Selection of Magnetic Pulse Crimping Process Conditions to Improve Crimped Terminal Quality

The crimping of copper terminals via hand-operated and hydraulic compressors is used to generate a compressive force between a terminal and a wire, generally on a worksite. However, this equipment often causes compression defects because non-uniform pressure is applied to the terminal surface in the radial direction during crimping. When the crimped terminal is connected to electrical parts such as the power transmission system, a low-quality crimped terminal can separate from the wire strands, increasing resistance to current flow through the terminal, energy loss, and the risk of fire due to overheating. For this reason, Magnetic Pulse Crimping (MPC), which can yield highly durable crimped terminals with uniform quality, has recently been developed. This process uses only the magnetic force generated by high electromagnetic interaction between the crimping coil part and the surface of the terminal, without physical contact. The objective of this research was to confirm the superiority of the MPC process over the conventional crimping process and then analyze the effects of the main process parameters, including the crimping length and the charge energy on the crimping part, so that this new process can be applied at worksites. To realize these goals, copper terminals and 35 mm² copper wire strands were employed, and various types of crimping parts were manufactured under different crimping conditions. In particular, the distribution of electromagnetic force on the crimped parts were analyzed via numerical analysis. The crimping part performance was improved when the MPC process was applied to terminal crimping. In particular, decreasing the crimping length led to increased crimping quality, while increasing the charge energy caused increases in the compression ratio and pullout strength. However, excessively high charge energy caused the edge to break the wire strands; therefore, it is important to select the proper charge energy.