Search Results (3)

Following the Aerosol Robotic Network-Ocean Color (AERONET-OC) network scheme and instrument deployment protocols, two fixed platforms (Muping and Dong’ou) in the Yellow Sea and East China Sea were implemented with the support of the China National Satellite Ocean Application Service. Optical radiometry instruments were established at the two sites to autonomously determine remote sensing reflectance (R_rs) and aerosol optical depth (AOD). Details about location selection, platform design, instrument deployment, and the associated data processing procedure are reported in this study. R_rs and AOD measured by independent instruments at the Muping site were compared and results showed that they were consistent, with a median relative percentage difference (MRPD) < 0.6% for AOD and <10% for R_rs. The spectral feature and temporal pattern of R_rs and AOD at the two sites were examined and compared with data from 14 AERONET-OC sites. R_rs and AOD data measured at the two sites were used to evaluate ocean color operational products of MODIS/Aqua (MODISA), OLCI/Sentinel-3A (OLCI-3A), and OLCI/Sentinel-3B (OLCI-3B). Comparison showed that the three satellite sensor-derived R_rs agreed well with in situ measurements, with an MRPD < 25% for MODISA, <30% for OLCI-3A, and <40% for OLCI-3B, respectively. Large uncertainties were observed in the blue bands for the three satellite sensors, particularly for OLCI-3B at 400 nm. AOD at 865 nm derived from the three satellite sensors also agreed well with in situ measurements, with an MRPD of 28.1% for MODISA, 30.6% for OLCI-3A, and 39.9% for OLCI-3B. Two commonly used atmospheric correction (AC) processors, the ACOLITE and SeaDAS, were also evaluated using in situ measurements at two sites and 20 m-resolution MSI/Sentinel-2A data. Close agreements were achieved for both AC processors, while the SeaDAS performed slightly better than ACOLITE. The optimal band selection in the AC models embedded in two AC processors was a combination of one near-infrared and one short-wave infrared band such as 865 and 1609 nm, shedding light on MSI data applications in the aquatic environment. Full article

The hardware and software capabilities of the compact-profiling hybrid instrumentation for radiometry and ecology (C-PHIRE) instruments on an unmanned surface vessel (USV) are evaluated. Both the radiometers and USV are commercial-off-the-shelf (COTS) products, with the latter being only minimally modified to deploy the C-PHIRE instruments. The hybridspectral C-PHIRE instruments consist of an array of 18 multispectral microradiometers with 10 nm wavebands spanning 320–875 nm plus a hyperspectral compact grating spectrometer (CGS) with 2048 pixels spanning 190–1000 nm. The C-PHIRE data were acquired and processed using two architecturally linked software packages, thereby allowing lessons learned in one to be applied to the other. Using standard data products and unbiased statistics, the C-PHIRE data were validated with those from the well-established compact-optical profiling system (C-OPS) and verified with the marine optical buoy (MOBY). Agreement between algorithm variables used to estimate colored dissolved organic matter (CDOM) absorption and chlorophyll a concentration were also validated. Developing and operating novel technologies, such as the C-PHIRE series of instruments, deployed on a USV increase the frequency and coverage of optical observations, which are required to fully support the present and next-generation validation exercises in radiometric remote sensing of aquatic ecosystems. Full article

Spatial resolution is the main instrumental requirement for the multi-spectral optical space missions that address the scientific issues of marine coastal systems. This spatial resolution should be at least decametric. Aquatic color data processing associated with these environments requires specific atmospheric corrections (AC) suitable for the spectral characteristics of high spatial resolution sensors (HRS) as well as the high range of atmospheric and marine optical properties. The objective of the present study is to develop and demonstrate the potential of a ground-based AC approach adaptable to any HRS for regional monitoring and security of littoral systems. The in Situ-based Atmospheric CORrection (SACOR) algorithm is based on simulations provided by a Successive Order of Scattering code (SOS), which is constrained by a simple regional aerosol particle model (RAM). This RAM is defined from the mixture of a standard tropospheric and maritime aerosol type. The RAM is derived from the following two processes. The first process involved the analysis of a 6-year data set composed of aerosol optical and microphysical properties acquired through the ground-based PHOTONS/AERONET network located at Arcachon (France). The second process was related to aerosol climatology using the NOAA hybrid single-particle Lagrangian integrated trajectory (HYSPLIT) model. Results show that aerosols have a bimodal particle size distribution regardless of the season and are mainly represented by a mixed coastal continental type. Furthermore, the results indicate that aerosols originate from both the Atlantic Ocean (53.6%) and Continental Europe (46.4%). Based on these results, absorbing biomass burning, urban-industrial and desert dust particles have not been considered although they represent on average 19% of the occurrences. This represents the main current limitation of the RAM. An assessment of the performances of SACOR is then performed by inter-comparing the water-leaving reflectance ( ${\rho }_w$ ) retrievals with three different AC methods (ACOLITE, MACCS and 6SV using three different standard aerosol types) using match-ups (N = 8) composed of Landsat-8/Operational Land Imager (OLI) scenes and field radiometric measurements. Results indicate consistency with the SWIR-based ACOLITE method, which shows the best performance, except in the green channel where SACOR matches well with the in-situ data (relative error of 7%). In conclusion, the study demonstrates the high potential of the SACOR approach for the retrieval of ${\rho }_w$ . In the future, the method could be improved by using an adaptive aerosol model, which may select the most relevant local aerosol model following the origin of the atmospheric air mass, and could be applied to the latest HRS (Sentinel-2/MSI, SPOT6-7, Pleiades 1A-1B). Full article