Search Results (24)

Based on the field data of laser interference devices obtained on the shelf of the Sea of Japan, the interaction of internal sea waves with the bottom and the transfer of energy from the sea wave to the seismic acoustic wave were studied. It has been established that when internal waves move from the depth dump to the surf zone, they transform, and their period decreases. When the energy of the internal wave is transformed into elastic bottom vibrations, the flow density is estimated to spread evenly over a shelf about 30 km wide. Taking into account the maximum amplitudes of elastic bottom vibrations caused by offshore internal waves, the density of the seismic energy flux will increase by 2–3 orders of magnitude and will be comparable to the density of the seismic energy flux caused by surface sea waves. Full article

We establish a spherically symmetric model of solar atmosphere, which consists of the whole chromosphere and low corona below the $1.25$ solar radius. It is a hydrodynamic model with heating in the chromosphere through an artificial energy flux. We performed a series of simulations with our model and found oscillations with a peak frequency of ∼4 $\mathrm{mHz}$ in the power spectrum. We confirmed that this resulted from the p-mode excited in the transition region and amplified in a resonant cavity situated in the height range ∼$4\times {10}^3$–$2\times {10}^4$ km. This result is consistent with global observations of Alfvénic waves in corona and can naturally explain the observational ubiquity of $4\mathrm{mHz}$ without the difficulty of the p-mode passing through the acoustic-damping chromosphere. We also confirmed that acoustic shock waves alone cannot heat the corona to the observed temperature, and found mass upflows in the height range ∼$7\times {10}^3$–$7\times {10}^4$ km in our model, which pumped the dense and cool plasma into the corona and might be the mass supplier for solar prominences. Full article

We use high-resolution coupled atmosphere–ocean model simulations over the Gulf Stream extension region during a winter season to examine the upper ocean thermodynamic response to including current feedback to atmospheric wind stress. We demonstrate that a model that includes current feedback leads to significant changes in the structure and transport of heat throughout the upper ocean in comparison to the same model without current feedback. We find that including the current feedback leads to changes in the upper ocean temperature pattern that match the vorticity pattern. Areas with cyclonic ocean vorticity, typically north of the Gulf Stream extension, correspond to areas with warmer temperatures throughout the water column. Areas with anticyclonic ocean vorticity, typically south of the Gulf Stream extension, correspond to areas with cooler temperatures throughout the water column. We also find that including current feedback leads to an overall reduction in the submesoscale vertical heat flux spectra across all spatial scales, with differences in the submesoscale vertical heat flux corresponding to SST minus mixed layer temperature differences. The direct impact of current feedback on the thermodynamic structure within the upper ocean also has indirect impacts on other aspects of the ocean, such as the energy transfer between the ocean and the atmosphere, ocean stratification, and acoustic parameters. Full article

Technologies associated with using concentrated energy flows are increasingly used in industry due to the need to manufacture products made of hard alloys and other difficult-to-process materials. This work is devoted to expanding knowledge about the processes accompanying the impact of laser pulses on material surfaces. The features of these processes are reflected in the acoustic emission signals, the parameters of which were used as a tool for understanding the accompanying phenomena. The influence of plasma formations above the material surface on self-oscillatory phenomena and the self-regulation process that affects pulse productivity were examined. The stability of plasma formation over time, its influence on the pulse performance, and changes in the heat flux power density were considered. Experimental data show the change in the power density transmitted by laser pulses to the surface when the focal plane is shifted. Experiments on the impact of laser pulses of different powers and durations on the surface of a hard alloy showed a relationship between the amplitude of acoustic emission and the pulse performance. This work shows the data content of acoustic emission signals and the possibility of expanding the research of concentrated energy flow technologies. Full article

Sonic layer depth (SLD) is crucial in ocean acoustics research and profoundly influences sound propagation and Sonar detection. Carrying 90% of oceanic kinetic energy, mesoscale eddies significantly impact the propagation of acoustic energy in the ocean. Recent studies classified mesoscale eddies into normal eddies (warm anticyclonic and cold cyclonic eddies) and abnormal eddies (cold anticyclonic and warm cyclonic eddies). However, the influence of mesoscale eddies, especially abnormal eddies, on SLD remains unclear. Based on satellite altimeter and reanalysis data, we explored the influence of mesoscale eddies on seasonal variations in SLD in the South China Sea. We found that the vertical structures of temperature anomalies within the eddies had a significant impact on the sound speed field. A positive correlation between sonic layer depth anomaly (SLDA) and eddy intensity (absolute value of relative vorticity) was investigated. The SLDA showed significant seasonal variations: during summer (winter), the proportion of negative (positive) SLDA increased. Normal eddies (abnormal eddies) had a more pronounced effect during summer and autumn (spring and winter). Based on mixed-layer heat budget analysis, it was found that the seasonal variation in SLD was primarily induced by air–sea heat fluxes. However, for abnormal eddies, the horizontal advection and vertical convective terms modulated the variations in the SLDA. This study provides additional theoretical support for mesoscale eddy–acoustic coupling models and advances our understanding of the impact of mesoscale eddies on sound propagation. Full article

The unconsolidated near surface and large, daily temperature variations in the desert environment degrade the vertical seismic profiling (VSP) data, posing the need for rigorous quality control. Distributed acoustic sensing (DAS) VSP data are often benchmarked using geophone surveys as a gold standard. This study showcases a new simulation-based way to assess the quality of DAS VSP acquired in the desert without geophone data. The depth uncertainty of the DAS channels in the wellbore is assessed by calibrating against formation depth based on the concept of conservation of the energy flux. Using the 1D velocity model derived from checkshot data, we simulate both DAS and geophone VSP data via an elastic pseudo-spectral finite difference method, and estimate the source and receiver signatures using matching filters. These field geophone data show high amplitude variations between channels that cannot be replicated in the simulation. In contrast, the DAS simulation shows a high visual similarity with the field DAS first arrival waveforms. The simulated source and receiver signatures are visually indistinguishable from the field DAS data in this study. Since under perfect conditions, the receiver signatures should be invariant with depth, we propose a new DAS data quality control metric based on local variations of the receiver signatures which does not require geophone measurements. Full article

Persistent low-frequency (<180 Hz) acoustic detection took place within the boundaries of Oak Ridge National Laboratory to monitor full power operations of the High Flux Isotope Reactor. Three acoustic sensors were installed at distances of 69, 101, and 914 m from the northeast corner of the cooling towers to monitor and assess four reactor power generation cycles. Features were extracted from power spectral density calculations where data were collected during reactor on and off operations. Diverse spectral features were present during full reactor power, including a 21.4 Hz fundamental frequency and ascending harmonics. Using bandpass filters, these related frequencies were isolated and summed, and the root mean square energy was calculated. The method of isolating and summing characteristic features provided a significant improvement in identifying acoustic behavior related to reactor power when the raw signals were obscured by noise. Full article

In this study formal derivation of mode coupling equations in underwater acoustics is revisited. This derivation is based on the method of multiple scales from which modal expansion of the field emerges, and the vectorized WKBJ equation for the coefficients in this expansion are obtained in an automatic way. Asymptotic analysis accomplished in this work also establishes a connection between coupled mode parabolic equations in three-dimensional case and the generalized WKBJ solution that emerges as its two-dimensional counterpart. Despite the fact that similar mode coupling equations can be found in literature, in our study a new systematic and formalized approach to their derivation is proposed. A theorem that guarantees asymptotic conservation of the energy flux in the considered two-dimensional waveguide is also proven. Full article

The behaviour of the steel bar in concrete under cyclic loading has been evaluated using magnetic flux leakage associated with acoustic emission monitoring technique. Visual observation was used to observe the deformation of the beam under cyclic loading. The sensors of metal magnetic memory were scanned in the middle of the beam at a distance of 320 mm at the bottom part. Twenty-two cyclic ranges were performed for cyclic loading of 100 or 200 cycles for each range, with a frequency of 1 Hz and a sinusoidal wave mode. The magnetic flux leakage signal, acoustic emission characteristics and crack width were measured and analysed to evaluate the behaviour of the steel bar in the concrete beam. The magnetic flux leakage signal and acoustic emission energy results were well matched with the occurrence of cracks at the centre of the beam. It was found that the relationship between the magnetic leakage flux signal and crack opening showed a strong correlation with R² of 0.969. A high acoustic emission energy of 1300 nVs is observed at the centre of the beam. Based on the results, the behaviour of the steel in the concrete beam can be determined by the integrity assessment of a structure. Full article

The transportation of oil and gas through pipelines is an integral aspect of the global energy infrastructure. It is crucial to ensure the safety and integrity of these pipelines, and one way to do so is by utilizing an inspection tool called a smart pig. This paper reviews various smart pigs used in steel oil and gas pipelines and classifies them according to pipeline structure, anomaly-detection capability, working principles, and application areas. The advantages and limitations of each sensor technology that can be used with the smart pig for in-line inspection (ILI) are discussed. In this context, ultrasonic testing (UT), electromagnetic acoustic transducer (EMAT), eddy current (EC), magnetic flux leakage (MFL), and mechanical contact (MC) sensors are investigated. This paper also provides a comprehensive analysis of the development chronology of these sensors in the literature. Additionally, combinations of relevant sensor technologies are compared for their accuracy in sizing anomaly depth, length, and width. In addition to their importance in maintaining the safety and reliability of pipelines, the use of ILI can also have environmental benefits. This study aims to further our understanding of the relationship between ILI and the environment. Full article

Series solutions are used to explore the mode conversion of slow, Alfvén and fast magnetohydrodynamic waves injected at the base of a two-isothermal-layer stratified atmosphere with a uniform magnetic field, crudely representing the solar chromosphere and corona with intervening discontinuous transition region. This sets a baseline for understanding the ubiquitous Alfvénic waves observed in the corona, which are implicated in coronal heating and solar wind acceleration. It is found that all three injected wave types can partially transmit as coronal Alfvén waves in varying proportions dependent on frequency, magnetic field inclination, wave orientation, and distance between the Alfvén/acoustic equipartition level and the transition region. However, net Alfvénic transmission is limited for plausible parameters, and additional magnetic field structuring may be required to provide sufficient wave energy flux. Full article

The potential beneficial regenerative and stimulatory extracorporeal shock wave therapy (ESWT) applications to the central nervous system have garnered interest in recent years. Treatment zones for these indications are acoustically shielded by bones, which heavily impact generated sound fields. We present the results of high-resolution tissue-realistic simulations, comparing the viability of different ESWT applicators in their use for transcranial applications. The performances of electrohydraulic, electromagnetic, and piezoelectric transducers for key reflector geometries are compared. Based on density information obtained from CT imaging of the head, we utilized the non-linear wave propagation toolset Matlab k-Wave to obtain spatial therapeutic sound field geometries and waveforms. In order to understand the reliability of results on the appropriate modeling of the skull, three different bone attenuation models were compared. We find that all currently clinically ESWT applicator technologies show significant retention of peak pressures and energies past the bone barrier. Electromagnetic transducers maintain a significantly higher energy flux density compared to other technologies while low focusing strength piezoelectric applicators have the weakest transmissions. Attenuation estimates provide insights into sound field degradation and energy losses, indicating that effective transcranial therapies can readily be attained with current applicators. Furthermore, the presented approach will allow for future targeted in silico development and the design of applicators and therapy plans to ultimately improve therapeutic outcomes. Full article

In a laboratory, a model of a mid-channel bar is built to study the turbulent flow structures in its vicinity. The present study on the turbulent flow structure around a mid-channel bar is based on unravelling the fluvial fluxes triggered by the bar’s 3D turbulent burst phenomenon. To this end, the three-dimensional velocity components are measured with the help of acoustic doppler velocimetry (ADV). The results indicate that the transverse component of turbulent kinetic energy cannot be neglected when analyzing turbulent burst processes, since the dominant flow is three-dimensional around the mid-channel bar. Due to the three-dimensionality of flow, the octant events approach is used for analyzing the flow in the vicinity of the mid-channel bar. The aim is to develop functional relationships between the stable movements that are modelled in the present study. To find the best Markov chain order to present experimental datasets, the zero-, first-, and second-order Markov chains are analyzed using the Akaike information criterion (AIC) and the Bayesian information criterion (BIC). The parameter transition ratio has evolved in this research to reflect the linkage of streambed elevation changes with stable transitional movements. For a better understanding of the temporal behaviors of stable transitional movements, the residence time vs. frequency graphs are also plotted for scouring as well as for depositional regions. The study outcome herein underlines the usefulness of the octant events approach for characterizing turbulent bursts around mid-channel bar formation, which is a precursor to the initiation of braiding configuration. Full article

Arthritis is a degenerative disease that primarily affects the cartilage and meniscus of the knee joint. External acoustic stimulation is used to treat this disease. This article presents a numerical model of the knee joint aimed at the computer-aided study of the regenerative effects of shockwave treatment. The presented model was verified and validated. A numerical analysis of the conditions for the regeneration of the tissues of the knee joint under shockwave action was conducted. The results allow us to conclude that to obtain the conditions required for the regeneration of cartilage tissues and meniscus (compressive stresses above the threshold value of 0.15 MPa to start the process of chondrogenesis; distortional strains above the threshold value of 0.05% characterized by the beginning of the differentiation of the tissues in large volumes; fluid pressure corresponding to the optimal level of 68 kPa to transfer tissue cells in large volumes), the energy flux density of therapeutic shockwave loading should exceed 0.3 mJ/mm². Full article

The diurnal hourly dynamics of the kinetic energy flux density vector, called the Umov vector, and the mean and turbulent components of the kinetic energy are estimated from minisodar measurements of wind vector components and their variances in the lower 200 m layer of the atmosphere. During a 24 h period of continuous minisodar observations, it was established that the mean kinetic energy density dominated in the surface atmospheric layer at altitudes below ~50 m. At altitudes from 50 to 100 m, the relative contributions of the mean and turbulent wind kinetic energy densities depended on the time of the day and the sounding altitude. At altitudes below 100 m, the contribution of the turbulent kinetic energy component is small, and the ratio of the turbulent to mean wind kinetic energy components was in the range 0.01–10. At altitudes above 100 m, the turbulent kinetic energy density sharply increased, and the ratio reached its maximum equal to 100–1000 at altitudes of 150–200 m. A particular importance of the direction and magnitude of the wind effect, that is, of the direction and magnitude of the Umov vector at different altitudes was established. The diurnal behavior of the Umov vector depended both on the time of the day and the sounding altitude. Three layers were clearly distinguished: a near-surface layer at altitudes of 5–15 m, an intermediate layer at altitudes from 15 m to 150 m, and the layer of enhanced turbulence above. The feasibility is illustrated of detecting times and altitudes of maximal and minimal wing kinetic energy flux densities, that is, time periods and altitude ranges most and least favorable for flights of unmanned aerial vehicles. The proposed novel method of determining the spatiotemporal dynamics of the Umov vector from minisodar measurements can also be used to estimate the effect of wind on high-rise buildings and the energy potential of wind turbines. Full article