Search Results (2)

The increasing demand for sustainable materials has driven interest in biocomposites that incorporate low-value agricultural residues to offset the use of virgin plastics. The study investigated the production of blend pellets from raw and torrefied almond shells and post-consumer plastic waste as a potential feedstock for biocomposite and biofuels applications. Almond shells were torrefied in a lab-scale fixed-bed reactor at 300 °C for 30 min prior to the pelleting tests. High-density polyethylene (HDPE) and polypropylene (PP) wastes were size-reduced in a Crumbler (rotary shear grinder) fitted with a 2 mm head and a 2 mm screen to remove the fines. A portion of the crumbled HDPE, and torrefied almond shells were further ground in a Wiley mill fitted with 2 and 1 mm screens for flat die pelleting tests. The flat die pellet mill used for testing had a 6 mm die and a length-to-diameter (L/D) ratio of 2.0. The blend ratio consisted of 30% torrefied almond shells and 70% HDPE, with a 10% starch binder. The measured pellet properties include unit, bulk and tap densities, durability, and expansion ratio. The bulk density of the blend pellets ranged from 360 to 410 kg/m³, and durability ranged from 80% to 88%. The blend pellet unit density ranged from 830 to 880 kg/m³. The blend pellets produced using crumbled HDPE, PP and raw and torrefied almond shells in a ring die pilot-scale pellet mill with an L/D ratio of 6 and steam conditioning exhibit similar densities to those of HDPE pellets produced using a flat die pellet mill, albeit with lower durability. The study indicated that a smaller grind size and preheating the blend before pelleting produce blend pellets with higher density and greater durability. Full article

Corn stover and plastic waste, severely underutilized feedstocks generated in the U.S., could be co-pelletized to produce fuel for cement production. High-density polyethylene bags (0–25% in 5% increments, dry basis) and corn stover were co-pelletized using a flat ring pellet mill with die diameters of 6 and 8 mm. Physical and chemical properties were assessed to determine pellet quality. These results informed techno-economic and life cycle greenhouse gas emissions (GHGe) analyses for a Midwestern plant producing 400,000 metric tons of pellets annually. The system boundary included feedstock acquisition at the pellet plant, size reduction, co-pelletization, and transportation of the pellets to the cement plant by rail. Total resource requirements in terms of raw materials, labor, fuel, equipment, the facility, and utilities were estimated. It was determined that the pellets would be delivered to the cement plant at USD 112.4–138.6/t pellets. The life cycle analysis estimated a total GHGe of 1621.1–1753.1 kg CO₂e/t pellets associated with the pellet production, transportation, and combustion. The results suggest that substituting 25% of the thermal energy requirement of a cement plant with a 1.1 million t clinker annual production capacity with plastic–stover pellets would reduce the GHGe by 2.8% compared to 100% of the total energy requirement supplied by coal. Full article