Text Correction
In the original publication [1], the data for the Atomic Force Microscopy (AFM) analysis were missing. A correction has been made to Section 2.2. Characterization of TiO2.
“A tapping-mode AFM probe with a cantilever tip, HQ: NSC-16 (Mikromasch), was used.”
Error in Figure
In the original publication [1], there was a mistake in Figure 9 as published. Figure 9A–F were erroneously included from the same raw data source. The corrected Figure 9A–F appear below.
Figure 9.
Morphology of (A) cells in control group at day 1, (B) TiO2 nanoparticle-treated cells at day 1, (C) cells in control group at day 7, (D) TiO2 nanoparticle-treated cells at day 7, (E) cells in control group at day 30, and (F) TiO2 nanoparticle-treated cells at day 30.
The authors state that the scientific conclusions are not affected because of this correction. This correction was approved by the Academic Editor. The original publication has also been updated.
Reference
- Mansoor, A.; Khan, M.T.; Mehmood, M.; Khurshid, Z.; Ali, M.I.; Jamal, A. Synthesis and Characterization of Titanium Oxide Nanoparticles with a Novel Biogenic Process for Dental Application. Nanomaterials 2022, 12, 1078. [Google Scholar] [CrossRef] [PubMed]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2024 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).