Search Results (8)

Pattern recognition in myoelectric control that relies on the myoelectric activity associated with arm motions is an effective control method applied to myoelectric prostheses. Individuals with transhumeral amputation face significant challenges in effectively controlling their prosthetics, as muscle activation varies with changes in arm positions, leading to a notable decrease in the accuracy of motion pattern recognition and consequently resulting in a high rejection rate of prosthetic devices. Therefore, to achieve high accuracy and arm position stability in upper-arm motion recognition, we propose a Deep Adversarial Inception Domain Adaptation (DAIDA) based on the Inception feature module to enhance the generalization ability of the model. Surface electromyography (sEMG) signals were collected from 10 healthy subjects and two transhumeral amputees while performing hand, wrist, and elbow motions at three arm positions. The recognition performance of different feature modules was compared, and ultimately, accurate recognition of upper-arm motions was achieved using the Inception C module with a recognition accuracy of 90.70% ± 9.27%. Subsequently, validation was performed using data from different arm positions as source and target domains, and the results showed that compared to the direct use of a convolutional neural network (CNN), the recognition accuracy on untrained arm positions increased by 75.71% (p < 0.05), with a recognition accuracy of 91.25% ± 6.59%. Similarly, in testing scenarios involving multiple arm positions, there was a significant improvement in recognition accuracy, with recognition accuracy exceeding 90% for both healthy subjects and transhumeral amputees. Full article

Designs of active prostheses attempt to compensate for various functional losses following amputation. Integration of sensory feedback with the functional control re-enables sensory interaction with the environment through the prosthetic. Besides the functional and sensory loss, amputation induces anatomical and physiological changes of the sensory neural pathways, both peripherally and centrally, which can lead to phantom limb pain (PLP). Additionally, referred sensation areas (RSAs) likely originating from peripheral nerve sprouting, regeneration, and sensory reinnervation may develop. RSAs might provide a non-invasive access point to sensory neural pathways that project to the lost limb. This paper aims to report on the sensory input features, elicited using non-invasive electrical stimulation of RSAs that over time alleviated PLP in two upper-limb amputees. The distinct features of RSAs and sensation evoked using mechanical and electrical stimuli were characterized for the two participants over a period of 7 and 9 weeks, respectively. Both participants received transradial and transhumeral amputation following traumatic injuries. In one participant, a relatively low but stable number of RSAs provided a large variety of types of evoked phantom hand (PH) sensations. These included non-painful touch, vibration, tingling, stabbing, pressure, warmth/cold as well as the perception of various positions and movements of the phantom hand upon stimulation. Discomforting and painful sensations were induced with both mechanical and electrical stimuli. The other participant had a relatively large number of RSAs which varied over time. Stimulation of the RSAs provided mostly non-painful sensations of touch in the phantom hand. Temporary PLP alleviation and a change in the perception of the phantom hand from a tight to a more open fist were reported by both participants. The specificity of RSAs, dynamics in perception of the sensory input, and the associated alleviation of PLP could be effectively exploited by designs of future active prostheses. As such, techniques for the modulation of the sensory input associated with paradigms from interaction with the environment may add another dimension of protheses towards integrating personalized therapy for PLP. Full article

The lack of intuitive controllability remains a primary challenge in enabling transhumeral amputees to control a prosthesis for arm reaching with residual limb kinematics. Recent advancements in prosthetic arm control have focused on leveraging the predictive capabilities of artificial neural networks (ANNs) to automate elbow joint motion and wrist pronation–supination during target reaching tasks. However, large quantities of human motion data collected from different subjects for various activities of daily living (ADL) tasks are required to train these ANNs. For example, the reaching motion can be altered when the height of the desk is changed; however, it is cumbersome to conduct human experiments for all conditions. This paper proposes a framework for cloning motion datasets using deep reinforcement learning (DRL) to cater to training data requirements. DRL algorithms have been demonstrated to create human-like synergistic motion in humanoid agents to handle redundancy and optimize movements. In our study, we collected real motion data from six individuals performing multi-directional arm reaching tasks in the horizontal plane. We generated synthetic motion data that mimicked similar arm reaching tasks by utilizing a physics simulation and DRL-based arm manipulation. We then trained a CNN-LSTM network with different configurations of training motion data, including DRL, real, and hybrid datasets, to test the efficacy of the cloned motion data. The results of our evaluation showcase the effectiveness of the cloned motion data in training the ANN to predict natural elbow motion accurately across multiple subjects. Furthermore, motion data augmentation through combining real and cloned motion datasets has demonstrated the enhanced robustness of the ANN by supplementing and diversifying the limited training data. These findings have significant implications for creating synthetic dataset resources for various arm movements and fostering strategies for automatized prosthetic elbow motion. Full article

Transhumeral amputees experience considerable difficulties with controlling a multifunctional prosthesis (powered hand, wrist, and elbow) due to the lack of available muscles to provide electromyographic (EMG) signals. The residual limb motion strategy has become a popular alternative for transhumeral prosthesis control. It provides an intuitive way to estimate the motion of the prosthesis based on the residual shoulder motion, especially for target reaching tasks. Conventionally, a predictive model, typically an artificial neural network (ANN), is directly trained and relied upon to map the shoulder–elbow kinematics using the data from able-bodied subjects without extracting any prior synergistic information. However, it is essential to explicitly identify effective synergies and make them transferable across amputee users for higher accuracy and robustness. To overcome this limitation of the conventional ANN learning approach, this study explicitly combines the kinematic synergies with a recurrent neural network (RNN) to propose a synergy-space neural network for estimating forearm motions (i.e., elbow joint flexion–extension and pronation–supination angles) based on residual shoulder motions. We tested 36 training strategies for each of the 14 subjects, comparing the proposed synergy-space and conventional neural network learning approaches, and we statistically evaluated the results using Pearson’s correlation method and the analysis of variance (ANOVA) test. The offline cross-subject analysis indicates that the synergy-space neural network exhibits superior robustness to inter-individual variability, demonstrating the potential of this approach as a transferable and generalized control strategy for transhumeral prosthesis control. Full article

Prosthetic arms are designed to assist amputated individuals in the performance of the activities of daily life. Brain machine interfaces are currently employed to enhance the accuracy as well as number of control commands for upper limb prostheses. However, the motion prediction for prosthetic arms and the rehabilitation of amputees suffering from transhumeral amputations is limited. In this paper, functional near-infrared spectroscopy (fNIRS)-based approach for the recognition of human intention for six upper limb motions is proposed. The data were extracted from the study of fifteen healthy subjects and three transhumeral amputees for elbow extension, elbow flexion, wrist pronation, wrist supination, hand open, and hand close. The fNIRS signals were acquired from the motor cortex region of the brain by the commercial NIRSport device. The acquired data samples were filtered using finite impulse response (FIR) filter. Furthermore, signal mean, signal peak and minimum values were computed as feature set. An artificial neural network (ANN) was applied to these data samples. The results show the likelihood of classifying the six arm actions with an accuracy of 78%. The attained results have not yet been reported in any identical study. These achieved fNIRS results for intention detection are promising and suggest that they can be applied for the real-time control of the transhumeral prosthesis. Full article

The cybernetic interface within an upper-limb prosthesis facilitates a Human–Machine interaction and ultimately control of the prosthesis limb. A coherent flow between the phantom motion and subsequent actuation of the prosthesis limb to produce the desired gesture hinges heavily upon the physiological sensing source and its ability to acquire quality signals, alongside appropriate decoding of these intent signals with the aid of appropriate signal processing algorithms. In this paper, we discuss the sensing and signal processing aspects of the overall prosthesis control cybernetics, with emphasis on transradial, transhumeral, and shoulder disarticulate amputations, which represent considerable upper-limb amputees typically encountered within the population. Full article

The control scheme in a myoelectric prosthesis includes a pattern recognition section whose task is to decode an input signal, produce a respective actuation signal and drive the motors in the prosthesis limb towards the completion of the user’s intended gesture motion. The pattern recognition architecture works with a classifier which is typically trained and calibrated offline with a supervised learning framework. This method involves the training of classifiers which form part of the pattern recognition scheme, but also induces additional and often undesired lead time in the prosthesis design phase. In this study, a three-phase identification framework is formulated to design a control architecture capable of self-learning patterns from bio-signal inputs from electromyography (neuromuscular) and electroencephalography (brain wave) biosensors, for a transhumeral amputee case study. The results show that the designed self-learning framework can help reduce lead time in prosthesis control interface customisation, and can also be extended as an adaptive control scheme to minimise the performance degradation of the prosthesis controller. Full article

Robotic prostheses are expected to allow amputees greater freedom and mobility. However, available options to control transhumeral prostheses are reduced with increasing amputation level. In addition, for electromyography-based control of prostheses, the residual muscles alone cannot generate sufficiently different signals for accurate distal arm function. Thus, controlling a multi-degree of freedom (DoF) transhumeral prosthesis is challenging with currently available techniques. In this paper, an electroencephalogram (EEG)-based hierarchical two-stage approach is proposed to achieve multi-DoF control of a transhumeral prosthesis. In the proposed method, the motion intention for arm reaching or hand lifting is identified using classifiers trained with motion-related EEG features. For this purpose, neural network and k-nearest neighbor classifiers are used. Then, elbow motion and hand endpoint motion is estimated using a different set of neural-network-based classifiers, which are trained with motion information recorded using healthy subjects. The predictions from the classifiers are compared with residual limb motion to generate a final prediction of motion intention. This can then be used to realize multi-DoF control of a prosthesis. The experimental results show the feasibility of the proposed method for multi-DoF control of a transhumeral prosthesis. This proof of concept study was performed with healthy subjects. Full article