Next Article in Journal
Hyperbolic Secant Subsidence Prediction Model under Thick Loose Layer Mining Area
Next Article in Special Issue
Decomposition and Properties of the Traveltime Sensitivity Kernels in Transversely Isotropic Elastic Media
Previous Article in Journal
Carbothermic Reduction Roasting of Cathode Active Materials Using Activated Carbon and Graphite to Enhance the Sulfuric-Acid-Leaching Efficiency of Nickel and Cobalt
Previous Article in Special Issue
Elastic Impedance Simultaneous Inversion for Multiple Partial Angle Stack Seismic Data with Joint Sparse Constraint
 
 
Article
Peer-Review Record

Quantitative Evaluation of Faults by Combined Channel Wave Seismic Transmission-Reflection Detection Method

Minerals 2022, 12(8), 1022; https://doi.org/10.3390/min12081022
by Yanhui Wu 1, Guowei Zhu 1, Wei Wang 2,*, Mengbo Zhang 3 and Zhen Gao 4
Reviewer 1: Anonymous
Reviewer 2:
Minerals 2022, 12(8), 1022; https://doi.org/10.3390/min12081022
Submission received: 28 June 2022 / Revised: 11 August 2022 / Accepted: 12 August 2022 / Published: 14 August 2022
(This article belongs to the Special Issue Theory and Applications of Seismic Inversion)

Round 1

Reviewer 1 Report

Please read my comments in the attached pdf

 

Best regards

Comments for author File: Comments.pdf

Author Response

please see the attachment

Author Response File: Author Response.docx

Reviewer 2 Report

In this paper, through the Logistic regression and Neural network model to feature extraction and determination fault location extension, Calculation the fractional dimension D to the quantitative analysis of the fault throw. This paper has a clear theme, but still some problems need to correct before its publication.

1.      L35, “Therefore, Fault detection before mining is necessary,” Capitalization.

2.      L58, “Duo to the complexity of the reflected wavefield results in attenuation and absorption seriously and weak reflected signal.” you should change the order of sentences.

3.      L65,“the fall of the fault is fitted step by step by calculating the dispersion curve fractional dimension(D) and the fault rendezvous method. ” fall or throw.

4.      L75, “The second step was to locate the fault reflection by the ellipse tangent method, the channel wave properties are extracted by logistic regression and neural network methods to discriminate and effectively extend the fault range.” Capitalization and remain consistent with the content of later chapters.

5.      L115, “represent the ray path through the fault plane and not through the fault plane.” Missing pronouns.

6.      L223, “Based on the reflection fault location obtained by the elliptical tangent method, first defined the variables.”  You should be change the order of  the sentences.

7.      L274, “We introduce D is to calculate to determine the fault throw, high D corresponding to a complex velocity range for the dispersion map.” Lack of subordinating conjunctions and redundant words.

8.      L306, “while the ellipse tangent method predicts that the partial fault throw is about 4 m.” about or approximately?

Author Response

please see the attachment

Author Response File: Author Response.docx

This manuscript is a resubmission of an earlier submission. The following is a list of the peer review reports and author responses from that submission.


Back to TopTop