Correction: Steer et al. A Comparison of Laboratory Coal Testing with the Blast Furnace Process and Coal Injection. Metals 2021, 11, 1476

Julian Steer; Mark Greenslade; Richard Marsh

doi:10.3390/met12010130

,

and

¹

Cardiff School of Engineering, Cardiff University, Queen’s Buildings, The Parade, Cardiff CF24 3AA, UK

²

Tata Steel UK, Port Talbot SA13 2NG, UK

^*

Author to whom correspondence should be addressed.

Metals2022, 12(1), 130;https://doi.org/10.3390/met12010130

Version Notes

Order Reprints

The authors wish to make the following corrections to this paper [].

Error in Figure

In the original article, there was a mistake in Figure 4 when published. The diagram in Figure 4 has been duplicated; the bottom diagram is the correct schematic diagram. The corrected Figure 4 appears below. The authors apologize for any inconvenience caused and state that the scientific conclusions are unaffected. The original article has been updated.

Figure 4. Schematic of drop tube furnace.

Reference

Steer, J.; Greenslade, M.; Marsh, R. A Comparison of Laboratory Coal Testing with the Blast Furnace Process and Coal Injection. Metals 2021, 11, 1476. [Google Scholar] [CrossRef]

Publisher’s Note: MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations.

© 2022 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).

Correction: Steer et al. A Comparison of Laboratory Coal Testing with the Blast Furnace Process and Coal Injection. Metals 2021, 11, 1476

Reference

Article Metrics

Citations

Article Access Statistics