Search Results (4)

The mixing of hydrothermal vent fluids with deep ocean water and near-vent pelagic matter results in particle populations with a complex composition consisting of hydrothermally derived, rock-forming, and biogenic particles. This study is the first investigation of deep sediment trap material collected at the Jan Mayen hydrothermal vent field area at 71° N and 6° W of the southernmost Mohns Ridge in the Norwegian–Greenland Sea. This area is characterized by high magmatic activity, axial volcanic ridges, and mafic-hosted volcanogenic massive sulfide deposits. Data on sinking particle fluxes from two hydrothermal settings, the Troll Wall and Soria Moria vent fields, located about 4 km apart, are discussed in the article. In particular, the study emphasize the differences between two hydrothermal settings from each other that demonstrate the geodiversity of hydrothermal processes within the relatively shallow Jan Mayen hydrothermal vent field area affected by the Iceland and Jan Mayen hotspots. The fluxes of sinking hydrothermally derived particles (barite, gypsum, non-crystalline Fe-Si oxyhydroxides, and Fe, Zn, and Cu sulfides) obtained at the Jan Mayen hydrothermal vents made it possible to elucidate the characteristic features of their buoyancy plumes and compare them with similar data reported for other submarine hydrothermal systems. In terms of the composition of the deep-sea hydrothermal particles from buoyant plumes, the studied vent fields are most similar to the Menez Gwen and Lucky Strike vent fields affected by the Azores hotspot. The supply of hydrothermally derived matter is accompanied by normal pelagic/hemipelagic sedimentation, which is dominated by biogenic particles, especially in the upper water layers. Full article

This article discusses the results of a fluid inclusion studies in barite collected at the Jan Mayen vent field area (Troll Wall and Perle and Bruse) and Loki’s Castle vent field on the Mohns Ridge segment of the Arctic Mid-Ocean Ridge. Three mafic-hosted volcanogenic massive sulfide deposits were examined within the active vent fields that adequately correspond to the geological settings of ultraslow-spreading ridges and P–T conditions. Hydrothermal sediments were investigated to determine the temperature and salinity of the fluids responsible for barite precipitation. The hydrothermal origin of the barite was confirmed by its morphology. Fluid inclusions are two-phase and homogenize into the liquid phase on heating at temperatures below 287 °C. The salt concentration in fluids trapped in inclusions is 2.6–4.4 wt.% NaCl eq. The crystallization temperatures varied from 276 °C to 119 °C and from 307 °C to 223 °C for the Jan Mayen and Loki’s Castle vent fields, respectively. The data obtained allowed us to confirm evidence of fluid phase separation in the hydrothermal systems and to expand our knowledge of the temperature and salinity of mineral fluids previously known from recent direct measurements during the cruises within the G.O. Sars research vessel. The fluid inclusions data obtained from barites emphasize the fluid features characteristic of volcanogenic massive sulfide deposits, the similarities and differences among the studied hydrothermal sites and allow comparisons with similar products from other active hydrothermal systems. Full article

The results of the study of hydrocarbons (HCs): aliphatic (AHCs) and polycyclic aromatic hydrocarbons (PAHs) in bottom sediments (2019 and 2020, cruises 75 and 80 of the R/V Akademik Mstislav Keldysh) in the Norwegian-Barents Sea basin: Mohns Ridge, shelf Svalbard archipelago, Sturfiord, Medvezhinsky trench, central part of the Barents Sea, Novaya Zemlya shelf, Franz Victoria trough are presented. It has been established that the organo-geochemical background of the Holocene sediments was formed due to the flow of sedimentary material in the coastal regions of the Barents Sea on shipping routes. The anthropogenic input of HCs into bottom sediments leads to an increase in their content in the composition of C_org (in the sandy sediments of the Kaninsky Bank at an AHC concentration up to 64 μg/g, when its proportion in the composition of C_org reaches 11.7%). The endogenous influence on the of the Svalbard archipelago shelf in Sturfiord and in the Medvezhinsky Trench determines the specificity of local anomalies in the content and composition of HCs. This is reflected in the absence of a correlation between HCs and the grain size composition of sediments and C_org content, as well as a change in hydrocarbon molecular markers. At the same time, the sedimentary section is enriched in light alkanes and naphthalene’s that may be due to emission during point discharge of gas fluid from sedimentary rocks of the lower stratigraphic horizons and/or sipping migration. Full article

Loki’s Castle on the Arctic Mid-Ocean Ridge (AMOR) is an area of possible seafloor massive sulphide (SMS)-style mineralisation under Norwegian jurisdiction, which, due to mounting social pressure, may be a strategic future source of base and precious metals. The purpose of this study is to characterise mineralised material from a hydrothermal vent system on the AMOR in detail for the first time, and to discuss the suitability of methods used; reflected light microscopy, X-ray diffraction (XRD), whole rock geochemistry, electron probe micro-analysis (EPMA), and QEMSCAN. The primary sulphide phases, identifiable by microscopy, are pyrite and marcasite with minor pyrrhotite and galena, but multiple samples from the Loki’s Castle contain economically interesting quantities of copper (hosted in isocubanite and chalcopyrite) and zinc (hosted in sphalerite), as well as silver and gold. This reinforces the notion that slow spreading ridges may host significant base metal deposits. Micro-textures (chalcopyrite inclusions and exsolutions in sphalerite and isocubanite respectively) are typically undefinable by QEMSCAN, and require quantitative measurement by EPMA. QEMSCAN can be used to efficiently generate average grain size and mineral association data, as well as composition data, and is likely to be a powerful tool in assessing the effectiveness of SMS mineral processing. Full article