A Reference Matching-Based Temperature Compensation Method for Ultrasonic Guided Wave Signals
Abstract
:1. Introduction
2. Theoretical Background
3. Reference Matching-Based Compensation Method
4. Results
4.1. Experiment Setup
4.2. Process of Compensation
4.3. Analysis of Compensation Results
5. Experimental Validations of Damage Imaging Based on Temperature Compensation
6. Conclusions
Author Contributions
Funding
Conflicts of Interest
References
- Cawley, P.; Alleyne, D. The use of Lamb waves for the long range inspection of large structures. Ultrasonics 1996, 34, 287–290. [Google Scholar] [CrossRef]
- Qing, X.; Li, W.; Wang, Y.; Sun, H. Piezoelectric transducer-based structural health monitoring for aircraft applications. Sensors 2019, 19, 545. [Google Scholar] [CrossRef] [PubMed]
- Rose, J.L. Ultrasonic Guided Waves in Structural Health Monitoring. Key Eng. Mater. 2004, 270, 14–21. [Google Scholar] [CrossRef]
- Sun, X.; Xiao, Y. Opportunities and challenges of aircraft structural health monitoring. Acta Aeronaut. Astronaut. Sin. 2014, 35, 3199–3212. [Google Scholar]
- Yuan, S.; Qiu, L.; Wu, J.; Sun, Y.; Wang, Q. Challenge in structural health monitoring of large aircraft development. Aeronaut. Manuf. Technol. 2009, 22, 62–67. [Google Scholar]
- Qing, X.L.; Wang, Y.S.; Zhao, L. Structural health monitoring technology and its application in aeronautics and astronautics. J. Exp. Mech. 2012, 27, 517–526. [Google Scholar]
- Yan, G.; Zhou, L.; Meng, W. Damage detection and identification for composites based on Lamb waves and time-frequency analysis method. J. Nanjing Univ. Aeronaut. Astronaut. 2007, 39, 397–402. [Google Scholar]
- Qiu, L.; Liu, M.; Qing, X.; Yuan, S. A quan-titative multidamage monitoring method for large-scale complex composite. Struct. Health Monit. 2013, 12, 183–196. [Google Scholar] [CrossRef]
- Jian, C.; Lihua, S.; Xinlin, Q. Lamb wave high-resolution damage imaging method based on non-dispersive signal construction. Acta Aeronaut. Astronaut. Sin. 2013, 34, 1815–1823. [Google Scholar]
- Michaels, J.E.; Lee, S.J.; Michaels, T.E. Impact of applied loads on guided wave structural health monitoring. In Proceedings of the AIP Conference, San Diego, CA, USA, 18–23 July 2010; pp. 1515–1522. [Google Scholar]
- Lee, S.J.; Gandhi, N.; Michaels, J.E.; Michaels, T.E. Comparison of the effects of applied loads and temperature variations on guided wave propagation. In Proceedings of the AIP Conference, San Diego, CA, USA, 18–23 July 2010; pp. 175–182. [Google Scholar]
- Prasad, S.M.; Balasubramaniam, K.; Krishnamurthy, C.V. Structural health monitoring of composite structures using Lamb wave tomography. Smart Mater. Struct. 2004, 13, N73. [Google Scholar] [CrossRef]
- Schubert, K.J.; Brauner, C.; Herrmann, A.S. Non-damage-related influences on Lamb wave-based structural health monitoring of carbon fiber-reinforced plastic structures. Struct. Health Monit. 2014, 13, 158–176. [Google Scholar] [CrossRef]
- Sohn, H. Effects of environmental and operational variability on structural health monitoring. Philos. Trans. R. Soc. A Math. Phys. Eng. Sci. 2006, 365, 539–560. [Google Scholar] [CrossRef] [PubMed]
- Lanza di Scalea, F.; Salamone, S. Temperature effects in ultrasonic Lamb wave structural health monitoring systems. J. Acoust. Soc. Am. 2008, 124, 161–174. [Google Scholar] [CrossRef] [PubMed]
- Eybpoosh, M.; Bergés, M.; Noh, H.Y. Investigation on the effects of environmental and operational conditions (EOC) on diffuse-field ultrasonic guided-waves in pipes. In Proceedings of the Computing in Civil and Building Engineering, Orlando, FL, USA, 23–25 June 2014; pp. 1198–1205. [Google Scholar]
- Lu, Y.; Michaels, J.E. A methodology for structural health monitoring with diffuse ultrasonic waves in the presence of temperature variations. Ultrasonics 2005, 43, 717–731. [Google Scholar] [CrossRef] [PubMed]
- Konstantinidis, G.; Drinkwater, B.W.; Wilcox, P.D. The temperature stability of guided wave structural health monitoring systems. Smart Mater. Struct. 2006, 15, 967. [Google Scholar] [CrossRef]
- Lu, Z.; Lee, S.J.; Michaels, J.E.; Michaels, T.E. On the optimization of temperature compensation for guided wave structural health monitoring. In Proceedings of the AIP Conference, San Diego, CA, USA, 18–23 July 2010; pp. 1860–1867. [Google Scholar]
- Harley, J.B.; Moura, J.M.F. Scale transform signal processing for optimal ultrasonic temperature compensation. IEEE Trans. Ultrason. Ferroelectr. Freq. Control 2012, 59, 2226–2236. [Google Scholar] [CrossRef]
- Wang, Y.; Gao, L.; Yuan, S.; Qiu, L.; Qing, X. An adaptive filter–based temperature compensation technique for structural health monitoring. J. Intell. Mater. Syst. Struct. 2014, 25, 2187–2198. [Google Scholar] [CrossRef]
- Cross, E.J.; Worden, K.; Chen, Q. Cointegration: A novel approach for the removal of environmental trends in structural health monitoring data. Proc. R. Soc. A Math. Phys. Eng. Sci. 2011, 467, 2712–2732. [Google Scholar] [CrossRef]
- Dao, P.B.; Staszewski, W.J. Cointegration approach for temperature effect compensation in Lamb-wave-based damage detection. Smart Mater. Struct. 2013, 22, 095002. [Google Scholar] [CrossRef]
- Worden, K.; Cross, E.J.; Antoniadou, I.; Kyprianou, A. A multiresolution approach to cointegration for enhanced SHM of structures under varying conditions–an exploratory study. Mech. Syst. Signal Process. 2014, 47, 243–262. [Google Scholar] [CrossRef]
- Yan, A.M.; Kerschen, G.; De Boe, P.; Golinval, J.C. Structural damage diagnosis under varying environmental conditions—Part I: A linear analysis. Mech. Syst. Signal Process. 2005, 19, 847–864. [Google Scholar] [CrossRef]
- Yan, A.M.; Kerschen, G.; De Boe, P.; Golinval, J.C. Structural damage diagnosis under varying environmental conditions—Part II: Local PCA for non-linear cases. Mech. Syst. Signal Process. 2005, 19, 865–880. [Google Scholar] [CrossRef]
- Kullaa, J. Structural health monitoring under nonlinear environmental or operational influences. Shock Vib. 2014, 2014. [Google Scholar] [CrossRef]
- Roy, S.; Lonkar, K.; Janapati, V.; Chang, F.K. A novel physics-based temperature compensation model for structural health monitoring using ultrasonic guided waves. Struct. Health Monit. 2014, 13, 321–342. [Google Scholar] [CrossRef]
- Lu, Y.; Michaels, J.E. Numerical implementation of matching pursuit for the analysis of complex ultrasonic signals. IEEE Trans. Ultrason. Ferroelectr. Freq. Control 2008, 55, 173–182. [Google Scholar]
- Sun, H.; Yi, J.; Xu, Y.; Wang, Y.; Qing, X. Identification and Compensation Technique of Non-Uniform Temperature Field for Lamb Wave-and Multiple Sensors-Based Damage Detection. Sensors 2019, 19, 2930. [Google Scholar] [CrossRef]
- Blaise, E. Built-in diagnostics for sandwich structures under extreme temperatures. Ph.D. Thesis, Stanford University, Stanford, CA, USA, 2004. [Google Scholar]
- Putkis, O.; Dalton, R.P.; Croxford, A.J. The influence of temperature variations on ultrasonic guided waves in anisotropic CFRP plates. Ultrasonics 2015, 60, 109–116. [Google Scholar] [CrossRef]
- Wu, Z.; Liu, K.; Wang, Y.; Zheng, Y. Validation and evaluation of damage identification using probability-based diagnostic imaging on a stiffened composite panel. J. Intell. Mater. Syst. Struct. 2014, 26, 2181–2195. [Google Scholar] [CrossRef]
Compensation Temperature | CL |
---|---|
57 °C | −55.54 |
60 °C | −40.98 |
63 °C | −30.31 |
66 °C | −25.64 |
Compensation Method | Temperature Range | Maximum Compensation Interval | Reference Signal Interval 2 |
---|---|---|---|
BSS | 5–40 °C | 5 °C | 0.1 °C |
OBS | 22–32 °C | 10 °C | 0.1 °C |
BSS + OBS | 21.5–31.5 °C | 10 °C | 0.5 °C |
Physics-based | 30–90 °C | 10 °C | 4 °C |
Reference Matching-based | 39–84 °C | 25 °C 1 | 3 °C |
© 2019 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).
Share and Cite
Wang, G.; Wang, Y.; Sun, H.; Miao, B.; Wang, Y. A Reference Matching-Based Temperature Compensation Method for Ultrasonic Guided Wave Signals. Sensors 2019, 19, 5174. https://doi.org/10.3390/s19235174
Wang G, Wang Y, Sun H, Miao B, Wang Y. A Reference Matching-Based Temperature Compensation Method for Ultrasonic Guided Wave Signals. Sensors. 2019; 19(23):5174. https://doi.org/10.3390/s19235174
Chicago/Turabian StyleWang, Geng, Yuhang Wang, Hu Sun, Bingrong Miao, and Yishou Wang. 2019. "A Reference Matching-Based Temperature Compensation Method for Ultrasonic Guided Wave Signals" Sensors 19, no. 23: 5174. https://doi.org/10.3390/s19235174
APA StyleWang, G., Wang, Y., Sun, H., Miao, B., & Wang, Y. (2019). A Reference Matching-Based Temperature Compensation Method for Ultrasonic Guided Wave Signals. Sensors, 19(23), 5174. https://doi.org/10.3390/s19235174