AppliedPhys, Volume 2, Issue 1 (March 2026) – 3 articles

Antimicrobial peptides (AMPs) are found widely as part of nonspecific immune defenses. One class of AMPs forms stable pores in membranes, including the two chemically distinct membranes found in the Gram-negative cell envelope. As the Gram-negative cell envelope is a significant barrier to drug development, some have hypothesized that these AMPs could be used clinically, either alone or in combination with other drugs that cannot cross the Gram-negative cell envelope on their own. Here, we use atomic force microscopy (AFM), fluorescence spectroscopy, and fluorescence microscopy to elucidate the biomechanical changes that occur in Escherichia coli treated with various concentrations of the pore-forming AMP magainin 2 (MAG2). We find that near the minimum inhibitory concentration, MAG2 induces a loss of cell stiffness and a decrease in cell height consistent with pore formation and cellular leakage. Surprisingly, treatment with high concentrations of MAG2 leads to cells becoming stiffer and increasing in height. We confirmed that MAG2 forms pores at high concentrations using a standard propidium iodide (PI) uptake assay, in which PI is added to a cell suspension and is detected only after pores form in the cell membrane. However, when PI was added after 30 min of treatment with high concentrations of MAG2, less PI fluorescence was observed than in the standard PI uptake assay, indicating that movement across the cell membrane was restricted at the end of our experiments. We also observed that the modulus of the cell envelope increased with increasing MAG2 concentration, consistent with greater packing of MAG2 into the cell envelope membranes. Finally, our AFM images in air revealed that cells formed blebs when treated with high concentrations of MAG2. These data suggest that MAG2 initially forms pores at high concentrations, but as membrane packing increases, movement across the cell envelope becomes restricted. Understanding the concentration-dependent restriction of movement across the cell envelope could be important if AMPs are to be used clinically. Full article

This paper presents a dynamic analysis of ultrasonic motors (USMs) used in camera lens systems, which achieve high-precision motion via piezoelectric stators rather than electromagnetic components. The study focuses on the coupling of radial and tangential vibrations that create elliptical particle trajectories, driving the rotor through friction. The methodology is divided into two stages: Stage I: A discrete mass-spring model simplifies the coupled motion to a single degree of freedom. This analytical approach approximates natural frequencies and identifies modal degeneracy and the upper limits of representable modes via the Nyquist–Shannon criterion. Stage II: Based on continuous ring elasticity theory, the research establishes the actual coupled modal shapes. This stage demonstrates the manner in which kinematically linked displacements result in an elliptical trajectory on the stator surface. The analytical findings are validated using Finite Element Analysis (FEA) in CATIA. The simulations confirm the degeneracy of natural modes, proving that biphasic excitation is strictly necessary to maintain the progressive waves required for USM operation. Full article

Rapid evaluation of water toxicity requires biological methods capable of detecting sub-lethal physiological changes without depending on chemical identification. Conventional microscopy-based bioassays are limited by low throughput and difficulties in observing small, transparent and fast-moving microorganisms. This study applies a laser-biospeckle, non-imaging microbioassay to assess the motility responses of Paramecium caudatum and Euglena gracilis exposed to two organic pollutants, trichloroacetic acid (TCAA) and acephate. Dynamic speckle patterns were recorded using a 638 nm laser diode (Thorlabs Inc., Tokyo, Japan) and a CCD camera (Gazo Co., Ltd., Tokyo, Japan) at 60 fps for 120 s. Correlation time, derived from temporal cross-correlation analysis, served as a quantitative indicator of motility. Exposure to TCAA (0.1–50 mg/L) produced strong concentration-dependent inhibition, with correlation time increasing up to 16-fold at 500× PL in P. caudatum (p < 0.01), whereas E. gracilis showed a delayed response, with significant inhibition only above 250× PL. In contrast, acephate exposure (0.036–3.6 mg/L) induced motility enhancement in both species, reflected by decreases in correlation time of up to 57% in P. caudatum and 40% in E. gracilis at 100× PL. Acute trends diminished after 24–48 h, indicating time-dependent physiological adaptation. These results demonstrate that biospeckled-derived correlation time sensitively captures both inhibitory and stimulatory behavioral responses, enabling real-time, high-throughput water toxicity screening without microscopic imaging. The method shows strong potential for integration into automated water-quality monitoring systems. Full article