Search Results (4)

Control subarea division is essential for coordinated signal control, but methods based mainly on local correlation or static topology may not adequately capture traffic-state propagation under dynamic traffic loading. This study proposes a control subarea division method that explicitly models traffic-state propagation by integrating state-guided colored random walk and path entropy analysis. Intersection correlation degree and traffic state are used to construct a state-guided colored random walk process, in which transition probabilities are updated according to network connectivity and traffic-state consistency. Path entropy characterizes propagation uncertainty, and control subareas are identified by minimizing the distribution discrepancy between node-level and subarea-level path responses. To compare partitioning schemes, five complementary metrics were adopted: variance reduction rate of spatial delay, delay reduction rate, congestion mitigation index, stop reduction rate, and queue reduction rate. A VISSIM microsimulation model with dynamic traffic loading was developed to compare the proposed method with the Whitson and Fast Newman methods. The proposed method achieved the best performance across all five metrics, with values of 41.47%, 23.77%, 25.96%, 23.59%, and 15.08%, respectively. These results indicate that the proposed method improves spatial balance and network efficiency while mitigating bottlenecks, reducing stops, and suppressing queue accumulation. Full article

Traffic state classification and relevance calculation at intersections are both difficult problems in traffic control. In this paper, we propose an intersection relevance model based on a temporal graph attention network, which can solve the above two problems at the same time. First, the intersection features and interaction time of the intersections are regarded as input quantities together with the initial labels of the traffic data. Then, they are inputted into the temporal graph attention (TGAT) model to obtain the classification accuracy of the target intersections in four states—free, stable, slow moving, and congested—and the obtained neighbouring intersection weights are used as the correlation between the intersections. Finally, it is validated by VISSIM simulation experiments. In terms of classification accuracy, the TGAT model has a higher classification accuracy than the three traditional classification models and can cope well with the uneven distribution of the number of samples. The information gain algorithm from the information entropy theory was used to derive the average delay as the most influential factor on intersection status. The correlation from the TGAT model positively correlates with traffic flow, making it interpretable. Using this correlation to control the division of subareas improves the road network’s operational efficiency more than the traditional correlation model does. This demonstrates the effectiveness of the TGAT model’s correlation. Full article

Transit priority control is not only an important means for improving the operating speed and reliability of public transport systems, but it is also a key measure for promoting green and sustainable urban transportation development. A review of signal intersection transit priority control strategy in a connected vehicle environment is conducive to discovering important research results on transit priority control at home and abroad and will promote further developments in urban public transport. This study analyzed and reviewed signal intersection transit priority control at four levels: traffic control sub-area divisions, transit signal priority (TSP) strategy, speed guidance strategy, and the impacts of intersection signal control on carbon emissions. In summary, the findings were the following: (1) In traffic control sub-area divisions, the existing methods were mainly based on the similarity of traffic characteristics and used clustering or search methods to divide the intersections with high similarity into the same control sub-areas. (2) The existing studies on the TSP control strategy have mainly focused on transit priority control based on fixed phase sequences or phase combinations under the condition of exclusive bus lanes. (3) Studies on speed guidance strategy were mainly based on using constant bus speeds to predict bus arrival times at intersection stop lines, and it was common to guide only based on bus speed. (4) The carbon emissions model for vehicles within the intersection mainly considered two types of vehicles, namely, fuel vehicles and pure electric vehicles. Finally, by analyzing deficiencies in the existing studies, future development directions for transit priority control are proposed. Full article

In order to identify the scope of active traffic control regions and improve the effect of active traffic control, this paper proposes a dynamic partitioning method of area boundaries based on benchmark intersections, taking into account the saturation, homogeneity, and correlation of intersections in the region. First, a boundary indicator correlation model was established. Next, benchmark intersections were selected based on evaluation indicators, such as traffic speed and queue length. Then, the boundary of the control region is initially defined based on the selected reference intersection, through a combination of the improved Newman algorithm. Subsequently, a spectral clustering algorithm is used to obtain the boundaries of the optimal active control subregions. Finally, a city road network is used as the study object for analysis and verification under the premise of implementing active traffic control. The results show that compared with the intersection clustering algorithm method and the boundary control subdivision method, the control effect indicators, such as the average delay and the average number of stops, have a great optimization improvement. Thus, the proposed method of regional borders combines the actual traffic flow characteristics efficiently to make a more accurate real-time dynamic division of the road network sub-areas. Full article