Next Article in Journal
Novel Delay-Dependent Stabilization for Fuzzy Stochastic Systems with Multiplicative Noise Subject to Passivity Constraint
Previous Article in Journal
Anammox-Based Processes for Mature Leachate Treatment in SBR: A Modelling Study
 
 
Article
Peer-Review Record

Using Artificial Neural Network and Fuzzy Inference System Based Prediction to Improve Failure Mode and Effects Analysis: A Case Study of the Busbars Production

Processes 2021, 9(8), 1444; https://doi.org/10.3390/pr9081444
by Saeed Na’amnh 1,*, Muath Bani Salim 2, István Husti 1 and Miklós Daróczi 1
Reviewer 1: Anonymous
Reviewer 2:
Processes 2021, 9(8), 1444; https://doi.org/10.3390/pr9081444
Submission received: 26 July 2021 / Revised: 15 August 2021 / Accepted: 17 August 2021 / Published: 19 August 2021

Round 1

Reviewer 1 Report

Journal                  : Processes (ISSN 2227-9717)

Manuscript ID    : processes-1335586

 

  1. If we refer to a figure in a manuscript, we shouldn't jump too far, as in Figure 1. Please also check other sections.
  2. At the end of the introduction, it is customary to state the purpose or novelty clearly in the manuscript so that the reader understands quickly.
  3. Currently, FIS and ANN are more commonly referred to as ANFIS terminology, should also be used as a reference. Is there a different FIS+ANN from the existing ANFIS? If it is different, the terminology can be used.
  4. In determining the crisps of a fuzzy MF (input or output), it is necessary to mapping the data properties. Is the existing data linear or polynomial? This has not been revealed in the script, and suddenly appears the triangle membership function (input) and the gaussian membership function (output).
  5. It is shown in Figure 3, "Aluminum Busbar….." we are not sure that the busbar is made of aluminum. Usually, busbars are made of galvanized steel coated with copper or zinc.
  6. In the manuscript, the term (O, S, D) appears at least three times, but the terminology is not explained beforehand. In Table 4, how the system can obtain each parameter Occurrence, Severity, and Detection?

Comments for author File: Comments.pdf

Author Response

Please see the attachment

Author Response File: Author Response.docx

Reviewer 2 Report

Correct the insertion of spaces, the deletion of spaces, the insertion of periods, or the insertion of "=".

The parts to be corrected are shown below.

 

L.58

Insert “space” between “weaknesses” and “[12]”.

 

L.63

Insert “space” between “concern” and “[13]”.

 

L.92

Insert “space” between “Chu” and “[16]”.

 

L.193

Insert “. ; period” between “Fig” and “2”.

 

L.258

Delete “space” between “[29]” and “ ,”.

 

L.286

Insert “space” among “O,” “S,” and “D”.

 

L.272

Insert “equal” into the equation (2).

 

L.338

Insert “space” between “&” and “3”.

 

Comments for author File: Comments.pdf

Author Response

Please see the attachment

Author Response File: Author Response.docx

Round 2

Reviewer 1 Report

We understand the reasons expressed and rational.

Back to TopTop