Search Results (11)

A two-dimensional ultrasonic anemometer was installed at a height of 20 m on a wind measurement tower in Haiyan Town, Jiangmen, to monitor flow conditions in typhoon Mangkhut (1822) before and after landfall. Mean wind speed, wind direction, turbulence intensity, gust factor, turbulence integral scale, and turbulence power spectral density were derived and analyzed before and after landing. The results show that the central wind speed time history before and after landfall exhibits significant differences, and the mean wind direction undergoes a reverse change of about 180°. The mean downwind and crosswind turbulence intensity before landing were 0.25 and 0.22, respectively, and 0.20 and 0.16 after landing. The associated mean downwind and crosswind gust factors were 1.70 and 0.61 before landing, and 1.55 and 0.46 after. These differences before and after landing are considered significant, and both turbulence intensity and gust factor showed a certain decreasing trend with the increase in wind speed. The relationship between turbulence intensity and gust factor, though somewhat scattered, was basically consistent with the commonly used Ishizaki and Choi empirical formulas. Mean streamwise and crosswind turbulence integral scales before landfall were 218 m and 100 m, respectively, and 198 m and 177 m after. They showed a weak increasing trend with increase in mean wind speed. Power spectra before and after landing were basically consistent. Comparisons with standard forms were inconclusive, though the von Karman spectrum appeared to be slightly superior to the others, particularly as the wind speed and turbulence integral scale increased. Full article

Graphene’s extraordinary thermal conductivity makes it a compelling material for heat management in microelectronic circuits, lithium-ion batteries, and thermoelectric devices. In this article, we investigate its vibrational modes using a Born–von Karman model that includes first- and second-nearest-neighbor interactions. The resulting phonon dispersion relations agree well with experimental data, including acoustic flexural modes. To analyze phonon transport in mesoscopic graphene ribbons, we use both the Kubo–Greenwood and Landauer formalisms, as well as an independent channel method, which analytically maps zigzag-edged hexagonal ribbons into a set of single and dual chains via a unitary transformation. The resulting lattice thermal conductance spectra exhibit quantized steps that are smoothed in the presence of corrugations. We further explore the effects of temperature-induced rippling and buckling disorders on the phonon transport in graphene ribbons suspended over trenches. The predicted thermal conductance as a function of length and temperature closely matches experimental measurements, demonstrating the effectiveness of the independent channel method for the fully real-space modeling of corrugated graphene ribbons. Full article

This study investigates the time-resolved aerodynamics in the cavity regions of a full-scale, high-speed, low-pressure turbine stage representative of geared turbofan engines. The turbine stage is tested in the von Karman Institute’s short-duration rotating facility at different purge rates (PR) injected through the upstream hub cavity. Spectra from the shroud and downstream hub cavity show perturbations linked to blade passing frequency and rotor speed. Asynchronous flow structures associated with ingress/egress mechanisms are observed in the rim seal of the purged cavity. At 0% PR, the ingress region extends to the entire rim seal, and pressure fluctuations are maximized. At 1% PR, the instability is suppressed and the cavity is sealed. At 0.5%, the rim-seal instability exhibits multiple peaks in the spectra, each corresponding to a state of the instability. Kelvin–Helmholtz instabilities are identified as trigger mechanisms. A novel technique based on the properties of the cross-power spectral density is developed to determine the speed and wavelength of the rotating structures, achieving higher precision than the commonly used cross-correlation method. Moreover, unlike the standard methodology, this approach allows researchers to calculate the structure characteristics for all the instability states. Spectral analysis at the turbine outlet shows that rim-seal-induced instabilities propagate into regions occupied by secondary flows. A methodology is proposed to quantify the magnitude of the induced fluctuations, showing that the interaction with secondary flows amplifies the instability at the stage outlet. Full article

This study investigates wind turbine structural dynamics using stochastic analysis and computational methods in both the time and frequency domains. Simulations and experiments are utilized to evaluate the dynamic response of a wind turbine structure to turbulent wind loads, with the aim of validating the results based on real wind farm conditions. Two approaches are employed to analyze the dynamic responses: the frequency domain modal analysis approach, which incorporates von Kármán spectra to represent the turbulent wind loads, and the time domain Monte Carlo simulation and Newmark methods, which generate wind loads and determine dynamic responses, respectively. The results indicate that, for a larger number of samples, both methods consistently yield simulated turbulent wind loads, dynamic responses and peak frequencies. These findings are further validated through experimental data. However, when dealing with a smaller number of samples, the time domain analysis produces distorted results, necessitating a larger number of samples to achieve accurate findings, while the frequency domain method maintains accuracy. Therefore, the accurate analysis of wind turbine structural dynamics can be achieved using simulations in both the time and frequency domains, considering the importance of the number of samples when choosing between time domain and frequency domain analyses. Taking these considerations into account allows for a more comprehensive and robust analysis, ultimately leading to more effective outcomes. Full article

Significant advances in the field of composite structures continue to be made on a variety of fronts, including theoretical studies based on advances in structural theory kinematics and computer models of structural elements employing advanced theories and unique formulations. Plate vibration is a persistently interesting subject owing to its wider usage as a structural component in the industry. The current study was carried out using the C^o continuous eight-noded quadrilateral shear-flexible element having five nodal degrees of freedom, which is ground on first-order shear deformation theory (FSDT). For small strain and sufficiently large deformation, the geometric nonlinearity is integrated using the Von Kármán assumption. The governing equations in the time domain are solved employing the modified shooting technique along with an arc-length and pseudo-arc-length continuation strategy. This work explored the effect of fiber angle on the steady-state nonlinear forced vibration response. To explain hardening nonlinearity, the strain and stress fluctuation throughout the thickness for a rectangular laminated composite plate is determined. The cyclic fluctuation of the steady-state nonlinear normal stress during a time period at the centre of the top/bottom surfaces is also provided at the forcing frequency ratio of peak amplitude in a nonlinear response. Because of the variation in restoring forces, the frequency spectra for all fiber angle orientations show significantly enhanced harmonic participation in addition to the fundamental harmonic. Full article

Based on wind field data measured during the landfall of Typhoon Jangmi in Wenzhou in 2008, this study analyzes wind field characteristics, including wind speed, wind direction, probability density, turbulence intensity, gust factor, peak factor, power spectrum, turbulence integral scale, coherence, and the autocorrelation coefficient of Typhoon Jangmi. Results showed that the wind field characteristics for the east and west measuring points were basically the same and followed an approximately similar pattern. The probability density of fluctuating wind tends to obey a Gaussian distribution. The turbulence intensity gradually decreases with increasing 10 min averaged wind speed, but the reduction rate gradually drops. The turbulence intensity is affected by the change in a time interval because turbulence intensity decreases as the time interval increases. With an increase in the 10 min average wind speed and time interval, the gust factor decreases. The peak factor decreases, though insignificantly, with increasing mean wind speed, and the distribution of peak factors is greatly scattered. The variation in the peak factor with time is in good agreement with the Durst curve. The gust factor increases as the turbulence intensity increases and is in line with the empirical curves of Ishizaki, Choi, and Cao. The power spectra of the fluctuating wind speed of Typhoon Jangmi in all directions agree well with Von Karman’s empirical spectrum. The turbulence integral scale increases slightly with increasing average wind speed, and the distribution is relatively scattered. The coherence of the fluctuating wind speed components matches the exponential function proposed by Davenport, and the autocorrelation coefficient decreases as $\mathsf{\tau }$ increases. Full article

With the intensification of energy consumption, how to make rational and efficient use of wind energy has been studied all over the world. The construction of facilities to obtain wind energy requires an accurate assessment of the wind characteristics of the local terrain. In order to study the wind characteristics on an island in Southeast China, a 1:1300 terrain model is established, and the characteristics of mean wind and fluctuating wind are studied by numerical simulation and wind tunnel test. The results show that wind speed is affected by the incoming wind direction and local terrain. Wind speed on windward slopes and flat areas with no obstructions is higher, and wind speed on leeward slopes and valleys is lower. Then, the wind attack angle of each measuring point is mainly in the range of −10°~10°, which is much higher than that in flat areas. The positive and negative wind attack angles are controlled by the incoming wind direction, and the size is closely related to the local terrain. As for pulsation characteristics, the disturbance of the inflow determines the turbulence intensity. The incoming wind direction mainly affects the turbulence intensity on the hillside, while the turbulence intensity in the valley and flat area is controlled by the local terrain. In addition, the fluctuating wind speed power spectra on the island is more consistent with the von Karman spectrum, which is quite different from the Kaimal spectrum. The bandwidth on hillsides and valleys will not change with the change in inflow, but for flat areas, the bandwidth is greatly affected by the inflow direction. Full article

The capabilities of a quadcopter in the hover mode for low-altitude sensing of atmospheric turbulence with high spatial resolution in urban areas characterized by complex orography are investigated. The studies were carried out in different seasons (winter, spring, summer, and fall), and the quadcopter hovered in the immediate vicinity of ultrasonic weather stations. The DJI Phantom 4 Pro quadcopter and AMK-03 ultrasonic weather stations installed in different places of the studied territory were used in the experiment. The smoothing procedure was used to study the behavior of the longitudinal and lateral spectra of turbulence in the inertial and energy production ranges. The longitudinal and lateral turbulence scales were estimated by the least-square fit method with the von Karman model as a regression curve. It is shown that the turbulence spectra obtained with DJI Phantom 4 Pro and AMK-03 generally coincide, with minor differences observed in the high-frequency region of the spectrum. In the inertial range, the behavior of the turbulence spectra shows that they obey the Kolmogorov–Obukhov “5/3” law. In the energy production range, the longitudinal and lateral turbulence scales and their ratio measured by DJI Phantom 4 Pro and AMK-03 agree to a good accuracy. Discrepancies in the data obtained with the quadcopter and the ultrasonic weather stations at the territory with complex orography are explained by the partial correlation of the wind velocity series at different measurement points and the influence of the inhomogeneous surface. Full article

In presence of vegetation patches in a channel bed, different flow–morphology interactions in the river will result. The investigation of the nature and intensity of these structures is a crucial part of the research works of river engineering. In this experimental study, the characteristics of turbulence in the non-developed region downstream of a vegetation patch suffering from a gradual fade have been investigated. The changes in turbulent structure were tracked in sequential patterns by reducing the patch size. The model vegetation was selected carefully to simulate the aquatic vegetation patches in natural rivers. Velocity profile, TKE (Turbulent Kinetic Energy), turbulent power spectra and quadrant analysis have been used to investigate the behavior and intensity of the turbulent structures. The results of the velocity profile and TKE indicate that there are three different flow layers in the region downstream of the vegetation patch, including the wake layer, mixing layer and shear layer. When the vegetation patch is wide enough (D_v/D_c > 0.5, termed as the patch width ratio, where D_v is the width of a vegetation patch and D_c is the width of the channel), highly intermittent anisotropic turbulent events appear in the mixing layer at the depth of z/H_v = 0.7~1.1 and distance of x/H_v = 8~12 (where x is streamwise distance from the patch edge, z is vertical distance from channel bed and H_v is the height of a vegetation patch). The results of quadrant analysis show that these structures are associated with the dominance of the outward interactions (Q1). Moreover, these structures accompany large coherent Reynolds shear stresses, anomalies in streamwise velocity, increases in the standard deviation of TKE and increases in intermittent Turbulent Kinetic Energy (TKE_i). The intensity and extents of these structures fade with the decrease in the size of a vegetation patch. On the other hand, as the size of the vegetation patch decreases, von Karman vortexes appear in the wake layer and form the dominant flow structures in the downstream region of a vegetation patch. Full article

Turbulence parameters, in particular integral length scale (ILS) and turbulence intensity (Tu), are key input parameters for various applications in aerodynamics and aeroacoustics. The estimation of these parameters is typically performed using data obtained via hot-wire measurements. On the one hand, hot-wire measurements are affected by external disturbances resulting in increased measurement noise. On the other hand, commonly applied turbulence parameter estimators lack in robustness. If not addressed correctly, both issues may impede the accuracy of the turbulence parameter estimation. In this article, a procedure consisting of several signal processing steps is presented to filter non-turbulence related disturbances from the unsteady velocity data. The signal processing techniques comprise time- and frequency-domain approaches. For the turbulence parameter estimation, two different models of the turbulence spectra—the von Kármán model and the Bullen model—are fitted to match the spectrum of the measured data. The results of several parameter estimation techniques are compared. Computational Fluid Dynamics (CFD) data are used to validate the estimation techniques and also to assess the influence of the variation in window size on the estimated parameters. Additionally, hot-wire data from a high-speed fan rig are analyzed. ILS and Tu are assessed at several radial positions for two fan speeds. It is found that most techniques yield similar values for ILS and Tu. The comparison of the fitted spectra with the spectra of the measured data shows a good agreement in most cases provided that a sufficiently fine frequency resolution is applied. The ratio of ILS and Tu of the velocity components in longitudinal and transverse direction allows the assessment of flow-isotropy. Results indicate that the turbulence is anisotropic for the investigated flow fields. Full article

This study carries out a detailed full-scale investigation on the strong wind characteristics at a cable-stayed bridge site and associated buffeting response of the bridge structure during construction, using a field monitoring system. It is found that the wind turbulence parameters during the typhoon and monsoon conditions share a considerable amount of similarity, and they can be described as the input turbulence parameters for the current wind-induced vibration theory. While the longitudinal turbulence integral scales are consistent with those in regional structural codes, the turbulence intensities and gust factors are less than the recommended values. The wind spectra obtained via the field measurements can be well approximated by the von Karman spectra. For the buffeting response of the bridge under strong winds, its vertical acceleration responses at the extreme single-cantilever state are significantly larger than those in the horizontal direction and the increasing tendencies with mean wind velocities are also different from each other. The identified frequencies of the bridge are utilized to validate its finite element model (FEM), and these field-measurement acceleration results are compared with those from the FEM-based numerical buffeting analysis with measured turbulence parameters. Full article