Next Article in Journal
Control Points Selection Based on Maximum External Reliability for Designing Geodetic Networks
Next Article in Special Issue
Design Model of Flow Lines to Include Switch-Off Policies Reducing Energy Consumption
Previous Article in Journal
Impact Damage Resistance and Post-Impact Tolerance of Optimum Banana-Pseudo-Stem-Fiber-Reinforced Epoxy Sandwich Structures
Previous Article in Special Issue
Statistical Analysis and Data Envelopment Analysis to Improve the Efficiency of Manufacturing Process of Electrical Conductors
 
 
Article
Peer-Review Record

In-Line Target Production for Laser IFE

Appl. Sci. 2020, 10(2), 686; https://doi.org/10.3390/app10020686
by Irina Aleksandrova, Eugeniy Koshelev and Elena Koresheva *
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Appl. Sci. 2020, 10(2), 686; https://doi.org/10.3390/app10020686
Submission received: 25 December 2019 / Revised: 13 January 2020 / Accepted: 15 January 2020 / Published: 18 January 2020
(This article belongs to the Special Issue Design and Optimization of Production Lines)

Round 1

Reviewer 1 Report

Your manuscript needs to be revised before it can be accepted.

Comments for author File: Comments.pdf

Author Response

Dear Sir!

We have revised the manuscript #applsci-691813 according your comments, namely:

Abstract: it was improved; the abbreviation of "FST" is supported with the full meaning Whole text: minor spell checking were made; the iterations from the text were took off Introduction was improved according your comments The newly obtained results are presented more clearly in order to avoid the dual or multiple publications References are improved according you comments

Sincerely yours,

Elena Koresheva

Author Response File: Author Response.pdf

Reviewer 2 Report

Review Report: "In-line target production for laser IFE", by  
Irina Aleksandrova , et al.

 

      The manuscript proposes a new method of a spherical inertial fusion target fabrication and its injection into a reactor. The manuscript is rather well organized, and presents the new results in this research field of Inertial Confinement Fusion. Before its publication, Authors are recommended to clarify the followings points:

 

1) The new results in the target fabrication and in the target injection have been published in Refs. [2]-[12] by the Authors previously. The differences must be clearly explained in the paper between the present work and the previous works in Refs. [2]-[12], in order to avoid the dual or multiple publications.

 

2) The following closely relating works must be cited in the paper. For example, the following references must be cited in the paper: [1]. https://doi.org/10.1016/j.fusengdes.2006.07.071,  [2]. https://doi.org/10.1109/TPS.2018.2876471.

 

3) The English presentation style should be polished up throughout the paper. For example, in Abstract the abbreviation of "FST" first appears without showing the full meaning.

 

Author Response

Dear Sir

We have revised the manuscript #applsci-691813 according your comments, namely:

Abstract: it was improved, the abbreviation of "FST" is supported with the full meaning Whole text: minor spell cheking were made; the iterations from the text were took off Introduction was improved The newly obtained results are presented more clearly in order to avoid the dual or multiple publications References are improved.

Sincerely yours,

Elena Koresheva

Author Response File: Author Response.pdf

Back to TopTop