Triaxial Test Study on Energy Evolution of Marble after Thermal Cycle

With the increasing requirements for the exploitation of underground resources, the subject of the physical and mechanical properties of rocks under high temperature and pressure needs to be studied urgently. In order to analyze the mechanical and energy characteristics of rocks under different thermal damages and confining pressures (c), a triaxial compression test is performed on 35 marble samples. The effects of thermal damage and high pressure are simulated with different thermal cycles and confining pressures. The results show that as the number of thermal cycles increases, the peak strain of marble gradually rises, but the peak stress and the elastic modulus (E) decrease by a degree, reaching 11.19‰, 39.53 MPa, 4.79 GPa, while there is no confining pressure applied at eight thermal cycles. At this point, the failure mode gradually changes from brittle fracture to plastic failure. When confining pressure rises, peak stress, peak strain, and elastic modulus all show an upward trend, reaching a maximum of 189.45 MPa, 13.39‰, 35.41 GPa, while the sample is undamaged at 30 MPa confining pressure. Moreover, peak stress increases linearly with confining pressure increase. The increased rate of the peak value of the total absorbed energy, elastic strain energy, and dissipated energy all show a convex trend. The dissipated energy gradually increases with the axial strain (ε₁) during the rock loading process. The elastic strain energy has an energy storage limit, but the rock fails when the value exceeds the limit. The limit increases first and then decreases with the number of thermal cycles. These results can provide important engineering references for mining underground resources.