Overburden Failure Associated with Slicing Mining in a Super Thick Coal Seam under Special Weak Aquifers

With the increasing improvement of national ecological standards, the eco-environmental problems caused by super thick coal seam mining in western China are becoming more and more serious. The failure law of weak overburden stratum is an important factor affecting the safe mining of coal. The failure characteristics of weakly cemented overburden under high-intensity mining in the mining area of western China were studied. For this purpose, a case study was conducted in the 1101 working face of the Baituyao Coal Mine in Ürümqi County. Based on the analysis of geological conditions in the study area, we combined empirical calculations with engineering analogy, physical simulation, and numerical simulation to comprehensively analyze the characteristics of mining-induced overburden failure. The study showed that the overburden in the study area had several unfavorable engineering geological characteristics, including ease of softening in the presence of water. The Middle Jurassic Xishanyao Formation is a directly recharged aquifer with a weak water-retaining property. Overburden failure mainly occurred at the two ends of the open-off cut. During the mining process, vertical fissures and bed-separated fissures were periodically developed and closed, and the fissures were interconnected. The overburden was fractured, and the fractured zone showed a trapezoidal shape, tapering off from bottom to top. The heights of the caving zone and the water-conducting fracture zone were 25 and 280 m, respectively, in the 1101 working face of the Baituyao Coal Mine, and the ratio of fracturing to mining height was 14.0. Due to the weakly cemented overburden and the presence of the Neogene weak aquifer, the risk of water and sand bursts still exists in this working face under high-intensity mining. Our findings shed light on the safe mining and environmental protection of the ground surface in coal mine shafts in western China.