Review Reports

Round 1

Reviewer 1 Report

This paper presents Shape sensing of plate structures using inverse Finite  Element Method: Investigation of efficient strain sensor patterns. Before considering it for publication the authors are required to revise the paper based on the following remarks:

1- Please double check all the formulation (Bold, Italic, ….).

2- English typos should be revised.

3- The CPU time of each mesh should be mention to see the accuracy of the presented numerical model.

4- Mode types are missing (Number of modes belong to DOF).

5- Section 2 it will be better to describe the presented technique using a flowchart.

6- Please improve the Figs 11-13 using zoom. (The plotted results are very close but the error still higher? ) Please double-check carefully.

7- The introduction should be improved by different kinds of structures in dynamical analysis and inverse problem such as:

https://doi.org/10.1016/j.compstruct.2020.112497

 https://doi.org/10.12989/scs.2020.34.4.511

Author Response

Please, see attachment

Author Response File: Author Response.pdf

Reviewer 2 Report

See attached file

Comments for author File: Comments.pdf

Author Response

Please, see the attachment

Author Response File: Author Response.pdf

Round 2

Reviewer 1 Report

accept in this present form.