A Highly Sensitive Potentiometric Amphetamine Microsensor Based on All-Solid-State Membrane Using a New Ion-Par Complex, [3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻ C₉H₁₃NH^+ †

Abstract

In the present work a highly sensitive ion-selective microelectrode for the detection of amphetamine is presented. For this purpose, a novel ion-par complex based on the metallocarborane, cobalt bis(dicarbollide) anion ([3,3′-Co(1,2-C₂B₉H₁₁)₂]⁻) coupled to amphetamonium cation has been prepared as the active site for amphetamine recognition. The prepared ion-par complex was incorporated to a PVC-type sensitive membrane. It was then drop-casted on the top of a gold microelectrode previously modified with a solid contact layer of polypyrrole. This novel amphetamine microsensor has provided excellent and quick response within the range 10⁻⁵ M to 10⁻³ M of amphetamine concentration, a limit of detection of 12 µM and a slope of 60.1 mV/decade. It was also found to be highly selective toward some potential interference compounds when compared to amphetamine.

1. Introduction

Nowadays, illicit drugs are considered one of the major concerns for developed countries due to the potential of bringing about all types of healthy problems. Although cannabis and cocaine are by far the most used narcotic, amphetamine and methylenedioxy-methamphetamine (MDMA) are becoming more and more popular. The last rapport from the European Monitoring Centre for Drug and Drug Consumption (MCDDC) estimated that about 1.3 and 2.1 million of person have consumed amphetamine and MDMA respectively in the last year [1]. Nevertheless, not only the healthy problems related to drug use are a matter of concern but also the black economy that it implies has become alarming. The estimated annual value of the retail market for amphetamine in Europe is about EUR 1.8 billion according to the MCDDC what means that 76 tonnes of amphetamine were consumed in the last year [2]. Collecting information concerning illicit drug uses plays a vital role to help low enforcement agencies in prevention and fight against criminal organizations. At present, chemical analysis are widely used to complement the epidemiology studies of population traditionally carried out in surveys. Particularly, the chemical analysis of wastewater is a powerful tool to monitor the pattern and trends of illicit drugs consumption in a community [3,4]. However, as in the cases of amphetamine and its derivatives most analytical techniques used to analyze wastewater samples and detect the illicit compounds are based on ex-situ studies like colorimetric measurements, capillary electrophoresis, HPLC or GC-MS among others. Recently, researchers from our group have presented an all-solid-state amphetamine-selective electrodes based on the crown ether dibenzo-18-crown-6 as amphetamine ionophore [5] and K. Graniczkowska et al. presented a capacitive sensor able to detect trace amounts of a precursor of the amphetamine synthesis [6]. The aim of this work is to present a highly selective microsensor easy to handle for in situ amphetamine detection by fasts potentiometric measurements at real time in both soft (street samples) and harsh environment (wastewater). To accomplish this, a novel amphetamine ion-par complex has been prepared as the active component of a polymeric sensitive membrane for amphetamine recognition. Metallocarboranes sandwich anions of the type [3,3′-Co(1,2-C₂B₉H₁₁)₂]⁻ have been reported for analysis applications due to their very good chemical properties (stability, hydrophobicity and extreme organophility) when isolated with organic bases of the type [cation-NH]ⁿ⁺ n[3,3′-Co(1,2-C₂B₉H₁₁)₂]⁻ [7]. This strategy allows incorporating the target molecule to the sensitive membrane enhancing the sensor’s performance and the selectivity. The ion-par complex [C₉H₁₃NH]⁺[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻ has been synthetized and the product obtained has been characterized by FTIR.

2. Materials and Methods

2.1. Preparation of [C₉H₁₃NH]⁺[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻

The ion-par complex [C₉H₁₃NH]⁺[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻ has been obtained by ion-exchange procedure. An acidic solution of Cs[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂] was extracted with diethyl ether to obtain the metallocarborane in the form H[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]. Then, the diethyl ether was evaporated under vacum and the residue was diluted with water to generate 0.05 M solution of H[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂] (solution 1). Amphetamine was dissolved in water and with the minimum quantity of HCl to prepare 0.05 M acidic solution (solution 2). Next, 20 mL of solution 1 and 20 mL of solution 2 were mixed and after stirring a yellow precipitate was obtained. This was filtered off, washed with HCl 0.1 M and dried in vacuum.

2.2. Sensitive Membrane

The polymeric membrane selective to amphetamine was made of 31 wt %. PVC as the polymeric matrix, 65 wt %. dibutyl phthalate as plasticizer and 4 wt % of [C₉H₁₃NH]⁺[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻ ion-par complex. All components were dissolved in THF. The solution mixture was drop-casted onto the gold microelectrode already modified with the polypyrrole conductive layer and let the solvent evaporate overnight.

3. Results and Discussion

3.1. The Ion Par Complex [C₉H₁₃NH]⁺[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻

The electroactive ion-par complex obtained was characterized by FT-IR spectroscopy. The IR spectrum shows evidence of hydrogen or dihydrogen bonding at the B-H and Cc-H or ArC-H stretching regions. The IR spectrum can be presented under request.

3.2. Sensor’s Respons Characteristic: Potentiometric Measurements

The performance of the amphetamine-selective microsensor was determined following the generalized standard addition method [8] by titration of amphetamine sulfate solutions from 10⁻⁷ to 10⁻³ M. Potentiometric measurements provided information regarding the Nernstian behavior, the limit of detection and the response time. Results are summarized in

Table 1. Characteristic response of the amphetamine selective microsensor.

Parameter	Amphetamine Selective Microsensor
Slope (mV/decade)	60.1
Limit of detection (M)	1.2 × 10−5
Time of response (s)	<10

.

As it can be observed in Figure 1, the device developed integrates an array of four gold working microelectrodes, two Ag/AgCl pseudo-reference microelectrodes and one gold auxiliary microelectrode. So, four sensors can measure at the same time using a single miniaturized device. It is very useful not only for multi-detection applications but also to obtain fast statistical values. As reported in Table 1 the amphetamine-selective microsensor presents a Nernstian slope of 60.1 mV/decade of amphetamine concentration. This is near to the theoretical value of 59 mV/decade expected for a monovalent cation such as amphetamine in the protonated form. The limit of detection was extracted as the crossing point of the two linear segments from the calibration curve shown in Figure 1. The microsensor presents a limit of detection of 12 µM. The time needed by the sensor to achieve a stable response was found to be less than 10 s.

3.3. Selectivity

Coefficients of selectivity, K_IJ^Pot, were obtained following the fixed interference method [9]. A titration of amphetamine sulfate standard solutions was carried out from 10⁻⁷ to 10⁻³ M in 25 mL of 1 mM solution of N-formyl amphetamine, methylbenzylamine or phenylalanine respectively. Results are summarized in

Table 2. Selectivity coefficient of the amphetamine-selective microsensor.

Interference	KIJPot
N-formyl amphetamine	−2.15
Methylbenzylamine	−2.09
Phenylalanine	−2.09

.

The results obtained confirm the high selectivity of the amphetamine-selective microsensor. The K_IJ^Pot values show that the response toward amphetamine in the presence of these amino/amide compounds structurally similar is around hundred times more sensitive. It is well known that plasticizers play an important role concerning the lifetime, sensitivity and selectivity of ion selective electrodes. However, introducing the target molecule into the polymeric membrane through the ion-par complex [C₉H₁₃NH]⁺[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻ synthetized is crucial to achieve those values of selectivity.

4. Conclusions

The development of an all-solid-state and highly selective amphetamine micro sensors has been reported. The ion par complex [C₉H₁₃NH]⁺[3,3′-Co(1,2-closo-C₂B₉H₁₁)₂]⁻ has been synthetized as the active part of a PVC-type polymeric membrane for amphetamine recognition. The microsensor showed Nernstian response with a slope of 60.1 mV/decade within the concentration range 10⁻⁵ M to 10⁻³ M of amphetamine, limit of detection of 12 µM and a time of response less than 10 s. The cross-selectivity study in the presence of N-formyl amphetamine, methylbenzylamine and phenylalanine shows that the sensor’s response toward amphetamine is highly selective. In addition, the miniaturized device developed is able to produce reliable and real-time data using four independent amphetamine-selective microsensors at the same time.