1. Introduction
In many areas of research, fitting an appropriate model to capture the dependence in real data is a major issue. A copula helps in capturing the strength of the dependence between random variables, and is a joint cumulative distribution function introduced in Sklar [
1]. As defined in Nelsen [
2], a bivariate copula is defined as a function
for which the following holds:
For all , and
For all
, such that
and
; then,
Sklar’s Theorem popularized the use of copulas in modeling dependence in various fields of research. It states that, if
is the joint distribution of random variables
U and
V with marginal distributions of
and
, respectively, then there exists a copula
, such that
There are several families of copulas (see Nelsen [
2]) that can be used to describe different types of dependencies between random variables. Lower-tail dependence is captured by the Clayton copula, whereas the Joe copula captures upper-tail dependence. Independence is captured by the product copula. In recent years, numerous authors have developed copula models to enhance and understand dependence modeling. For instance, Durante [
3], Longla et al. [
4], and Longla [
5] discussed copulas that are obtained by the perturbation of copulas. Longla et al. [
6] studied the impact of perturbations on different mixing structures. Longla [
7] proposed a copula with specific
mixing properties.
Several approaches have been used by various authors to address the estimation of copula parameters, including parametric estimation, semi-parametric estimation, and non-parametric estimation methods. Genest and Rivest [
8] estimated the parameters of Archimedean copulas using the Method of Moments, based on Kendall’s Tau. Genest et al. [
9] constructed a semiparametric estimation method called maximum pseudo-likelihood, which is fully efficient at independence. Joe [
10] and Joe [
11] described a two-step estimation method known as the Inference Function of Margins (IFM) method. Ota and Kimura [
12] proposed an algorithm for estimating the parameters of the FGM copula. Huang [
13] computed the maximum likelihood estimator of model parameters using the EM algorithm.
Copula-based models have been employed in the literature to model dependence in time series data. Pioneered by Darsow et al. [
14], copula-based Markov chains have since become a topic of interest for researchers. For a first-order Markov process, the probability of a future event only depends on the present state and not on the past; that is,
For a stationary copula-based Markov chain
with
as marginal distribution, a bivariate copula
gives the joint distribution of
, i.e.,
. The transition densities for a stationary copula-based Markov chain are given by
where
c is the copula density and
is the marginal density of
. Darsow et al. [
14] showed that the Chapman–Kolmogorov Equation (see Norris [
15]) is related to the fold product (see Theorem 3.2 in Darsow et al. [
14]). The
n-fold product of
, defined by Darsow et al. [
14], denoted as
, is defined by
where
and
is the derivative of
C with respect to the
ith variable. In a stationary Markov chain
, as generated by the copula
and the Uniform (0, 1) marginals; the
n-fold product of the copula given in (
1) is the joint distribution of
.
Interest in statistical inference for Markov chains has peaked in recent decades. Some notable works include those by Gani [
16], Billingsley [
17], and Anderson and Goodman [
18]. Gani [
16] studied the Central Limit Theorem of consistent Maximum Likelihood Estimator of the parameter
of a simple ergodic Markov chain with transition probabilities,
, where
is unknown. Billingsley [
17] studied the multivariate asymptotic normality of the consistent maximum likelihood estimators of the parameters
of the Markov chain. Anderson and Goodman [
18] focused on the asymptotic distribution of the maximum likelihood estimates obtained for the transition probabilities of a Markov chain of arbitrary order.
Two of the most commonly used “scale invariant” measures of association are Spearman’s rho and Kendall’s tau. They both measure the rank correlation or concordance between the variables. As discussed by Nelsen [
2], the population version of Kendall’s tau is defined as follows. Let
and
be independent and identically distributed random variables, each with a joint distribution,
. Then, the population version of Kendall’s tau is given by
. If
is the copula for the continuous random variables
X and
Y, and if
and
are the common margins, then, by using probability transformation
and
, we get
. If the copulas are absolutely continuous, then
As discussed by Genest et al. [
19], due to the easy availability of the sample version of Kendall’s tau,
, it is often used to estimate model parameters. If the mapping of the parameter and the population version of
is invertible and differentiable, then a consistent estimator can be obtained along with the asymptotic normality, exploiting the fact that
is an unbiased U-statistic and asymptotically normal. Daniel and Kendall [
20] and Hoeffding [
21] discussed the expression and asymptotic properties of
. Estimations using
can be found in Sen [
22], where regression parameters,
, were estimated based on Kendall’s tau. Genest et al. [
19] obtained estimators based on inversion of multivariate versions of Kendall’s tau; Kojadinovic and Yan [
23] estimated the dependence parameters in copula models using the methods-of-moment based on the inversion of Kendall’s tau and Spearman’s rho, and the references therein.
Spearman’s rho is the other measure of association which also uses the concept of concordance and discordance. This measure was discussed by Nelsen [
2], Joe [
11], and many more researchers. Spearman envisioned it as an extension of Pearson’s product—moment correlation in Spearman [
24]. While Pearson’s correlation analyzes linear relationships, Spearman’s correlation analyzes monotonic relationships, whether they are linear or not. The Spearman correlation between two variables is equivalent to the Pearson correlation between the rank values of those two variables. As discussed by Nelsen [
2], the population version of this measure is defined in terms of three independent random vectors
,
and
with a common joint distribution,
, and margins,
and
, and is given by
. If
X and
Y are continuous random variables, and if
C is their copula, then
, which further reduces to
Borkowf [
25], Pearson [
26], and Moran [
27] discussed the asymptotic properties of the point estimate of Spearman’s rho. Spearman’s rho has also been used in the literature as a nonparametric statistic. Most often, the sample version of Spearman’s rho does not exist in a closed form; thus, it is not as widely used as Kendall’s tau. See Nelsen [
2], Cherubini et al. [
28], and Joe [
11] to obtain a better understanding of the use of Spearman’s rho in copula-based models.
Although both of the aforementioned measures of associations are measures of concordance, they possess unique characteristics and are fundamentally different. Details on their relations and applications can be found in the work by Nelsen [
2]. Joe [
29] defined the multivariate form of concordance by using survival functions and ordering the multivariate distribution functions. Longla et al. [
6] studied the effect of the perturbation of copulas on the measures discussed above. In this work, we establish a relationship between Spearman’s rho, Kendall’s tau, and the parameters of our copula.
This work aims to compare the performance of some estimation methods on parameters of copula-based Markov chain models developed by Longla [
5]. The main objective of our work is to show the efficiency of the estimation method—Estimation using Eigen Functions—compared to that of already existing estimation methods. For our copula model, regular maximum likelihood estimation theory sometimes fails. The robust estimation introduced by Longla and Peligrad [
30], also used in this paper, can be seen to be performing badly compared to our estimator. We provide Central Limit Theorems for the obtained estimators and construct confidence intervals. We provide a chi-square test using the information from the maximum likelihood estimation process to test the assumption of independence in data based on these copulas. Finally, we discuss the measures of association for these copulas, and deduce an expression for the estimators of the measures. The work is validated by simulations performed in R.
Structure of Paper
In
Section 2, we introduce the copula of interest and explain its properties. In
Section 3, we discuss the three methods of parameter estimation used in this work: Estimation using Eigen functions (EEF), maximum likelihood estimation (MLE), and robust estimation (RE). Furthermore, we discuss the Central Limit Theorems or the asymptotic normality of the estimators and construct confidence regions/intervals for the model parameters. This section also contains the results for tests of independence. We also discuss the measures of association and their estimators.
Section 4 discusses the examples of one-parameter and two-parameter perturbations which are specific cases for our copula of interest. A simulation study showcases the validity of our results. The
Appendix A consists of the proofs of all Theorems and Corollaries.