1. Introduction
Agriculture imparts a vital role in the economy of Pakistan. Pakistan has the largest irrigation system in the world that contributes towards agricultural production [
1]. The agriculture fulfills 40% of the world’s food requirements by consuming 60% of its fresh water reserves. However, as population increases the demand for food also increases and the gap between demand and supply also widens. This gap needs to be filled by adopting new techniques for sowing crops to provide a “high-yield per drop of water” [
2].
Wheat is the major crop of every agricultural country. It is very important for socio-economic growth. Wheat is required for food for both humans and animals. Wheat has a positive impact on a country’s GDP. If there is shortage of wheat in a country, t will negatively affect the economic conditions as well as the population’s food needs will not be met. Therefore, proper management strategies need to be adopted for the healthy growth and good yield of wheat to ensure a country’s growth. Water shortage is a critical global issue, with developed countries also facing this problem. Such countries have reduced conventional farming methods and adopted new techniques to conserve soil moisture and soil water in the root zone [
3]. They have applied water directly into the root zone where plants can more efficiently use this water. Certain modern techniques are known today which have been adopted by developed countries and are receiving the benefits from these techniques. The problem with modern techniques is that they require technical labor for effective use. The lack of technical labor also causes loss due to the improper use of instruments. Natural water-retention measures have also been adopted to increase water-retaining capacity of aquifers, soil, and aquatic and water-dependent ecosystems [
3,
4]. The agriculture sector utilizes the largest amount of water, almost 90%, and remaining water is utilized for household and industrial purposes [
5]. Water availability is crucial in Pakistan because the per capita water availability is reduced to 1000 m
3 per annum, internationally considered as the water shortage threshold value [
6]. In this highly stressed water profile, the major reasons which lead to the fall in the agriculture sector are population increases, rapid urbanization, and the reduction in agricultural land.
Under these circumstances, a field experiment was conducted on wheat crops using water-retention polymers in the Fouji Fertilizers Research Center of Faisalabad. The purpose of study was to develop the optimal irrigation schedules for wheat based on the different deficit levels and the following parameters were investigated, water productivity, crop yield and the development of an optimal irrigation schedule for wheat.
2. Methodology
The experimental site (geographical coordinates 31.430 N (latitude) and 73.07 degree E (longitude)) was selected at the FFC Dyyal Garh Faisalabad, Punjab, Pakistan. Wheat crop was studied from 2019–2020 to analyze the irrigation schedule and sowing techniques under RCBD statistical design (layout as shown in
Table 1). Insecticide was applied to the crop as a precautionary measure to prevent the attack of insects. Fungicide was also applied to protect the crop from fungi. The use of fertilizer is very important for the better growth of any crop. For this purpose, the liquid fertilizer NPK was applied to fulfil the deficiency of macro-nutrients in the soil. There were four treatments under flood irrigation and a control under a furrow irrigation system.
T1 = Recommended dose of N (standard urea), P (DAP) and K (MOP) fertilizers with four irrigations (with no application of water-retention polymers);
T2 = Recommended dose of N (neem-coated urea), P (DAP) and K (MOP) fertilizers with four irrigations (with no application of water-retention polymers);
T3 = Recommended dose of N (standard urea), P (DAP) and K (MOP) fertilizers with four irrigations (with 100% application of water-retention polymers);
T4 = Recommended dose of N (neem-coated urea), P (DAP) and K (MOP) fertilizers with four irrigations (with 100% application of water-retention polymers).
Soil and Water Sampling
The soil samples were taken from the field irrigated with groundwater flood irrigation. The water samples were collected from running tube-wells by adopting the standard procedure of sampling (
Figure 1).
3. Results
Crop Harvesting Parameters
The harvesting and growth parameters are crucial to assess the crop growth over time. These are indications of the crop conditions and helps in finding the results of the experimental site. The different parameters of wheat were tested as shown in
Figure 2,
Figure 3 and
Figure 4.
The results shows that plant height and spike length is higher when neem-coated urea was applied. The results show that while comparing standard urea and neem-coated urea, standard urea had a good effect on crop yield. Comparing price, standard urea is cheaper than that of neem-coated urea so is a better option for crop growth in Pakistan.
Histogram and Normal Probability Plot of Crop Harvesting Parameters
4. Conclusions
The results from the tensiometers show that water remained available to the crops when the recommended doses of the water-retention polymers were applied. The yield analysis showed that the yield was maximum with T3 treatment, where 100% of the recommended doses of the water-retention polymers with standard urea were applied. Crop conditions (plant height, grain weight, etc.) were good with T3 treatment of the recommended doses of the water-retention polymers.
Author Contributions
L.A. and Q.R. gathered and processed the data and performed the experiments. L.A. and M.R. supervised the experiments. L.A., A.R., M.R., Q.R. and M.S.I.Z. to analyzing the results and writing the manuscript. All authors have read and agreed to the published version of the manuscript.
Funding
This research received no external funding.
Institutional Review Board Statement
Not applicable.
Informed Consent Statement
Not applicable.
Data Availability Statement
The data is available upon request from the corresponding author.
Conflicts of Interest
The authors declare no conflict of interest.
References
- Rehman, A.; Jingdong, L.; Shahzad, B.; Chandio, A.A.; Hussain, I.; Nabi, G.; Iqbal, M.S. Economic perspectives of major field crops of Pakistan: An empirical study. Pac. Sci. Rev. B Humanit. Soc. Sci. 2015, 1, 145–158. [Google Scholar] [CrossRef] [Green Version]
- Iqbal, M.A.; Shen, Y.; Stricevic, R.; Pei, H.; Sun, H.; Amiri, E.; Penas, A.; del Rio, S. Evaluation of the FAO AquaCrop model for winter wheat on the North China Plain under deficit irrigation from field experiment to regional yield simulation. Agric. Water Manag. 2014, 135, 61–72. [Google Scholar] [CrossRef]
- Anjum, L.; Ahmad, N.; Arshad, M.; Ahmad, R. Effect of different irrigation and management practices on corn growth parameters. Pak. J. Life Soc. Sci. 2014, 12, 106–113. [Google Scholar]
- Erostate, M.; Huneau, F.; Garel, E.; Ghiotti, S.; Vystavna, Y.; Garrido, M.; Pasqualini, V. Groundwater dependent ecosystems in coastal Mediterranean regions: Characterization, challenges and management for their protection. Water Res. 2020, 172, 115461. [Google Scholar] [CrossRef] [PubMed]
- Qureshi, R.; Ashraf, M. Water security issues of agriculture in Pakistan. PAS Islamabad Pak. 2019, 1, 41. [Google Scholar]
- Nabi, R.B.S.; Tayade, R.; Hussain, A.; Kulkarni, K.P.; Imran, Q.M.; Mun, B.-G.; Yun, B.-W. Nitric oxide regulates plant responses to drought, salinity, and heavy metal stress. Environ. Exp. Bot. 2019, 161, 120–133. [Google Scholar] [CrossRef]
| Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2022 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).