Elasticity of Phases in Fe-Al-Ti Superalloys: Impact of Atomic Order and Anti-Phase Boundaries
AbstractWe combine theoretical and experimental tools to study elastic properties of Fe-Al-Ti superalloys. Focusing on samples with chemical composition Fe71Al22Ti7, we use transmission electron microscopy (TEM) to detect their two-phase superalloy nano-structure (consisting of cuboids embedded into a matrix). The chemical composition of both phases, Fe66.2Al23.3Ti10.5 for cuboids and Fe81Al19 (with about 1% or less of Ti) for the matrix, was determined from an Energy-Dispersive X-ray Spectroscopy (EDS) analysis. The phase of cuboids is found to be a rather strongly off-stoichiometric (Fe-rich and Ti-poor) variant of Heusler Fe2TiAl intermetallic compound with the L21 structure. The phase of the matrix is a solid solution of Al atoms in a ferromagnetic body-centered cubic (bcc) Fe. Quantum-mechanical calculations were employed to obtain an insight into elastic properties of the two phases. Three distributions of chemical species were simulated for the phase of cuboids (A2, B2 and L21) in order to determine a sublattice preference of the excess Fe atoms. The lowest formation energy was obtained when the excess Fe atoms form a solid solution with the Ti atoms at the Ti-sublattice within the Heusler L21 phase (L21 variant). Similarly, three configurations of Al atoms in the phase of the matrix with different level of order (A2, B2 and D03) were simulated. The computed formation energy is the lowest when all the 1st and 2nd nearest-neighbor Al-Al pairs are eliminated (the D03 variant). Next, the elastic tensors of all phases were calculated. The maximum Young’s modulus is found to increase with increasing chemical order. Further we simulated an anti-phase boundary (APB) in the L21 phase of cuboids and observed an elastic softening (as another effect of the APB, we also predict a significant increase of the total magnetic moment by 140% when compared with the APB-free material). Finally, to validate these predicted trends, a nano-scale dynamical mechanical analysis (nanoDMA) was used to probe elasticity of phases. Consistent with the prediction, the cuboids were found stiffer. View Full-Text
Share & Cite This Article
Friák, M.; Buršíková, V.; Pizúrová, N.; Pavlů, J.; Jirásková, Y.; Homola, V.; Miháliková, I.; Slávik, A.; Holec, D.; Všianská, M.; Koutná, N.; Fikar, J.; Janičkovič, D.; Šob, M.; Neugebauer, J. Elasticity of Phases in Fe-Al-Ti Superalloys: Impact of Atomic Order and Anti-Phase Boundaries. Crystals 2019, 9, 299.
Friák M, Buršíková V, Pizúrová N, Pavlů J, Jirásková Y, Homola V, Miháliková I, Slávik A, Holec D, Všianská M, Koutná N, Fikar J, Janičkovič D, Šob M, Neugebauer J. Elasticity of Phases in Fe-Al-Ti Superalloys: Impact of Atomic Order and Anti-Phase Boundaries. Crystals. 2019; 9(6):299.Chicago/Turabian Style
Friák, Martin; Buršíková, Vilma; Pizúrová, Naděžda; Pavlů, Jana; Jirásková, Yvonna; Homola, Vojtěch; Miháliková, Ivana; Slávik, Anton; Holec, David; Všianská, Monika; Koutná, Nikola; Fikar, Jan; Janičkovič, Dušan; Šob, Mojmír; Neugebauer, Jörg. 2019. "Elasticity of Phases in Fe-Al-Ti Superalloys: Impact of Atomic Order and Anti-Phase Boundaries." Crystals 9, no. 6: 299.
Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.