Correction: Rimano et al. The Environmental Impact of Organizations: A Pilot Test from the Packaging Industry Based on Organizational Life Cycle Assessment. Sustainability 2021, 13, 11402

Michela Rimano; Alberto Simboli; Raffaella Taddeo; Michele Del Grosso; Andrea Raggi

doi:10.3390/su15032528

,

and

¹

Aptar Italia S.p.A., Via Po 49, San Giovanni Teatino, 66020 Chieti, Italy

²

Department of Economic Studies, University “G. d’Annunzio”, Viale Pindaro 42, 65127 Pescara, Italy

^*

Author to whom correspondence should be addressed.

Sustainability2023, 15(3), 2528;https://doi.org/10.3390/su15032528

This article belongs to the Special Issue Life Cycle Thinking, Sustainability and Circular Economy: Practical Applications and Future Challenges

Version Notes

Order Reprints

The authors would like to make the following corrections about the published paper [1]. The changes are as follows.

The authors would like to delete repeated parts in Table 1 and replace Table 1 to:

Table 1. Data quality assessment.

The authors and the Editorial Office would like to apologize for any inconvenience caused to the readers and state that the scientific conclusions are unaffected. The original article has been updated.

Reference

Rimano, M.; Simboli, A.; Taddeo, R.; Del Grosso, M.; Raggi, A. The Environmental Impact of Organizations: A Pilot Test from the Packaging Industry Based on Organizational Life Cycle Assessment. Sustainability 2021, 13, 11402. [Google Scholar] [CrossRef]

Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

© 2023 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).

Flow	Specific or Generic	Reliability	Completeness	Temporal Correlation	Geographical Correlation	Technological Correlation
INPUT
Electrical energy
Electrical energy from renewable sources	S	1	1	1	1	1
T&D losses	G	1 *	2	1	3	2
Water
Water	S	1	1	1	1	1
Mass
Resins (for molding)	S	1	1	1	1	1
Resins (components)	S	2	1	1	1	1
Metals (components)	S	2	1	1	1	1
Auxiliary materials	S	1	1	1	1	1
Packaging	S	1	1	1	1	1
Maintenance products	S	1	5	1	1	1
Other products (e.g., for offices)	S	1	1	1	1	1
Fuels	S	2	1	1	1	1
Refrigerants	S	1	1	1	1	1
Transport
Incoming transport	S	2	1	1	1	1
Employee commuting	S	2	1	1	1	1
Business travels	S	1	2	1	1	1
Outbound transport	S	2	1	1	1	1
OUTPUT
Products and by-products
Cartridges	S	1	1	1	1	1
Finished products	S	1	1	1	1	1
By-products	S	1	1	1	1	1
Waste
Waste	S	1	1	1	1	1

Correction: Rimano et al. The Environmental Impact of Organizations: A Pilot Test from the Packaging Industry Based on Organizational Life Cycle Assessment. Sustainability 2021, 13, 11402

Reference

Article Metrics

Citations

Article Access Statistics