Correction: Akat et al. Quantitative Evaluation of Marginal and Internal Fit of CAD/CAM Ceramic Crown Restorations Obtained by Model Scanner, Intraoral Scanner, and Different CBCT Scans. Appl. Sci. 2025, 15, 8017

In the original publication [1], there was a mistake in Figures 1 and 2 as published. Figure 1 and Figure 2 have been re-created by the authors based on the methodology and measurement scheme presented in their previous publication [26], using new primary data generated for the current study.

Accordingly, the following text corrections have been made to the original publication. A correction has been made to Section 2.1, Paragraph 1:

In the sagittal section, the space between the crown and the prepared tooth was measured from nine different points (A1, A2…A9), starting from the buccal surface (Figure 1). In the coronal section, the space between the crown and the prepared tooth was measured from nine different points (B1, B2…B9), starting from the mesial surface (Figure 2). For the measurement points, the points from the study by Oğuz et al. were used as a basis [26].

With the addition of reference [26], the order of the subsequent references was updated accordingly.

26.

Oğuz, E.I.; Kılıçarslan, M.A.; Ocak, M.; Bilecenoğlu, B.; Ekici, Z. Marginal and internal fit of feldspathic ceramic CAD/CAM crowns fabricated via different extraoral digitization methods: A micro-computed tomography analysis. Odontology 2021, 109, 440–447. https://doi.org/10.1007/s10266-020-00560-6.

The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.