Glaciers experience periodic variations in flow velocity called surges, each of which influences the glacier’s characteristics and the occurrence of downstream disasters (e.g., ice-dammed lake outburst floods). The Karakoram region contains many surging glaciers, yet there are few comprehensive studies of multiple surge cycles. In this work, Landsat, topographic map, Shuttle Radar Topography Mission (SRTM), TerraSAR-X/TanDEM-X, ITS_LIVE, and Sentinel-1 glacier velocity data were used to systematically analyze the characteristics of Kyagar Glacier since the 1970s. Three surging events were identified, with active phases in 1975–1978, 1995–1997, and 2014–2016. The timing of these surges was similar, with a cycle of 19–20 years, an active phase of 3–4 years, and a quiescent phase of 16–17 years. During the quiescent phase, a large amount of ice accumulates in the lower part of the accumulation zone, and the terminal of the tongue thins significantly. According to the most recent surge event (2014–2016), glacier flow accelerated suddenly in the active phase and reached a maximum velocity of 2 ± 0.08 m d⁻¹. Then, the glacier terminal thickened sharply, the reservoir zone thinned by 12 ± 0.2 m, and the terminal receiving zone thickened by 28 ± 0.2 m. The glacier may have entered a quiescent phase after July 2016. The glacier surge causes a large amount of material to transfer from upstream to downstream, forming an ice dam and creating conditions for a glacial lake outburst flood (GLOF). At the termination of the active phase, the subglacial drainage channel became effective, triggering the GLOF. For a period of the quiescent phase, the glacier ablation intensifies and the GLOF repeats constantly. One surge caused 7–8 GLOFs, and then a continuous reduction in the ice dam elevation. Eventually, the ice dam disappeared, and the GLOF no longer continued before the next glacier-surging event. Full article

Bed topography and roughness play important roles in numerous ice-sheet analyses. Although the coverage of ice-penetrating radar measurements has vastly increased over recent decades, significant data gaps remain in certain areas of subglacial topography and need interpolation. However, the bed topography generated by interpolation such as kriging and mass conservation is generally smooth at small scales, lacking topographic features important for sub-kilometer roughness. DeepBedMap, a deep learning method combined with multiple surface observation inputs, can generate high-resolution (250 m) bed topography with realistic bed roughness but produces some unrealistic artifacts and higher bed elevation values in certain regions, which could bias ice-sheet models. To address these issues, we present MB_DeepBedMap, a multi-branch deep learning method to generate more realistic bed topography. The model improves upon DeepBedMap by separating inputs into two groups using a multi-branch network structure according to their characteristics, rather than fusing all inputs at an early stage, to reduce artifacts in the generated topography caused by earlier fusion of inputs. A direct upsampling branch preserves large-scale subglacial landforms while generating high-resolution bed topography. We use MB_DeepBedMap to generate a high-resolution (250 m) bed elevation grid product of Antarctica, MB_DeepBedMap_DEM, which can be used in high-resolution ice-sheet modeling studies. Moreover, we test the performance of MB_DeepBedMap model in Thwaites Glacier, Gamburtsev Subglacial Mountains, and several other regions, by comparing the qualitative topographic features and quantitative errors of MB_DeepBedMap, BEDMAP2, BedMachine Antarctica, and DeepBedMap. The results show that MB_DeepBedMap can provide more realistic small-scale topographic features and roughness compared to BEDMAP2, BedMachine Antarctica, and DeepBedMap. Full article

This study demonstrates the results of Russian airborne radio-echo sounding (RES) investigations and also seismic reflection soundings carried out in 1971–2020 over a vast area of coastal part of East Antarctica. It is the first comprehensive summary mapping of these data. Field research, equipment, errors of initial RES data, and methods of gridding are discussed. Ice thickness, ice base elevation, and bedrock topography are presented. The ice thickness across the research area varies from a few meters to 3620 m, and is greatest in the local subglacial depressions. The average thickness is about 1220 m. The total volume of the ice is about 710,500 km${}^3$. The bedrock heights vary from 2860 m below sea level in the ocean bathyal zone to 2040 m above sea level in the Grove Mountains area (4900 m relief). The main directions of the bedrock orographic forms are concentrated mostly in three intervals: 345${}^{\circ }$–30${}^{\circ }$, 45${}^{\circ }$–70${}^{\circ }$, and 70${}^{\circ }$–100${}^{\circ }$. The bottom melting rate was estimated on the basis of the simple Zotikov model. Total annual melting under the study area is about 0.633 cubic meters. The total annual melting in the study area is approximately 1.5 mm/yr. Full article

The internal layers of ice sheets from ice-penetrating radar (IPR) investigation preserve critical information about the ice-flow field and englacial conditions. This paper presents a new detailed analysis of spatial distribution characteristics of internal layers and subglacial topography of the East Antarctic ice sheet (EAIS) from Zhongshan Station to Dome A. The radar data of 1244 km along a traverse between Zhongshan Station and Dome A of EAIS were collected during the 29th Chinese National Antarctic Research Expedition (CHINARE 29, 2012/2013). In this study, the Internal Layering Continuity Index (ILCI) and basal roughness were taken as indicators to provide an opportunity to evaluate the past internal environment and dynamics of the ice sheet. Except for the upstream of Lambert Glacier, the fold patterns of internal layers are basically similar to that of the bed topography. The relatively flat basal topography and the decrease of ILCI with increasing depth provide evidence for identifying previous rapid ice flow areas that are unavailable to satellites, especially in the upstream of Lambert Glacier. Continuous internal layers of Dome A, recording the spatial change of past ice accumulation and ice-flow history over 160 ka, almost extend to the bed, with high ILCI and high basal roughness of the corresponding bed topography. There are three kinds of basal roughness patterns along the traverse, that is, “low ξ_t low η”, “low ξ_t high η”, and “high ξ_t high η”, where ξ_t represents the amplitude of the undulations, and quantifies the vertical variation of the bedrock, and η measures the frequency variation of fluctuations and the horizontal irregularity of the profile. The characteristics of internal layers and basal topography of the traverse between Zhongshan Station and Dome A provide new information for understanding the ancient ice-flow activity and the historical evolution of EAIS. Full article

Alpine glaciers are key components of local and regional hydrogeological cycles and real-time indicators of climate change. Volume variations are primary targets of investigation for the understanding of ongoing modifications and the forecast of possible future scenarios. These fluctuations can be traced from time-lapse monitoring of the glacier topography. A detailed reconstruction of the ice bottom morphology is however needed to provide total volume and reliable mass balance estimations. Non-destructive geophysical techniques can support these investigations. With the aim of characterizing ice bottom depth, ground-penetrating radar (GPR) profiles and single-station passive seismic measurements were acquired on the terminal lobes of Belvedere Glacier (NW Italian Alps). The glacier is covered by blocks and debris and its rough topography is rapidly evolving in last years, with opening and relocation of crevasses and diffuse instabilities in the frontal sectors. Despite the challenging working environment, ground-based GPR surveys were performed in the period 2016–2018, using 70-MHz and 40-MHz antennas. The 3D ice bottom morphology was reconstructed for both frontal lobes and a detailed ice thickness map was obtained. GPR results also suggested some information on ice bottom properties. The glacier was found to probably lay on a thick sequence (more than 40 m) of subglacial deposits, rather than on stiff bedrock. Week deeper reflectors were identified only in the frontal portion of the northern lobe. These interfaces may indicate the bedrock presence at a depth of around 80 m from the topographic surface, rapidly deepening upstream. Single-station passive seismic measurements, processed with the horizontal-to-vertical spectral ratio (HVSR) method, pointed out the absence of sharp vertical contrast in acoustic impedance between ice and bottom materials, globally confirming the hypotheses made on GPR results. The obtained results have been compared with previous independent geophysical investigations, performed in 1961 and 1985, with the same aim of ice thickness estimation. The comparison allowed us to validate the results obtained in the different surveys, supply a reference base map for the glacier bottom morphology and potentially study ice thickness variations over time. Full article

The poles constitute 14% of the Earth’s biosphere: The aquatic Arctic surrounded by land in the north, and the frozen Antarctic continent surrounded by the Southern Ocean. In spite of an extremely cold climate in addition to varied topographies, the polar aquatic regions are teeming with microbial life. Even in sub-glacial regions, cellular life has adapted to these extreme environments where perhaps there are traces of early microbes on Earth. As grazing by macrofauna is limited in most of these polar regions, viruses are being recognized for their role as important agents of mortality, thereby influencing the biogeochemical cycling of nutrients that, in turn, impact community dynamics at seasonal and spatial scales. Here, we review the viral diversity in aquatic polar regions that has been discovered in the last decade, most of which has been revealed by advances in genomics-enabled technologies, and we reflect on the vast extent of the still-to-be explored polar microbial diversity and its “enigmatic virosphere”. Full article

Surge-type glaciers are characterised by relatively short phases of enhanced ice transport and mass redistribution after a comparatively long quiescent phase when the glacier is virtually inactive. This unstable behaviour makes it difficult to assess the influence of climate change on those glaciers. We describe the evolution of the most recent surge of Bivachny Glacier in the Pamir Mountains, Tajikistan between 2011 and 2015 with respect to changes in its topography and dynamics. For the relevant time span, nine digital elevation models were derived from TanDEM-X data; optical satellite data (Landsat 5, 7 and 8, EO-1) as well as synthetic aperture radar data (TerraSAR-X and TanDEM-X) were used to analyse ice flow velocities. The comparison of the topography at the beginning of the surge with the one observed by the Shuttle Radar Topography Mission in 2000 revealed a thickening in the upper part of the ablation area of the glacier and a thinning further down the glacier as is typically observed during the quiescent phase. During the active phase, a surge bulge measuring up to around 80 m developed and travelled downstream for a distance of 13 km with a mean velocity of 4400 m year⁻¹. Ice flow velocities increased from below 90 m year⁻¹ duringthe quiescent phase in 2000 to up to 3400 m year⁻¹ in spring 2014. After reaching the confluence with Fedchenko Glacier, the surge slowed down until it completely terminated in 2015. The observed seasonality of the glacier velocities with a regular speed-up during the onset of the melt period suggests a hydrological control of the surge related to the effectiveness of the subglacial drainage system. Full article