Search Results (8)

A thorough understanding of the lignin–carbohydrate complex (LCC) structure has a significant meaning in the high-value utilization of lignocellulose. In this work, the complex (DHPKGC) was obtained by an addition reaction between konjac glucomannan (KGM) and quinone methides generated in the synthesis of dehydrogenation polymers (DHPs) to simulate the formation of LCCs. The effect of pH on the prepared DHPKGC was investigated. The structure of the DHPKGC was characterized by Fourier Transform Infrared (FTIR), ¹³C-Nuclear Magnetic Resonance (¹³C-NMR), and two-dimensional Heteronuclear Single Quantum Coherence Nuclear Magnetic Resonance (2D HSQC NMR) analyses. The results indicated the pH of 4.0 was conducive to the polymerization reaction between DHPs and oxidized KGM by the TEMPO/NaClO/NaBr system. In addition, the resultant DHPKGC was connected by benzyl ester linkages. Overall, this study aims to gain greater insight into the process of LCC formation in plants. Full article

Hemicellulose extracted by alkali treatment is of interest because of the advantages of its intact sugar structure and high degree of polymerization. However, the hemicellulose extracted by alkali treatment contained more lignin fragments and the presence of a lignin–carbohydrate complex (LCC), which affected the isolation and purification of hemicellulose and its comprehensive utilization. Therefore, the evaluation of the LCC structure of different types of lignocellulosic resources is of great significance. In this study, the LCC structures of hardwoods and Gramineae were enriched in alkaline systems. Information on the composition, structural proportions, and connection patterns of LCC samples was discussed. The similarities and differences between the LCC structures of different units of raw materials were comparatively studied. The results indicated that the monosaccharide fractions were higher in the LCC of Gramineae compared to hardwoods. The composition of the lignin fraction was dominated by G and S units. The phenyl glycosidic (PhGlc) bond is the predominant LCC linkage under alkali-stabilized conditions. In addition, Gramineae PhGlc types are more numerous compared to hardwoods. The results of the study provide insights into the differences in the chemical composition and structural features of LCC in different plants and provide important guidance for the optimization of the process of purifying hemicellulose. Full article

To further our understanding of the change in association between lignin and carbohydrates after kraft pulping, isotope-labeled kraft pulp (KP) was prepared using ¹³C and D double-isotope-labeled wheat straw, and it was subjected to enzymatic hydrolysis and ionic liquid treatment to explore the linkages between lignin and carbohydrate complexes in wheat straw. Isotope abundance determination showed that ¹³C and D abundances in the experimental groups were substantially higher than those in the control group, indicating that the injected exogenous coniferin-[α-¹³C], coniferin-[γ-¹³C], and d-glucose-[6-D₂] were effectively absorbed and metabolized during wheat internode growth. Solid-state CP/MAS ¹³C-NMR spectroscopy showed that lignin was mainly linked to polysaccharides via acetal, benzyl ether, and benzyl ester bonds. Kraft pulp (KP) from the labeled wheat straw was degraded by cellulase. The obtained residue was fractionated using the ionic liquid DMSO/TBAH to separate the cellulose–lignin complex (KP-CLC) and xylan–lignin complex (KP-XLC). X-ray diffractometer determination showed that the KP-CLC regenerated cellulose type II from type I after the ionic liquid conversion. The ¹³C-NMR spectrum of Ac-En-KP-CLC showed that the cellulose–lignin complex structure was chemically bonded between the lignin and cellulose through acetal and benzyl ether bonds. The ¹³C-NMR spectrum of En-KP-XLC showed a lignin–hemicellulose complex structure, wherein lignin and xylan were chemically bonded by benzyl ether and acetal bonds. These results indicate that the cross-linking between lignin and carbohydrates exists in lignocellulosic fibers even after kraft pulping. Full article

Acid saccharification of hemicelluloses offers promising pathways to sustainably diversify the revenue of the lignocellulose biorefinery industry. Electrodialysis to separate inorganic acids from acid hydrolysate in the hemicellulose saccharification process could realize the recovery of sulfuric acid, and significantly reduced the chemical consumption than the traditional ion exchange resins method. In this work, the deacidification of corncob acid hydrolysate was conducted by a homemade electrodialysis apparatus. The results showed that: (1) more than 99% of acid can be removed through the electrodialysis process; (2) A non-negligible membrane fouling occurred during the electrodialysis process, which aggravated with the repeated batch running The final global system resistance rose from 15.8 Ω (1st batch) to 43.9 Ω (10th batch), and the treatment ending time was delayed from 120 min (1st batch) to 162 min (10th batch); (4) About 90% of protein, 70% of ferulate acid, and 80% of p-coumarate acid precipitated from the corncob acid hydrolysate during the electrodialysis process. The zeta potential of corncob acid hydrolysate changed from a positive value to a negative value, and an isoelectric point around pH 2.3 was reached. HSQC, FTTR, and GPC, along with SEM and EDS analysis, revealed that the fouling layers mostly consisted of hydrolysates of protein and lignin. The result of HSQC indicated that the membrane foulant may exist in the form of lignin–carbohydrate complexes, as the lignin component of the membrane foulant is in the form of p-coumarate and ferulate. From the result of FTIR, a strong chemical bonding, such as a covalent linkage, existed between the lignin and protein in the membrane foulant. Throughout the electrodialysis process, the increased pH decreased the stability of colloidal particles, including lignin and proteins. Destabilized colloidal particles started to self-aggregate and form deposits on the anion exchange membrane’s surface. Over time, these deposits covered the entire membrane surface and the spaces between the membranes. Eventually, they attached to the surface of the cation exchange membrane. In the end, a suggestion to control and minimize membrane fouling in this process was discussed: lower pH as a process endpoint and a post-treatment method. Full article

To elucidate the chemical linkages between lignin and carbohydrates in ginkgo cell walls, ¹³C-²H-enriched cell wall-dehydrogenation polymers (CW-DHP) were selectively prepared with cambial tissue from Ginkgo biloba L. by feeding D-glucose-[6-²H₂], coniferin-[α-¹³C], and phenylalanine ammonia-lyase (PAL) inhibitor. The abundant detection of ¹³C and ²H confirmed that D-glucose-[6-²H₂] and coniferin-[α-¹³C] were involved in the normal metabolism of ginkgo cambial cells that had been effectively labelled with dual isotopes. In the ginkgo CW-DHP, ketal and ether linkages were formed between the C-α of lignin side chains and carbohydrates, as revealed by solid state CP/MAS ¹³C-NMR differential spectroscopy. Furthermore, the DMSO/TBAH ionic liquids system was used to fractionate the ball-milled CW-DHP into three lignin-carbohydrate complex (LCC) fractions: glucan–lignin complex (GL), glucomannan–lignin complex (GML), and xylan–lignin complex (XL). The XRD determination indicated that the cellulose type I of the GL was converted into cellulose type II during the separation process. The molecular weight was in the order of Ac-GL > Ac-GML > XL. The ¹³C-NMR and ¹H-NMR differential spectroscopy of ¹³C-²H-enriched GL fraction indicated that lignin was linked with cellulose C-6 by benzyl ether linkages. It was also found that there were benzyl ether linkages between the lignin side chain C-α and glucomannan C-6 in the ¹³C-²H-enriched GML fraction. The formation of ketal linkages between the C-α of lignin and xylan was confirmed in the ¹³C-²H-enriched XL fraction. Full article

Lignin and lignin-carbohydrate complexes are important polymers for lignocellulosic biorefinery and functional materials, but those in ginkgo shells are not effectively analyzed and exploited. Based on this background, milled wood lignins (MWL_ML and MWL_FZ) and lignin-carbohydrate complexes (LCC_ML and LCC_FZ) were isolated from the shells of Ginkgo biloba L. cv. Damaling (ML) and Ginkgo biloba L. cv. Dafozhi (FZ) correspondingly, and were structurally characterized by comprehensive NMR spectroscopy. The results showed that ginkgo shells exhibited higher lignin (42%) and xylan (20%) content than general softwood species. Isolated MWLs were rich in guaiacyl units with the presence of ferulates and p-coumarates, and the molecular formula was C₉H_7.93O_2.73(OCH₃)_0.81 and C₉H_7.87O_2.76(OCH₃)_0.88 for MWL_ML and MWL_FZ, respectively. Phenolic hydroxyl of MWL_ML (1.38 mmol/g) and MWL_FZ (1.23 mmol/g) in ginkgo shells was much less than that in general softwoods, suggesting a higher etherification and condensation degree of ginkgo shells lignin, and β-5′, α-O-4′, and 4-O-5′ bonds were the main condensed structures. O-acetylated β-d-xylopyranoside and β-d-mannopyranoside were the main polysaccharides associated with lignin, and the acetyl groups frequently acylate the C₂ and C₃ positions. LCC_ML had more phenyl glycoside (0.035/Ar) and less γ-ester (0.026/Ar) linkages than LCC_FZ. Full article

A two-step pretreatment using NaOH and ozone was performed to improve the enzymatic hydrolysis, compositions and structural characteristics of corn stover. Comparison between the unpretreated and pretreated corn stover was also made to illustrate the mechanism of the combined pretreatment. A pretreatment with 2% (w/w) NaOH at 80 °C for 2 h followed by ozone treatment for 25 min with an initial pH 9 was found to be the optimal procedure and the maximum efficiency (91.73%) of cellulose enzymatic hydrolysis was achieved. Furthermore, microscopic observation of changes in the surface structure of the samples showed that holes were formed and lignin and hemicellulose were partially dissolved and removed. X-ray Diffraction (XRD), Fourier Transform Infrared Spectroscopy (FTIR) and Cross-Polarization Magic Angle Spinning Carbon-13 Nuclear Magnetic Resonance (CP/MAS ¹³C-NMR) were also used to characterize the chemical structural changes after the combined pretreatment. The results were as follows: part of the cellulose I structure was destroyed and then reformed into cellulose III, the cellulose crystal indices were also changed; a wider space between the crystal layer was observed; disruption of hydrogen bonds in cellulose and disruption of ester bonds in hemicellulose; cleavage of bonds linkage in lignin-carbohydrate complexes; removal of methoxy in lignin and hemicellulose. As a result, all these changes effectively reduced recalcitrance of corn stover and promoted subsequent enzymatic hydrolysis of cellulose. Full article

The lignin-carbohydrate complex (LCC) was isolated from milled wood lignin of 2- and 24-month-old crude bamboo (Neosinocalamus affinis) culms using acetic acid (AcOH) and then characterized. The results have shown that the LCC preparation from 2-month-old bamboo (L₂) exhibited a slightly lower molecular weight than the LCC preparation from the 24-month-old bamboo (L₂₄). Further studies using Fourier transform infrared spectroscopy (FT-IR) and heteronuclear single quantum coherence (2D-HSQC) NMR spectra analyses indicate that the LCC preparations included glucuronoarabinoxylan and G-S-H lignin-type with G>S>>H. The content of the S lignin units of LCC in the mature bamboo was always higher than in the young bamboo. Combined with sugar composition analysis, the contents of phenyl glycoside and ether linkages in the L₂₄ preparation were higher than in the L₂ preparation; however, there was a reverse relationship of ester LCC bonds in L₂ and L₂₄. Lignin–xylan was the main type of LCC linkage in bamboo LCCs. Lignin–lignin linkages in the LCC preparations included β-β, β-5 and β-1 carbon-to-carbon, as well as β-O-4 ether linkages, but β-1 linkages were not present in L₂. Full article