Next Article in Journal
Influence of Physicochemical Properties and Parent Material on Chromium Fractionation in Soils
Next Article in Special Issue
Model-Based Prediction of Perceived Light Flashing in Recirculated Inclined Wavy-Bottomed Photobioreactors
Previous Article in Journal
Anti-Inflammatory Effects of Abeliophyllum distichum Nakai (Cultivar Okhwang 1) Callus through Inhibition of PI3K/Akt, NF-κB, and MAPK Signaling Pathways in Lipopolysaccharide-Induced Macrophages
Previous Article in Special Issue
In Situ Bio-Methanation Modelling of a Randomly Packed Gas Stirred Tank Reactor (GSTR)
 
 
Article
Peer-Review Record

Modelling and Multi-Objective Optimization of the Sulphur Dioxide Oxidation Process

Processes 2021, 9(6), 1072; https://doi.org/10.3390/pr9061072
by Mohammad Reza Zaker, Clémence Fauteux-Lefebvre and Jules Thibault *
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Processes 2021, 9(6), 1072; https://doi.org/10.3390/pr9061072
Submission received: 29 May 2021 / Revised: 16 June 2021 / Accepted: 18 June 2021 / Published: 20 June 2021
(This article belongs to the Special Issue Modelling and Optimization of Chemical Reactors)

Round 1

Reviewer 1 Report

The article discloses about optimization of  a chemical reactor for a multi-step reaction. The method used for developing the research work is OK. The article is well-writing but some referecences are not appropriately indexed along the article.

Author Response

Please see the attachment

Author Response File: Author Response.docx

Reviewer 2 Report

1) During H2SO4 synthesis, is there a step that produces H2S2O7 (disulfuric acid/ oleum)? Can you add this information to the intro if appropriate?

2) Kinetics of Reaction:

  1. a) Line 121-129 Can you elaborate more (in a sentence or two) why the second approach was favored over the other? Although the reader can infer why from the paragraph, I think it is good to state it.

3) Line 147 and 150 = where is the reference?

I think you have to check your references for this data/ information.

4) Why did you choose 400 Celsius as the constant temperature for pressure variation studies?

5) Line 198: SO2 – correct the subscript.

6) Figure 9: can you increase the quality/ resolution of this figure?

Author Response

Please see the attachment

Author Response File: Author Response.docx

Back to TopTop