Search Results (9)

Oil sands tailings ponds are significant emitters of greenhouse gases (GHGs) in Canada. To move beyond making surface or atmospheric measurements of GHG release, it is necessary to understand the physical mechanisms by which gas is generated, bubbles form and then are either released or remain trapped in the pond. We present a review of the physical description of tailings ponds, relevant to gas release models. In particular, we target rheological variations within a pond and how these directly affect the distribution of trapped gas bubbles with depth. Within the limits of the available data, we show how gas content may vary significantly across ponds, and develop data-driven one-dimensional models of gas distribution and rheology. Full article

Large volumes of oil sands process-affected waters (OSPW) result from heavy oil extraction in Alberta, Canada. Currently, a toxic legacy of ca. 500 Mm³ is stored in tailings ponds under a zero-discharge policy. OSPW is a complex mixture of suspended and dissolved materials including a wide range of inorganic and organic contaminants. Classically defined naphthenic acids (NAs; C_nH_2n+ZO₂) are one of the primary toxic fractions in OSPW and have therefore been the subject of considerable research interest. Most studies employ considerable sample cleanup followed by liquid chromatography and/or high-resolution mass spectrometry (HRMS) for the characterization of these complex mixtures. However, these strategies can be time- and cost-intensive, limiting the scope of research and adoption for regulatory purposes. Condensed phase membrane introduction mass spectrometry (CP-MIMS) is emerging as a “fit-for-purpose” approach for the analysis of NAs. This technique directly interfaces the mass spectrometer with an aqueous sample using a hydrophobic semi-permeable membrane, requiring only pH adjustment to convert NAs to a membrane-permeable form. Here, we examine the perm-selectivity of classical NAs (O₂) relative to their more oxidized counterparts (O₃–O₇) and heteroatomic (N, S) species collectively termed naphthenic acid fraction compounds (NAFCs). The investigation of 14 model compounds revealed that classically defined NAs are greater than 50-fold more membrane permeable than their oxidized/heteroatomic analogs. HRMS analysis of real OSPW extracts with and without membrane clean-up further supported selectivity towards the toxic O₂ class of NAs, with >85% of the overall signal intensity attributable to O₂ NAs in the membrane permeate despite as little as 34.7 ± 0.6% O₂ NAs observed in the directly infused mixture. The information collected with HRMS is leveraged to refine our method for analysis of NAs at unit mass resolution. This new method is applied to 28 archived real-world samples containing NAs/NAFCs from constructed wetlands, OSPW, and environmental monitoring campaigns. Concentrations ranged from 0–25 mg/L O₂ NAs and the results measured by CP-MIMS (unit mass) and SPE-HRMS (Orbitrap) showed good agreement (slope = 0.80; R² = 0.76). Full article

The biogenic production of toxic H₂S gas in sulfate-rich oil sands tailings ponds is associated with strong environmental concerns. Beside precipitation into sulfide minerals and chemical re-oxidation, microbial sulfur oxidation may catalyze sulfide re-cycling but potentially contributes to acid rock drainage (ARD) generation. To evaluate the microbial potential for sulfur oxidation, we conducted a microcosm-based pilot study with tailings of an active pond. Incubations were performed under oxic and anoxic conditions, with and without KNO₃ as an electron acceptor and thiosulfate as a common substrate for microbial sulfur oxidation. The highest potentials of sulfur oxidation occurred in oxic assays (1.21 mmol L⁻¹ day⁻¹). Under anoxic conditions, rates were significantly lower and dominated by chemical transformation (0.09 mmol L⁻¹ day⁻¹; p < 0.0001). The addition of KNO₃ to anoxic incubations increased microbial thiosulfate oxidation 2.5-fold (0.23 mmol L⁻¹ day⁻¹; p = 0.0474), with complete transformation to SO₄²⁻ coupled to NO₃⁻ consumption, pointing to the activity of sulfur-oxidizing bacteria (SOB) under nitrate-reducing conditions. Importantly, in the presence of KNO₃, a decrease in sedimentary sulfides was associated with an increase in S⁰, which indicates the potential for microbially mediated oxidation of sulfide minerals and ARD generation. Furthermore, the comparative analysis of sediments from other anthropogenic aquatic habitats demonstrated high similarities with respect to viable SOB counts and corresponding activity rates. Full article

There is an urgent environmental need to remediate waste water. In this study, the use of surface-modified nanocrystalline cellulose (CNC) to remove polluting drugs or chemicals from waste water and oil sands tailing ponds has been investigated. CNC was modified by either surface adsorbing cationic or hydrophobic species or by covalent methods and integrated into membrane water filters. The removal of either diclofenac or estradiol from water was studied. Similar non-covalently modified CNC materials were used to flocculate clays from water or to bind naphthenic acids which are contaminants in tailing ponds. Estradiol bound well to hydrophobically modified CNC membrane filter systems. Similarly, diclofenac (anionic drug) bound well to covalently cationically modified CNC membranes. Non-covalent modified CNC effectively flocculated clay particles in water and bound two naphthenic acid chemicals (negatively charged and hydrophobic). Modified CNC integrated into water filter membranes may remove drugs from waste or drinking water and contaminants from tailing ponds water. Furthermore, the ability of modified CNC to flocculate clays particles and bind naphthenic acids may allow for the addition of modified CNC directly to tailing ponds to remove both contaminants. CNC offers an environmentally friendly, easily transportable and disposable novel material for water remediation purposes. Full article

Oil sands surface mining in Alberta has generated over a billion cubic metres of waste, known as tailings, consisting of sands, silts, clays, and process-affected water that contains toxic organic compounds and chemical constituents. All of these tailings will eventually be reclaimed and integrated into one of two types of mine closure landforms: end pit lakes (EPLs) or terrestrial landforms with a wetland feature. In EPLs, tailings deposits are capped with several metres of water while in terrestrial landforms, tailings are capped with solid materials, such as sand or overburden. Because tailings landforms are relatively new, past research has heavily focused on the geotechnical and biogeochemical characteristics of tailings in temporary storage ponds, referred to as tailings ponds. As such, the geochemical stability of tailings landforms remains largely unknown. This review discusses five mechanisms of geochemical change expected in tailings landforms: consolidation, chemical mass loading via pore water fluxes, biogeochemical cycling, polymer degradation, and surface water and groundwater interactions. Key considerations and knowledge gaps with regard to the long-term geochemical stability of tailings landforms are identified, including salt fluxes and subsequent water quality, bioremediation and biogenic greenhouse gas emissions, and the biogeochemical implications of various tailings treatment methods meant to improve geotechnical properties of tailings, such as flocculant (polyacrylamide) and coagulant (gypsum) addition. Full article

iso-Alkanes, a major fraction of the solvents used in bitumen extraction from oil sand ores, are slow to biodegrade in anaerobic tailings ponds. We investigated methanogenic biodegradation of iso-alkane mixtures comprising either three (2-methylbutane, 2-methylpentane, 3-methylpentane) or five (2-methylbutane, 2-methylpentane, 2-methylhexane, 2-methylheptane, 2-methyloctane) iso-alkanes representing paraffinic and naphtha solvents, respectively. Mature fine tailings (MFT) collected from two tailings ponds, having different residual solvents (paraffinic solvent in Canadian Natural Upgrading Limited (CNUL) and naphtha in Canadian Natural Resources Limited (CNRL)), were amended separately with the two mixtures and incubated in microcosms for ~1600 d. The indigenous microbes in CNUL MFT produced methane from the three-iso-alkane mixture after a lag of ~200 d, completely depleting 2-methylpentane while partially depleting 2-methylbutane and 3-methylpentane. CNRL MFT exhibited a similar degradation pattern for the three iso-alkanes after a lag phase of ~700 d, but required 1200 d before beginning to produce methane from the five-iso-alkane mixture, preferentially depleting components in the order of decreasing carbon chain length. Peptococcaceae members were key iso-alkane-degraders in both CNUL and CNRL MFT but were associated with different archaeal partners. Co-dominance of acetoclastic (Methanosaeta) and hydrogenotrophic (Methanolinea and Methanoregula) methanogens was observed in CNUL MFT during biodegradation of three-iso-alkanes whereas CNRL MFT was enriched in Methanoregula during biodegradation of three-iso-alkanes and in Methanosaeta with five-iso-alkanes. This study highlights the different responses of indigenous methanogenic microbial communities in different oil sands tailings ponds to iso-alkanes. Full article

In Alberta’s Athabasca oil sands region (AOSR), over 1.25 billion m³ of tailings waste from the bitumen extraction process are stored in tailings ponds. Fugitive emissions associated with residual hydrocarbons in tailings ponds pose an environmental concern and include greenhouse gases (GHGs), reduced sulphur compounds (RSCs), and volatile organic compounds (VOCs). Froth treatment tailings (FTT) are a specific type of tailings waste stream from the bitumen froth treatment process that contains bioavailable diluent: either naphtha or paraffins. Tailings ponds that receive FTT are associated with the highest levels of biogenic gas production, as diverse microbial communities biodegrade the residual diluent. In this review, current literature regarding the composition, chemical analysis, and microbial degradation of FTT and its constituents is presented in order to provide a more complete understanding of the complex chemistry and biological processes related to fugitive emissions from tailings ponds receiving FTT. Characterizing the composition and biodegradation of FTT is important from an environmental perspective to better predict emissions from tailings ponds and guide tailings pond management decisions. Full article

Tailings ponds in northeastern Alberta, Canada contain massive amounts of oil sands process water (OSPW) that cannot currently be released due to the toxicity of some components. Limited space and the need for reclamation of oil sands operation sites will necessitate the release of OSPW in the near future. Knowledge of the composition and toxicity of OSPW is lacking yet is crucial for both risk assessment and management planning. This study examines chronic toxicity of a mixture of OSPW components sodium naphthenate and naphthenic acid (NA) to nymphs of the mayfly Hexagenia spp. in control and polycyclic aromatic hydrocarbons (PAH)-spiked sediment treatments. The objective of this study was to determine whether the addition of the PAH-spiked sediment significantly contributed to or masked responses of these sensitive mayflies to mixtures of NA. Mean survival in nymphs exposed to NA and PAH-spiked sediment treatments was reduced by 48% compared to those exposed to the NA mixture alone. Lethal responses were observed in all of the PAH-spiked sediment treatments. However, within PAH-spiked and control sediment treatments, there was no significant difference in nymph survival due to NA concentration, indicating that changes in survivorship were predominantly a reflection of increased mortality associated with sediment PAHs and not to the NA mixture treatment. Sublethal effects on body segment ratios suggest that mayflies exposed to NA and PAH-spiked sediment, as well as those exposed to the highest NA concentration tested (1 mg/L) and control sediment, made developmental trade-offs in order to emerge faster and escape a stressful environment. These results reveal that the release of OSPW to the surrounding environment could cause a reduction in mayfly populations. Mayflies provide ecosystem services and are an important food source for higher trophic levels in both the aquatic and terrestrial communities. Full article

Hydrocarbon extraction and exploitation is a global, trillion-dollar industry. However, for decades it has also been known that fossil fuel usage is environmentally detrimental; the burning of hydrocarbons results in climate change, and environmental damage during extraction and transport can also occur. Substantial global efforts into mitigating this environmental disruption are underway. The global petroleum industry is moving more and more into exploiting unconventional oil reserves, such as oil sands and shale oil. The Albertan oil sands are one example of unconventional oil reserves; this mixture of sand and heavy bitumen lying under the boreal forest of Northern Alberta represent one of the world’s largest hydrocarbon reserves, but extraction also requires the disturbance of a delicate northern ecosystem. Considerable effort is being made by various stakeholders to mitigate environmental impact and reclaim anthropogenically disturbed environments associated with oil sand extraction. In this review, we discuss the eukaryotic microbial communities associated with the boreal ecosystem and how this is affected by hydrocarbon extraction, with a particular emphasis on the reclamation of tailings ponds, where oil sands extraction waste is stored. Microbial eukaryotes, or protists, are an essential part of every global ecosystem, but our understanding of how they affect reclamation is limited due to our fledgling understanding of these organisms in anthropogenically hydrocarbon-associated environments and the difficulties of studying them. We advocate for an environmental DNA sequencing-based approach to determine the microbial communities of oil sands associated environments, and the importance of studying the heterotrophic components of these environments to gain a full understanding of how these environments operate and thus how they can be integrated with the natural watersheds of the region. Full article